Petrology at DSDP Leg 66 Holes

The sandstone petrology of Leg 66 samples provides insights into changes through time in the geology of the source regions along the Guerrero portion of the Middle America continental margin. This in turn constrains possible models of the evolution of the Middle America Trench (e.g., de Czerna, 1971; Malfait and Dinkleman, 1972; Karig, 1974). Primarily medium-grained sands and sandstones, representing the widest variety available of trench/trench slope settings and ages, were analyzed in both light and heavy mineral studies. Standard techniques were used as much as possible in order to compare results from other margins and from ancient rocks.

Geochemistry at DSDP Leg 70 Holes

The hydrothermal mounds on the southern flank of the Galapagos Spreading Center are characterized by the following main features: 1) They are located over a young basement (0.5 to 0.85 m.y. of age) in a region known for its high sedimentation rate (about 5 cm/10**3 y.) because it is part of the equatorial high biological productivity zone. 2) They are located in a region with generally high heat flow (8 to 10 HFU). The highest heat-flow measurements (up to 10**3 HFU) correspond to mound peaks (Williams et al., 1979), where temperatures up to 15°C were measured during a dive of the submersible Alvin (Corliss et al., 1978). 3) They are often located on small vertical faults which displace the basement by a few meters (Lonsdale, 1977) and affect the 25- to 50-meter-thick sediment cover. Most of these characteristics have also been observed in the other three known cases of hydrothermal deposits with mineral parageneses similar to that of the Galapagos mounds. However, the case of the hydrothermal mounds south of the Galapagos Spreading Center is unique because of the unusual thickness of the hydrothermal deposits present. The mounds are composed of several, up to 4.5-meter-thick, layers of green clays which, in one case (Hole 509B), are overlain by about 1.4 meters of Mn-oxide crust. We suspect that such a large accumulation of hydrothermal products results from the "funnelling" of the hydrothermal solutions exiting from a highly permeable basement along the faults. This chapter reports a preliminary study of those green clays collected by hydraulic piston coring of the Galapagos mounds during Deep Sea Drilling Project (DSDP) Leg 70 of the D/V Glomar Challenger. Green clays have also been reported from three presently or recently active hydrothermal areas in or close to spreading centers.

Geotechnical properties of sediments at DSDP Site 75-532

During Leg 75 of the Deep Sea Drilling Project (DSDP) from the D/V Glomar Challenger, a 200-m deep hole was drilled at Hole 532A on the eastern side of Walvis Ridge at a water depth of 1331 m. Sediment cores were obtained by means of a hydraulic piston corer. All of the cores from this boring were designated for geotechnical studies and were distributed among eight institutions. The results of laboratory studies on these sediment cores were compiled and analyzed. Sediment properties, including physical characteristics, strength, consolidation, and permeability were studied to evaluate changes as a function of depth of burial. It was concluded that the sediment profile to the explored depth of 200 m at Walvis Ridge consists of approximately 50 m of foram-nannofossil marl (Subunit 1a) over 64 m of diatom-nannofossil marl (Subunit 1b) over nannofossil marl (Subunit 1c) to the depth explored. All three sediment units appear to be normally consolidated, although some anomalies seem to exist to a depth of 120 m. No distinct differences were found among the sediment properties of the three subunits (1a, 1b, and 1c) identified at this site.

Porphyrin geochemistry of DSDP Hole 71-511

Late Jurassic-early Cretaceous black shales and an overlying sequence of Albian-Campanian zeolitic claystones from the Falkland Plateau (DSDP/IPOD Leg 71, Site 511) were analyzed for tetrapyrrole pigment type and abundance. The "black shale" sequence was found to be rich in DPEP-series dominated free-base, nickel (Ni) and, to a lesser extent, vanadyl (V = 0) porphyrins. A low level of organic maturity (i.e. precatagenesis) is indicated for these strata as nickel chelation by free-base porphyrins is only 50-75% complete, proceeding down-hole to 627 meters sub-bottom. Electronic and mass spectral data reveal that the proposed benzo-DPEP (BD) and tetrahydrobenzo-DPEP (THBD) series are present in the free-base and Ni species, as well as the more usual occurrence in V = 0 porphyrin arrays. Highly reducing conditions are suggested by an abundance of the PAH perylene, substantial amounts of the THBD/BD series and a redox equilibrium between free-base DPEP and 7,8-dihydro-DPEP series, which exist in a 7:1 molar ratio. The Albian-Campanian claystone strata were found to be tetrapyrrolepoor, and those pigments present were typed as Cu/Ni highly dealkylated (C26 max.) etioporphyrins, thought to be derived via redeposition and oxidation of terrestrial organic matter (OM). Results from the present study are correlated to our past analyses of Jurassic-Cretaceous sediments from Atlantic margins in an effort to relate tetrapyrrole quality and quantity to basin evolution and OM sources in the proto-Atlantic.

Numerical ages of magnetostratigraphically calibrated biostratigraphic zones at DSDP Leg 73 Holes

Most Cenozoic nannofossil and many foraminiferal zonal boundaries have been accurately determined and magnetostratigraphically calibrated at five Leg 73 boreholes. The numerical ages of the boundaries were computed by assuming a linear seafloor spreading rate and a radiometric age of 66.5 m.y. for the Cretaceous/Tertiary boundary. Alternative magnetostratigraphic ages (given below in parentheses) were obtained by adopting a 63.5 m.y. age for the Cenozoic. Our data confirm previous determinations of the Pleistocene/Pliocene boundary at 1.8 (1.7) m.y. and of the Pliocene/ Miocene boundary at 5.1 (5.0) m.y. The Miocene/Oligocene boundary is placed within Chron C-6C and has a magnetostratigraphic age of 23.8 to 24.0 (22.7 to 22.9) m.y. The Oligocene/Eocene boundary is also very precisely located within Chron C-13-R, with a magnetostratigraphic age of 37.1 to 37.2 (35.5 to 35.6) m.y. The Eocene/Paleocene boundary should be located within an uncored interval of Chron C-24 and have a magnetostratigraphic age of 59.0 (55.4) +/- 0.2 m.y. The general accord of the magnetostratigraphic and radiometric ages supports the hypothesis that the seafloor spreading rate was linear during the Cenozoic. Two possible exceptions are noted: the middle Miocene radiometric ages are a few million years older, and the early Eocene radiometric ages are several million years younger, than the corresponding magnetostratigraphic ages.

40Ar-39Ar dating of rocks drilled at sites 60-458 and 60-459

40Ar-39Ar dating of a high-MgO bronzite andesite from near the top of basement drilled at Site 458 shows the characteristic symptoms of artificially disturbed samples - i.e., an inverse staircase-type age spectrum, approximate linearity on an isochron plot, and concordance between total fusion age and isochron age. From conclusions based on other artificially disturbed samples (Ozima et al., 1979), we suggest that the reference isochron age (33.6 Ma) approximates the age of the sample. A basalt from deeper in Hole 458 gives an isochron age of 19.1 ± 0.2 Ma, which is slightly younger than the plateau age of 21.4 ± 1.0 Ma. Both ages are, however, considerably younger than the age of fossils in the overlying sediments (30 - 34 Ma). The age discrepancy may be explained if the 40Ar-39Ar age represents the age of secondary minerals, which formed later. No useful age data were obtained from a basalt sample recovered from Hole 459B.

(Table 2) Geochemistry of K-feldspars and associated plagioclase phenocrysts and rims at DSDP Legs 69, 52, 51 and 19

Basalts from some holes of the Deep Sea Drilling Project contain secondary K-feldspar which forms pseudomorphs after calcic (>76% An) Plagioclase cores, whereas Plagioclase of rims and microlites (68-74% An) remains unaltered. In basalts of Hole 504B two such grains with relics of Plagioclase in the central parts of phenocysts were recovered. The composition of the Plagioclase rims and of non-replaced phenocrysts is An79-81; the composition of relics is An83. The An and Ab contents of the K-feldspar is higher than in K-feldspar from altered basalt in Hole 418A in the Atlantic Ocean near the Bermuda Rise. Replacement of plagioclases by K-feldspar evidently is caused by oxygen-rich nearbottom sea water penetrating into basalts. The temperature interval of K-feldspathization is probably in the range 30 to 80°C, more-calcic Plagioclase being replaced by K-feldspar at higher temperatures.