Lithology, stratigraphy, organic carbon content, extract and liquid chromatography yields, and Rock-Eval pyrolysis at DSDP Holes 75-530A and 75-532

Seventeen sediment samples of Albian-Cenomanian to early Pliocene age from DSDP Hole 530A in the Angola Basin and six sediment samples of early Pliocene to late Pleistocene age from the Walvis Ridge were investigated by organic geochemical methods, including organic carbon determination, Rock-Eval pyrolysis, gas chromatography and combined gas chromatography/mass spectrometry of extractable hydrocarbons, and kerogen microscopy. The organic matter in all samples is strongly influenced by a terrigenous component from the nearby continent. The amount of marine organic matter present usually increases with the total organic carbon content, which reaches an extreme value of more than 10% in a Cenomanian black shale from Hole 530A. At Site 530 the extent of preservation of organic matter in the deep sea sediments is related to mass transport down the continental slope, whereas the high organic carbon contents in the sediments from Site 532 reflect both high bioproductivity in the Benguela upwelling regime and considerable supply of terrigenous organic matter. The maturation level of the organic matter is low in all samples.

Electrical resistivity, formation factors, and sound velocity at DSDP Holes 75-530A and 75-530B

From 0 to 277 m at Site 530 are found Holocene to Miocene diatom ooze, nannofossil ooze, marl, clay, and debrisflow deposits; from 277 to 467 m are Miocene to Oligocene mud; from 467 to 1103 m are Eocene to late Albian Cenomanian interbedded mudstone, marlstone, chalk, clastic limestone, sandstone, and black shale in the lower portion; from 1103 to 1121 m are basalts. In the interval from 0 to 467 m, in Holocene to Oligocene pelagic oozes, marl, clay, debris flows, and mud, velocities are 1.5 to 1.8 km/s; below 200 m velocities increase irregularly with increasing depth. From 0 to 100 m, in Holocene to Pleistocene diatom and nannofossil oozes (excluding debris flows), velocities are approximately equivalent to that of the interstitial seawater, and thus acoustic reflections in the upper 100 m are primarily caused by variations in density and porosity. Below 100 or 200 m, acoustic reflections are caused by variations in both velocity and density. From 100 to 467 m, in Miocene-Oligocene nannofossil ooze, clay, marl, debris flows, and mud, acoustic anisotropy irregularly increases to 10%, with 2 to 5% being typical. From 467 to 1103 m in Paleocene to late Albian Cenomanian interbedded mudstone, marlstone, chalk, clastic limestone, and black shale in the lower portion of the hole, velocities range from 1.6 to 5.48 km/s, and acoustic anisotropies are as great as 47% (1.0 km/s) faster horizontally. Mudstone and uncemented sandstone have anisotropies which irregularly increase with increasing depth from 5 to 10% (0.2 km/s). Calcareous mudstones have the greatest anisotropies, typically 35% (0.6 km/s). Below 1103 m, basalt velocities ranged from 4.68 to 4.98 km/s. A typical value is about 4.8 km/s. In situ velocities are calculated from velocity data obtained in the laboratory. These are corrected for in situ temperature, hydrostatic pressure, and porosity rebound (expansion when the overburden pressure is released). These corrections do not include rigidity variations caused by overburden pressures. These corrections affect semiconsolidated sedimentary rocks the most (up to 0.25 km/s faster). These laboratory velocities appear to be greater than the velocities from the sonic log. Reflection coefficients derived from the laboratory data, in general, agree with the major features on the seismic profiles. These indicate more potential reflectors than indicated from the reflection coefficients derived using the Gearhart-Owen Sonic Log from 625 to 940 m, because the Sonic Log data average thin beds. Porosity-density data versus depth for mud, mudstone, and pelagic oozes agree with data for similar sediments as summarized in Hamilton (1976). At depths of about 400 m and about 850 m are zones of relatively higher porosity mudstones, which may suggest anomalously high pore pressure; however, they are more probably caused by variations in grain-size distribution and lithology. Electrical resistivity (horizontal) from 625 to 950 m ranged from about 1.0 to 4.0 ohm-m, in Maestrichtian to Santonian- Coniacian mudstone, marlstone, chalk, clastic limestone, and sandstone. An interstitial-water resistivity curve did not indicate any unexpected lithology or unusual fluid or gas in the pores of the rock. These logs were above the black shale beds. From 0 to 100 m at Sites 530 and 532, the vane shear strength on undisturbed samples of Holocene-Pleistocene diatom and nannofossil ooze uniformly increases from about 80 g/cm**2 to about 800 g/cm**2. From 100 to 300 m, vane shear strength of Pleistocene-Miocene nannofossil ooze, clay, and marl are irregular versus depth with a range of 500 to 2300 g/cm**2; and at Site 532 the vane shear strength appears to decrease irregularly and slightly with increasing depth (gassy zone). Vane shear strength values of gassy samples may not be valid, for the samples may be disturbed as gas evolves, and the sediments may not be gassy at in situ depths.

Organic carbon and humic substances contents, carbon isotope composition and peroxidase activity in sediments from DSDP Sites 15-147 and 75-532

Sediment samples from the Cariaco Trench (DSDP Leg 15) and the Walvis Ridge (DSDP Leg 75) ranging in age from Holocene to Upper Miocene (approximately 8 million years BP) and in depth from 5 to 258 m were extracted with basic sodium pyrophosphate and the extract analyzed for enzymic activity. Since no dehydrogenase, alkaline phosphatase or esterase activity was found, it is estimated from these data that the maximum bacterial population does not exceed 1000 cells per gram dry sediment. Peroxidase activity was, however, found in most samples: this showed marked dependence on the humic substance concentration (expressed as percent of the organic carbon content) and increased with depth at a rate of 33 units per meter. To explain this observation, we favor an hypothesis based on the presence of active humic-enzyme association. The humic substances absorb and stabilize peroxidase which is liberated throughout the sediment column by lysis of cells. The association of the enzyme with the humic substances protects it from biodegradation and denaturation. This hypothesis agrees with laboratory experiments which show the enhanced stability of humic-enzyme complexes towards degradation by biological, chemical and thermal effects.

Organic geochemical comparison of Cretaceous green and black claystones at DSDP Hole 75-530A

Three pairs of Upper Cretaceous black shales and adjacent green claystones from Hole 530A were analyzed to compare types and amounts of organic matter and lipids and to seek information about their environments of deposition. The organic-carbon-rich black shales have C/N ratios nearly seven times those of the organic-carbon-lean green claystones. The lipid content of organic matter in the black shales is about ten times less than in adjacent green layers. Organic matter in both types of rocks is thermally immature, and distributions of alkanoic acids, alkanols, sterols, and alkanes contain large amounts of terrigenous components. Pristane/phytane ratios of less than one suggest that younger Turonian sediments were laid down under anoxic conditions, but ratios greater than one suggest that older Turonian Cenomanian deposits accumulated in a more oxic environment. Closely bedded green and black layers have very similar types of lipid distributions and differ primarily in concentrations, although black shales contain somewhat larger amounts of terrigenous lipid components. Geochemical and stratigraphic evidence suggests much of the organic matter in these samples originated on the African continental margin and was transported to the Angola Basin by turbidity flow. Rapid reburial of organic-carbon-rich sediments led to formation of the black shales.