B-isotope and Mg/Ca ratios of planktonic foraminifera from ODP Hole 108-668B and esimates of salinity, alkalinity and pCO2 (Table 1)

Knowledge of past atmospheric pCO2 is important for evaluating the role of greenhouse gases in climate forcing. Ice core records show the tight correlation between climate change and pCO2, but records are limited to the past ~900 kyr. We present surface ocean pH and pCO2 data, reconstructed from boron isotopes in planktonic foraminifera over two full glacial cycles (0-140 and 300-420 kyr). The data co-vary strongly with the Vostok pCO2-record and demonstrate that the coupling between surface ocean chemistry and the atmosphere is recorded in marine archives, allowing for quantitative estimation of atmospheric pCO2 beyond the reach of ice cores.

Strontium and neodymium isotope data for barite separates and pore waters, and isotope and concentration data for foraminifera and fish teeth from DSDP Leg 85 sediments

Strontium and neodymium isotopic data are reported for barite samples chemically separated from Late Miocene to Pliocene sediments from the eastern equatorial Pacific. At a site within a region of very high productivity close to the equator, 87Sr/86Sr ratios in the barite separates are indistinguishable from those of foraminifera and fish teeth from the same samples. However, at two sites north of the productivity maximum barite separates have slightly, but consistently lower (averaging 0.000062) ratios than the coexisting phases, although values still fall within the total range of published values for the contemporaneous seawater strontium isotope curve. We examine possible causes for this offset including recrystallization of the foraminifera, fish teeth or barite, the presence of non-barite contaminants, or incorporation of older, reworked deep-sea barite; the inclusion of a small amount of hydrothermal barite in the sediments seems most consistent with our data, although there are difficulties associated with adequate production and transportation of this phase. Barite is unlikely to replace calcite as a preferred tracer of seawater strontium isotopes in carbonate-rich sediments, but may prove a useful substitute in cases where calcite is rare or strongly affected by diagenesis. In contrast to the case for strontium, neodymium isotopic ratios in the barite separates are far from expected values for contemporary seawater, and appear to be dominated by an (unobserved) eolian component with high neodymium concentration and low 143Nd/144Nd. These results suggest that the true potential of barite as an indicator of paleocean neodymium isotopic ratios and REE patterns will be realized only when a more selective separation procedure is developed.

Stable isotope ratios on foraminifera and age determinations from sediments of BP00 and BP01 cruises to the Kara Sea

no abstract available

South Pacific dissolved Nd isotope compositions, rare earth element and nutrient concentrations from SONNE cruise SO213

Despite its enormous extent and importance for global climate, the South Pacific has been poorly investigated in comparison to other regions with respect to chemical oceanography. Here we present the first detailed analysis of dissolved radiogenic Nd isotopes (epsilon-Nd) and rare earth elements (REEs) in intermediate and deep waters of the mid-latitude (~40°S) South Pacific along a meridional transect between South America and New Zealand. The goal of our study is to gain better insight into the distribution and mixing of water masses in the South Pacific and to evaluate the validity of Nd isotopes as a water mass tracer in this remote region of the ocean. The results demonstrate that biogeochemical cycling (scavenging processes in the Eastern Equatorial Pacific) and release of LREEs from the sediment clearly influence the distribution of the dissolved REE concentrations at certain locations. Nevertheless, the Nd isotope signatures clearly trace water masses including AAIW (Antarctic Intermediate Water) (average epsilon-Nd = -8.2 ± 0.3), LCDW (Lower Circumpolar Deep Water) (average epsilon-Nd = -8.3 ± 0.3), NPDW (North Pacific Deep Water) (average epsilon-Nd = -5.9 ± 0.3), and the remnants of NADW (North Atlantic Deep Water) (average epsilon-Nd = -9.7 ± 0.3). Filtered water samples taken from the sediment-water interface under the deep western boundary current off New Zealand suggest that boundary exchange processes are limited at this location and highlight the spatial and temporal variability of this process. These data will serve as a basis for the paleoceanographic application of Nd isotopes in the South Pacific.

Petrology and isotope characteristics of basalts from ODP Hole 111-504B

Petrography and isotope geochemical characteristics of H, O, S, Sr, and Nd have been described for basalts recovered from Hole 504B during Leg 111 of the Ocean Drilling Program. The petrographic and chemical features of the recovered basalts are similar to those obtained previously (DSDP Legs 69, 70, and 83); they can be divided into phyric (plagioclase-rich) and aphyric (Plagioclase- and clinopyroxene-rich) basalts and show low abundances of TiO2, Na2O, K2O, and Sr. This indicates that the basalts belong to Group D, comprising the majority of the upper section of the Hole 504B. The diopside-rich nature of the clinopyroxene phenocrysts and Ca-rich nature of the Plagioclase phenocrysts are also consistent with the preceding statement. The Sr and Nd isotope systematics (average 87Sr/86Sr = 0.70267 ± 0.00007 and average 143Nd/144Nd = 0.513157 ± 0.000041) indicate that the magma sources are isotopically heterogeneous, although the analyzed samples represent only the lowermost 200-m section of Hole 504B. The rocks were subjected to moderate hydrothermal alteration throughout the section recovered during Leg 111. Alteration is limited to interstices, microfractures, and grain boundaries of the primary minerals, forming chlorite, actinolite, talc, smectite, quartz, sphene, and pyrite. In harmony with the moderate alteration, the following alteration-sensitive parameters show rather limited ranges of variation: H2O = 1.1 ±0.2 wt%, dD = - 38 per mil ± 4 per mil, d180 = 5.4 per mil ± 0.3 per mil, total S = 562 ± 181 ppm, and d34S = 0.8 per mil ± 0.3 per mil. Based on these data, it was estimated that the hydrothermal fluids had dD and d180 values only slightly higher than those of seawater, the water/rock ratios were as low as 0.02-0.2, and the temperature of alteration was 300°-400°C. Sulfur exists predominantly as pyrite and in minor quantities as chalcopyrite. No primary monosulfide was detected. This and the d34S values of pyrite (d34S = 0.8 per mil) suggest that primary pyrrhotite was almost completely oxidized to pyrite by reaction with hydrothermal fluids containing very little sulfate.

Isotope ratios of smectites, calcites and whole rocks from DSDP Legs 51 and 52, Atlantic Ocean

Delta180 and 87Sr/86Sr isotopic data from smectites, calcites, and whole rocks, together with published isotopic age determinations, alkali element concentration data and petrographic observations suggest a sequential model of ocean floor alteration. The early stage lasts about 3 m.y. and is characterized by palagonite and smectite formation, and solutions with a large basaltic component, increasing with temperature which varies from 15° to 80° C at DSDP site 418A. Most carbonates are deposited after this stage from solutions with a negligible basaltic Sr component and temperatures of 15° to 40° C. Water of seawater Sr and O isotopic composition is shown to percolate to at least 500 m into the basaltic basement. No evidence was found for continuing exchange of strontium or oxygen after 3 m.y.

Sulfur concentrations and isotope ratios in sediments from Kiel Bay, western Baltic Sea

The isotope-ratios of sulfur-components in several sedimentologically different cores of recent marine sediments from Kiel Bay (Baltic Sea) were investigated. In addition, quantitative determinations were made on total sulfur, sulfate, sulfide, chloride, organic carbon, iron and watercontent in the sediment or in the pore-water solution. The investigations gave the following results: 1. The sulfur in the sediment (about 0.3 -2 % of the dry sample) was for the most part introduced into the sediment after sedimentation. This confirms the results of Kaplan et al. (1963, doi:10.1016/0016-7037(63)90074-7). The yield of Sulfur from organic material is very small (in our samples about 5-10% of the total sulfur in the sediment). 2. The sulfur bound in the sediment is taken from the sulfate of the interstitial water. During normal sedimentation, the exchange of sulfate by diffusion significant for changes in the sulfur-content goes down to a sediment depth of 4-6 cm. In this way the sulfate consumed by reduction and formation of sulfide or pyrite is mostly replaced. The uppermost layer of the sediment is an partly open system for the sulfur. The diagenesis of the sulfur is allochemical. 3. The isotope-values of the sediment-sulfur are largely influenced by the sulfur coming into the sediment by diffusion and being bound by bacteriological reduction. Due to the prevailing reduction of 32S and reverse-diffusion of sulfate into the open sea-water, an 32S enrichment takes place in the uppermost layer of the sediment. delta34S-values in the sediment range between -15 and -35 ? while seawater-sulfate has +20 ?. No relationship could be established between sedimentological or chemical changes and isotope-ratios. In the cores, successive sandy and clayly layers showed no change in the delta-values. The sedimentation rate, however, seems to influence isotope-ratios. In one core with low sedimentationrates the delta34S-values varied between -29 and -33 ?, while cores with higher sedimentationrates showed values between -17 and -24 ?. 4. As sediment depth increases, the pore-water sulfate shows decreasing concentrations (in a depth of 30-40 cm we found between 20 and 70 % of the seawater-values), and increasing delta 34S-values (in one case reaching more than +60 ?). The concentration of sulfide in the pore-water increases with sediment-depth (reaching 80 mg S/l in one case). The (delta34S-values of the pore-water-sulfide in all cores show increases paralleling the sulfate sulfur, with a nearly constant delta-distance of 50-60 ? in all cores. This seems to confirm the genetic relationship between the two components.