Sediment constituents and quartz in the sand-sized fraction, West Florida slope and Mississippi Fan sediments

The interval between 488.2 and 513.7 m below seafloor at Deep Sea Drilling Project (DSDP) Site 615 is interpreted as a single carbonate gravity-flow deposit. The deposit has characteristics of both a debris flow and a high-density turbidity current. Comparison of the sedimentary constituents in 15 samples from this site with samples from 26 core tops from the upper West Florida continental slope and eastern Mississippi Fan shows many similarities. Shallow-water indicators, such as mollusk and echinoid fragments, occur in both suites of samples. The West Florida continental margin, therefore, is a potential provenance area. The Yucatan slope is also a possible source, but data from it are limited. The recognition of carbonate gravity-flow deposits intercalated within the Mississippi Fan refines our understanding of Pleistocene sedimentation within the Gulf basin. Deposition in the deep Gulf is dominated by the construction of the Mississippi Fan. However, this marine terrigenous depocenter is located between two large carbonate depocenters, the West Florida continental margin on the east and the Yucatan peninsula on the southwest. Periodically, the carbonate slope in these two regions fails, injecting carbonate gravity flows into the accreting terrigenous deep-sea fan.

Fig. 2. Lithology, water and total carbon content, cumulative grain-size distribution, and quartz, feldspar, and mica contents of core sequence Lz1013 from south-western Beaver Lake

A 100 cm long sediment sequence was recovered from Beaver Lake in Amery Oasis, East Antarctica, using gravity and piston corers. Sedimentological and mineralogical analyses and the absence of micro and macrofossils indicate that the sediments at the base of the sequence formed under glacial conditions, probably prior to c. 12 500 cal. yr BP. The sediments between c. 81 and 31 cm depth probably formed under subaerial conditions, indicating that isostatic uplift since deglaciation has been substantially less than eustatic sea-level rise and that large areas of the present-day floor of Beaver Lake must have been subaerially exposed following deglaciation. The upper 31 cm of the sediment sequence were deposited under glaciomarine conditions similar to those of today, supporting geomorphic observations that the Holocene was a period of relative sea-level highstand in Amery Oasis.

Distribution of opal and quartz in surface sediments from the subtropical southeastern Pacific (Table 1)

The distribution patterns of opal and quartz on the ocean floor of the subtropical southeastern Pacific have been defined by analyzing 59 surface-sediment samples. The opal distribution resembles that of primary productivity in the surface waters, except along the Peruvian and northern Chilean coasts, where dilution reduces opal values. The distribution pattern of quartz represents both eolian and fluvial transport. Quartz distribution extends out as a tongue in the same direction and position as the prevailing southeast trade winds. Along the South American coast, high quartz concentrations are found in patches near shore and decrease rapidly seaward.

Behavior of trace elements in quartz from plutons of different geochemical signature: a case study from the Bohemian Massif, Czech Republic

Trace-element content in igneous quartz from granitoids of different geochemical types from Bohemian Massif (Central Evrope) was investigated using the laser ablation ICP-MS technique. Two laboratories (Geological Survey of Norway, Trondheim, and Institute of Geology of the Academy of Science of Czech Republic, Praha) were involved in the trace-element (Li, Be, B, Mn, Ge, Rb, Ba, Pb, Mg, Al, P, Ca, Ti, Fe, and Sn) analyses of quartz (altogether, ~300 analyses of 17 rock samples). About 200 representative analyses of quartz are given in Tables 1 and 2.

Settlement characteristics of quartz grains on certain sediment surface forms of tidal beaches along the Baltic and Wadden Sea

Sind in einem Sediment, das unter dem Einfluß einer Strömung abgelagert wurde, richtungsanzeigende Indikatoren vorhanden, so werden sie je nach den momentanen Bedingungen, die zur Zeit der Sedimentation herrschten, ein mehr oder weniger gutes Abbild der Strömungsverhältnisse liefern. Zahlreich sind Strömungsanzeiger organischen Ursprungs, wie z. B. Molluskenschalen u. a. Doch auch anorganische Partikel in Psephiten und Psammiten lassen häufig in ihrer Lagerung eine Abhängigkeit von der Strömungsrichtung erkennen: sie sind "geregelt". Die Autoren der verschiedenen Arbeiten, in denen Regelungen in klastischen Sedimenten untersucht wurden, gingen von der Tatsache aus, daß viele Sedimentpartikel statistisch gesehen keine Kugelform, sondern eine längliche Gestalt besitzen. Die langen Achsen dieser länglich geformten Sedimentkörner werden im folgenden als "Langachsen" bezeichnet. In Sanden sind es vor allem Quarzkörner von annähernd zylindrischer oder ellipsoidischer Form ("Langquarze"), die geeignet sind, durch die Lage ihrer Langachsen strömungsbedingte Regelungen anzuzeigen. Mit der Orientierung solcher Langquarze in marinen und fluviatilen Sanden haben sich bisher vorwiegend amerikanische Autoren befaßt. So untersuchten z. B. Dapples & Rominger (1945) die Sandsohle eines künstlichen Gerinnes. Sie stellten fest, daß die Hauptorientierungsrichtung der Langquarze mit der Strömungsrichtung des fließenden Wassers zusammenfiel. Dabei zeigte das spitze Ende tropfenförmiger ("polarer") Quarze stromab und das stumpfe Ende stromauf. Nanz (1955) maß die Langachsenrichtungen von Langquarzen in Sanden des nassen und trockenen Strandes von Texas und Florida und fand, daß sich diese Achsen vorwiegend parallel zur Auf- und Ablaufrichtung der Wellen und damit senkrecht zum Streichen der Strandlinie einregeln. Curray (1956 b) beobachtete die gleiche Regelung. Er wies ferner darauf hin, daß in Strandwällen und Strandhaken die bevorzugte Richtung der Langquarze senkrecht zum Streichen des Sedimentkörpers liegt. Zahlreiche weitere Autoren beschäftigten sich ebenfalls mit den Fragen der Langquarzregelung, so Schwarzacher (1951), Griffith & Rosenfeld (1953), Vollbrecht (1953), Rusnak (1956), Wendler (1956), Sriramadas (1957). Ganz allgemein war das Ergebnis aller dieser Untersuchungen, daß die aus einer Strömung abgelagerten Langquarze eine Regelung parallel zur Strömungsrichtung zeigen. Eigene Untersuchungen und Überlegungen ergaben, daß die bisher veröffentlichten Ergebnisse und die an sie angeschlossenen Vorstellungen z. T. bestätigt werden können, jedoch z. T. auch erheblich modifiziert werden müssen.

Tab. 1: Proportion of glacial quartz grains contained in the deposits

The Yari-Hotaka Mountain Range is one of the most famous formerly-glaciated areas of Japan. Many glacial landforms remain in three neighbouring U-shaped valleys, named Yarisawa, Yokoo and Migimata. Moraines and outwash terraces can be classified into four groups according to their location and to the amount of glacial quartz grains contained in the deposits. A glaciation is proved for other parts of the Northern Japanese Alps before 100 000 years B.P., but not for the Yari-Hotaka Mountain Range, because the corresponding glacial landforms cannot be found here. The oldest known Ichinomata stage before and after 60 000 years B.P. corresponds to the Yokoo glacial which is proved wirhin the whole Japanese Alps. The three younger stages, Babadaira stage (before 30 000 years B.P.), Yarisawa stage I (about 30000 years B.P.) and Yarisawa stage II (about 15000 years B.P.), belong to the Karasawa glacial. About 10 000 years B.P. the glaciers melted away. At all times the relief-influence was especially important for Ihe mass-balances of Japanese glaciers. Wind-drifted snow from the west-exposed windward slopes to the slopes in eastern (lee) exposition, and a voluminous snow accumulation by avalanches from the high rocky walls onto the glacier surfaces beneath, caused very low situated glaciers as well as low equilibrium-lines. In most cases the snow-lines were situated 100 m or more above the equilibrium-lines. During the Ichinomata stage the snow-line reached an altitude of 2400-2450 m. It rose about 100 m to the Babadaira stage, 300 m to Yarisawa stage I and about 450 m to Yarisawa stage II. At present the snow-line is situated above the Northern Japanese Alps at over 4000 m. Therefore only perennial snow-patches exist. If the snow-line would go down by a few hundred meters, this region would be highly interesting Ifor studies on the beginning of mountain glaciation.

Quartz grain microtextures of sediments from ODP Hole 188-1166A (Table 1)

This paper presents the results of the scanning electron microscopic (SEM) analysis of quartz grains from a selection of samples at Site 1166. Ocean Drilling Program Leg 188 drilled Site 1166 on the Prydz Bay continental shelf, Antarctica, to document onset and fluctuations of East-Antarctic glaciation. This site recovered Upper Pliocene-Holocene glacial sediments directly above Cretaceous through Lower Oligocene sediments recording the transition from preglacial to early glacial conditions. SEM analysis of quartz grains at Site 1166 was used to characterize the glacial and preglacial sediments by their diagnostic textures. Angular edges, edge abrasion as well as arcuate to straight steps, are the most frequent features in glacial deposits. The highest frequency of grains with round edges is present in Middle-Late Eocene fluvio-deltaic sands. However, angular outlines, fractured plates with subparallel linear fractures and edge abrasion indicating glacier influence are also present. Preglacial carbonaceous mudstone and laminated gray claystone show distinctive high relief quartz grains and some chemical weathering on grain surfaces. The results of the microtextural analysis of quartz grains are used to verify some critical periods of ice sheet evolution, such as the transition from the East Antarctic preglacial to glacial conditions on the continental shelf from Middle/Late Eocene to Late Eocene/Early Oligocene time.

Occurrence of microtextures recorded from quartz sand grains of ODP Hole 178-1101A (Table 1)

Sediment drifts on the continental rise are located proximal to the western side of the Antarctic Peninsula and recorded changes in glacial volume and thermal regime over the last ca. 15 m.y. At Ocean Drilling Program (ODP) Site 1101 (Leg 178), which recovered sediments back to 3.1 Ma, glacial-interglacial cyclicity was identified based on the biogenic component and sedimentary structures observed in X-radiographs, magnetic susceptibility and lithofacies descriptions. Glacial intervals are dominated by fine-grained laminated mud and interglacial units consist of bioturbated muds enriched in biogenic components. From 2.2 to 0.76 Ma, planktonic foraminifera and calcareous nannofossils dominate in the interglacials suggesting a shift of the Antarctic Polar Front (APF) to the south near the drifts. Prior to 2.2 Ma, cyclicity cannot be identified and diatoms dominate the biogenic component and high percent opal suggests warmer conditions south of the APF and reduced sea ice over the drifts. Analyses of the coarse-grained terrigenous fraction (pebbles and coarse sand) from Sites 1096 and 1101 record glaciers at sea-level releasing iceberg-rafted debris (IRD) throughout the last 3.1 m.y. Analyses of quartz sand grains in IRD with the scanning electron microscope (SEM) show an abrupt change in the frequency of occurrence of microtextures at ~1.35 Ma. During the Late Pliocene to Early Pleistocene, the population of quartz grains included completely weathered grains and a low frequency of crushing and abrasion, suggesting that glaciers were small and did not inundate the topography. Debris shed from mountain peaks was transported supraglacially or englacially allowing weathered grains to pass through the glacier unmodified. During glacial periods from 1.35-0.76 Ma, glaciers expanded in size. The IRD flux was very high and dropstones have diverse lithologies. Conditions resembling those at the Last Glacial Maximum (LGM) have been episodically present on the Antarctic Peninsula since ~0.76 Ma. Quartz sand grains show high relief, fracture and abrasion common under thick ice and the IRD flux is low with a more restricted range of dropstone lithologies.