Geochemistry of basalts from ODP Hole 109-648B

Legs 106-109 achieved the first basaltic bare-rock drill hole, on a small volcano (Serocki volcano) located on the flanks of the rift valley in the MAR about 70 km south of the Kane fracture zone. Because of severe technical difficulties only 50.5 m of basalt below seafloor was recovered. Geochemical analysis shows that the recovered basalts display typical N-MORB characteristics as expected in this segment of the Mid-Atlantic ridge. The lava flows display rather equivalent geochemical characteristics all over the drilled section and show the imprint of a previous magmatic differentiation suffered by the magmas before their emission, indicative of a fractional crystallization of plagioclase-bearing cumulates. The incompatible and alkali element content of these 648B magmas is very low, a feature which resembles those of other N-MORB. The geochemical characteristics of these basalts look closely similar to those of basalts from the same flow line emitted respectively 10 m.y. (Hole 395, Legs 45-46), and 110 m.y. (Hole 417A, Legs 51-53) ago, supporting the persistence in this ridge segment of a mantle source with depleted characteristics over the last 110 m.y., but with some variations in the degree of depletion of the source along this period. Although these rocks appear fresh, the imprint of an incipient low temperature alteration can be noticed in a few samples, as evidenced by slight increases of alkali, U elements, and 87Sr/86Sr isotopic compositions.

(Table 1) B content, d11B, d18O, degree of alteration, and lithology of basalts from ODP Hole 504B

Boron contents and boron isotopic compositions were determined for the uppermost 1.3 km section of typical 6.2 Ma oceanic crust from DSDP/ODP Hole 504B, Costa Rica Rift, Galapagos Spreading Center. Both the boron content and the d11B value in the oceanic crust are controlled by two types of alteration: 1. (1) low-temperature alteration (0 to 60°C; Zones I and II) and 2. (2) high-temperature hydrothermal alteration (200 to 400°C; Zones III and IV). Basalts subjected to the low-temperature alteration are characterized by their relatively high boron contents (0.69 to 19.3 ppm) and high d11B values (+2.2 to +10.6?), indicating uptake of boron into secondary phases in equilibrium with seawater or evolved seawater. Hydrothermally altered basalts contain less abundant boron (0.17 to 0.52 ppm) and relatively constant d11B values (?0.1 to +1.0?). Although basalts from the upper part of these hydrothermal zones (<1300 mbsf) show equilibrated boron content and d11B value with aqueous fluid, effective leaching of boron from basalt is predominant in the lower part (>1300 mbsf). Original boron content and d11B value of the Hole 504B MORB were 0.35 ppm and +0.2?, respectively. The present data provide fundamental information in understanding of the distribution of boron and boron isotopes in the oceanic crust.

(Table 3) Li concentrations and isotopic compositions in foraminiferal shells, carbonate sediments, and associated pore waters from ODP Sites 131-806 and 138-851

An improved procedure for lithium isotope analysis using Li3PO4 as the ion source has been investigated for application to geological samples. The 7Li/6Li ratio is measured using double rhenium filament thermal ionization mass spectrometry in which isotopic fractionation is minimized at high temperatures. The method produces a stable, high intensity Li+ ion beam that allows measurement of nanogram quantities of lithium. This results in a reduction in sample size of up to 1000 times relative to that required for the established Li2BO2+ method while maintaining a comparable precision of better than 1? (1 sigma). Replicate analyses of the NBS L-SVEC Li2CO3 standard yielded a mean value of 12.1047+/-0.0043 (n=21), which is close to the reported absolute value of 12.02+/-0.03. Intercalibration with a wide range of geological samples shows excellent agreement between the Li3PO4 and Li2BO2+ techniques. Replicate analyses of seawater and a fresh submarine basalt display high precision results that agree with previous measurements. Taking advantage of the high ionization efficiency of the phosphate ion source, we have made the first measurements of the lithium concentration (by isotope dilution) and isotopic composition of calcareous foraminiferal tests and other marine carbonates. Preliminary results indicate that substantial lithium exchange occurs between carbonate sediments and their interstitial waters. In addition, a possible link between lithium paleoceanography and paleoclimate during the last 1000 ky may be derived from planktonic foraminiferal tests. This highly sensitive technique can be applied in the examination of low lithium reservoirs and thereby provide insight into some fundamental aspects of lithium geochemistry.