Description of lithofacies associations and their interpreted settings from sequences of sediment core CRP-1 (Table 2)

Cape Roberts Project drillcore 1 was obtained from Roberts Ridge, a sea-floor high located at 77°S, 16 km offshore from Cape Roberts in western McMurdo Sound, Antarctica. The recovered core is about 147 m long with the upper 43.15 metres below the sea floor (revised figure) being dated as Quarternary and the older part of the sequence being Miocene. The core includes nine facies: sandy diamict, muddy diamict, gravel/conglomerate, mud(stone), clay(stone) and carbonate. These facies occure in associations that are repeated in particulare sequences throughout the core, and are interpreted as representing different depositional environments through time. Seven lithofacies associations are interpreted as representing offshore shelf, ice protected/below wave-base; prodeltaic/offshore shelf; delta front/sandy shelf; ice system; subglacial till/rainout diamict/debris flow diamicts singly or in combination; and a carbonate-rich shelf bank. The facies associations are used to infer that the Quaternary section represents deposition on a polar shelf with perhaps two or three glacial fluctuations. The Quaternary carbonate unit indicates a period of ice sheet retreat, but local glacial activity may have increased with an increase in costal precipitation. The Miocene section represents polythermal glacial systems. The older Miocene section is glacially dominated whereas the younger section is much less so. The glacially dominated section may provide evidence for a major glacial advance thar resulted un a low stand of global eustatic sea level at that time. After the low stand, eustatic sea level was gradually rising during deposition of the younger section dominated more by non-glacial processes.

Facies analysis on sediment core CRP-3 from the Ross Sea, Antarctica

Cape Roberts Project drill core 3 (CRP-3) was obtained from Roberts ridge, a sea-floor high located at 77°S, 12 km offshore from Cape Roberts in western McMurdo Sound, Antarctica. The recovered core is about 939 m long and comprises strata dated as being early Oligocene (possibly latest Eocene) in age, resting unconformably on ~116 m of basement rocks consisting of Palaeozoic Beacon Supergroup sediments. The core includes ten facies commonly occurring in five major associations that are repeated in particular sequences throughout the core and which are interpreted as representing different depositional environments through time. Depositional systems inferred to be represented in the succession include: outer shelf, inner shelf, nearshore to shoreface each under iceberg influence, deltaic and/or grounding-line fan, and ice proximal-ice marginal-subglacial (mass flow/rainout diamictite/subglacial till) singly or in combination. The record is taken to represent the initial talus/alluvial fan setting of a glaciated rift margin adjacent to the block-uplifted Transantarctic Mountains. Development of a deltaic succession upcore was probably associated with the formation of palaeo-Mackay valley with temperate glaciers in its headwaters. At that stage glaciation was intense enough to support glaciers ending in the sea elsewhere along the coast, but a local glacier was fluctuating down to the sea by the time the youngest part of CRP-3 was being deposited. Changes in palaeoenvironmental interpretations in this youngest part of the core are used to estimate relative glacial proximity to the drillsite through time. These inferred glacial fluctuations are compared with the global d180 and Mg/Ca curves to evaluate the potential of glacial fluctuations on Antarctica for influencing these records of global change. Although the comparisons are tentative at present, the records do have similarities, but there are also some differences that require further evaluation.

Grain size analysis of sediment core CRP-3 from the Ross Sea, Antarctica

Grain-size analyses by sieve and Sedigraph are presented for 115 samples of core from CRP-3, 12 km off the coast of south Victoria Land. The data provide a useful check on visual core descriptions. The geographic setting for the strata sampled, some 790 m of early Oligocene nearshore marine sediments with a persistent glacial influence, is reviewed, and sediment textures interpreted in that context. Sand textures from the CRP-3 samples in the lower part of the core suggest that deposition was initially primarily wave-dominated, but that at times the influence of the waves was over-ridden by episodes of rapid sedimentation. Sedimentary cycles, recognised in the visual description of the core above 485 mbsf, show an increasing proportion of mudstone in the middle of each cycle above 330 mbsf that is interpreted to record periodic sedimentation in deeper water. Sandstone textures in the lower and upper parts of each cycle are interpreted to record departure from and return to shoreface deposition with changes in sea level. Mudstone textures above 176 mbsf indicate sedimentation below wave base. Many of the textures in both sand and mud samples show the coarse 'tail' characteristic of ice-rafted debris, but others do not, indicating ice-free periods. Many sandstones below c. 200 mbsf have virtually no silt, but significant amounts of clay (6 to 17%) that is thought to be of post-depositional origin.

Preliminary results and documentation of sediment core CRP-1 from the Ross Sea off Cape Roberts, Antarctica

The first hole of the Cape Roberts Project, CRP-1, was drilled in October, 1997, to a depth of 148 metres below the sea floor (mbsf) before being terminated unexpectedly the loss of fast sea-ice seaward of the rig following a severe storm. The site lies in 150 m of water at 77.008°S and 163.755°E, 16 km off Cape Roberts. This part of the report outlines the geologic setting, a gently tilted sequence near the margin of the Victoria Land Basin, and describes the history of the growth of sea ice, which provided the drilling platform, as well as the history of the drilling itself. Core recovery was around 77% in soft and brittle strata to 100 m and 98% below that. The sequence was found to comprise a Quaternary glacigenic interval down to 43.55 mbsf and below this an early Miocene interval that was also glacigenic. Core properties that were studied include fracture patterns, porosity, sonic velocity and magnetic susceptibility. Velocity in particular was useful in relating the cored sequence to the regional seismic stratigraphy. A preliminary assessment suggests that the bottom of the hole is 15 m short of the boundary between seismic sequences V3 and V4. Analytical facilities new to the Antarctic and used for processing samples for the project are described here and include a bench top palynological processing system and a palaeomagnetic laboratory. The core management and sampling system, which recorded over 2000 samples, is also outlined.