Geochemistry of vein rocks of ODP Hole 118-735B

Rock samples from Hole 735B, Southwest Indian Ridge, were examined to determine the principal vein-related types of alteration that occurred, the nature of fluids that were present, and the temperatures and pressures of these fluids. Samples studied included veined metagabbro, veined mylonitic metagabbro, felsic trondhjemite, and late-stage leucocratic diopside-bearing veins. The methods used were standard petrographic analysis, mineral chemical analysis by electron microprobe, fluid inclusion petrography and analysis by heating/freezing techniques and laser Raman microspectroscopy, and oxygen isotopic analyses of mineral separates. Alteration in lithologic Units I and II (above the level of Core 118-735B-3OR; approximately 140 meters below the seafloor) is dominated by hydration by seawater-derived fluids at high temperature, up to about 700°C, and low water/rock ratio, during and immediately after pervasive ductile deformation. Below Core 118-735B-30R, pervasive deformation is less common, and brittle veining and brecciation are the major alteration styles. Leucocratic centimeter-scale veins, often containing diopside and plagioclase, were produced by interaction of hot (about 500°C) seawater-derived fluid and gabbro. The water/rock ratio was locally high at the veins and breccia zones, but the integrated water/rock ratio for the lower part of the hole is probably low. Accessory hydrous magmatic or deuteric phases formed from magmatic volatiles in some gabbro and in trondhjemite. Most subsequent alteration was affected by fluids that were seawater-derived, based on isotopic and chemical analyses of minerals and analyses of fluid inclusions. Many early-generation fluid inclusions, associated with high-temperature veining, contain appreciable methane as well as saline water. The source of methane is unclear, but it may have formed as seawater was reduced during low water/rock interaction with ultramafic upper mantle or ultramafic and mafic layer 3. Temperatures of alteration were calculated on the basis of coexisting mineral chemistry and isotopic values. Hydrothermal metamorphism commenced at about 720°C and continued to about 550°C. Leucocratic veining took place at about 500°C. Alteration within brecciated horizons was also at about 500° to less than 400°C, and the trondhjemite was altered at about 550° to below 490°C. Pressures calculated from a diopside-bearing vein, based on a combination of fluid inclusion and isotopic analysis, were 90 to 100 MPa. This pressure places the sample, from Core 118-735B-70R in Unit V, at about 2 km below the seafloor.

Geochemical composition of olivine, spinel and amphibole in ODP Hole 209-1271B

Dunite and gabbroic materials recovered from Hole 1271B, Ocean Drilling Program (ODP) Leg 209, were examined for mineral chemistry to understand melt flow and melt-mantle reactions in the shallowest upper mantle of the Mid-Atlantic Ridge near the 15°20' Fracture Zone. Hole 1271B was drilled to 103.8 meters below seafloor on the inner corner high along the south wall of the 15°20' Fracture Zone. The total length of core collected was 15.9 m (recovery = ~15%). The dominant rock type in Hole 1271B is dunite, followed by brown amphibole gabbro, olivine gabbro, and troctolite, along with minor amounts of harzburgite and olivine gabbronorite. A large proportion of the dunite is associated with gabbroic rocks in Hole 1271B, similar to those observed in the Mohorovicic (Moho) transition zone of the Oman ophiolite, indicating significant magmatic activity in this region near the 15°20' Fracture Zone. Olivine Fo content varies from 89.2 to 91.2 in impregnated dunite and from 85.6 to 88.6 in troctolite, olivine gabbro, and olivine gabbronorite. Spinel Cr# (= 100 x Cr/[Cr + Al] molar ratio) ranges from 38.9 to 62.7 in dunite and from 46.3 to 57.6 in troctolites, olivine gabbro, and olivine gabbronorite. Compositional trends for spinel from dunite through troctolite toward olivine gabbro/gabbronorite are characterized by increases in TiO2, Cr#, and Fe3+#, very similar to those reported from Hess Deep Site 895. Olivine gabbro, olivine gabbronorite, and troctolite in Hole 1271B are considered to have formed as hybrid rocks between dunite and an evolved melt in the walls of a melt channel in the shallowest upper mantle that is tens of meters wide. The melt trapped in the wall rock crystallized plagioclase and clinopyroxene. On the other hand, dunite in the center of the melt channel became more refractory by melt-mantle reactions, increasing spinel Cr# to 62.5.

Composition and structural formulas of ODP Site 200-1224 Eocene ferrobasalt minerals

The ~46-m.y.-old igneous basement cored during Leg 200 in the North Pacific represents one of the few cross sections of Pacific oceanic crust with a total penetration into basalt of >100 m. The rocks, emplaced during the Eocene at a fast-spreading rate (~14 cm/yr; full rate) are strongly differentiated tholeiitic basalts (ferrobasalts) with 7-4.5 wt% MgO, relatively high TiO2 (2-3.5 wt%), and total iron as Fe2O3 (9.1-16.8 wt%). The differentiated character of these lavas is related to unusually large amounts of crystallization differentiation of plagioclase, clinopyroxene, and olivine. The lithostratigraphy of the basement (cored to ~170 meters below seafloor) is divided into three units. The deepest unit (lithologic Unit 3), is a succession of lava flows of no more that a few meters thickness each. The intermediate unit (lithologic Unit 2) is represented by intermixed thin flows and pillows, whereas the shallowest unit (lithologic Unit 1), comprises two massive flows. The rocks range from aphyric to sparsely clinopyroxene-plagioclase-phyric (phenocryst content = <3 vol%) and from holocrystalline to hypohyaline. Chilled margins of pillow fragments show holohyaline to sparsely vitrophyric textures. Site 1224 oxide minerals present a type of alteration not previously seen, where titanomagnetite is only partially destroyed and the pure magnetite component is partially removed from the mineral, leaving, in the most extreme case, a nearly pure ulvöspinel residuum. As a result of this dissolution, iron, mainly in the oxidized state, is added to the circulating solvent fluids. This means that a considerable metal source can result from low-temperature reactions throughout the upper ocean crust. The coarsest-grained lithologic Unit 1 rocks have interstitial myrmekitic intergrowths of quartz and sodic plagioclase (~An12), roughly similar in mineralogy and bulk composition to tonalite/trondhjemite veinlets in abyssal gabbros from the southwest Indian Ocean and Hess Deep, eastern equatorial Pacific. Based on idiomorphic relationships and projections into the simplified Q-Ab-Or-H2O granite ternary system, the myrmekitic intergrowths formed at the same time as, or just after, the oxide minerals coprecipitated and at low water vapor pressure (~0.5 kbar). Their compositions correspond to SiO2-oligoclase intergrowths that are considerably less potassic than dacitic glasses that erupt, although rarely, along the East Pacific Rise or that have been produced experimentally by partial melting of gabbro. Based on the crystallization history and comparison to experimental data, the original interstitial siliceous liquids resulted from late-stage immiscible separation of siliceous and iron-rich liquids. The rare andesitic lavas found along the East Pacific Rise may be hybrid rocks formed by mixing of these immiscible siliceous melts with basaltic magma.