Geochemical and Nd isotopic investigations of sediments from the South China Sea

Secular variations in geochemistry and Nd isotopic data have been documented in sediment samples at ODP Site 1148 in the South China Sea. Major and trace elements show significant changes at ca. 29.5 Ma and 26-23 Ma, whereas epsilon-Nd values show a single change at ca. 26-23 Ma. Increases in Al/Ti, Al/K, Rb/Sr, and La/Lu ratios and a decrease in the Th/La ratio of the sediments beginning at 29.5 Ma are consistent with more intense chemical weathering in the source region. The abrupt change in Nd isotopes and geochemistry at ca. 26-23 Ma coincides with a major discontinuity in the sedimentology and physical properties of the sediments, implying a drastic change in sedimentary provenance and environment at the drill site. Comparison of the Nd isotopes of sediments from major rivers flowing into the South China Sea suggests that pre-27 Ma sediments were dominantly derived from a southwestern provenance (Indochina-Sunda Shelf and possibly northwestern Borneo), whereas post-23 Ma sediments were derived from a northern provenance (South China). This change in provenance from southwest to north was largely caused by ridge jumping during seafloor spreading of the South China Sea, associated with a southwestward expansion of the ocean basin crust and a global rise in sea level. Thus, the geochemical and Nd isotopic changes in the sediments at ODP Site 1148 are interpreted as a response to a major plate reorganization in SE Asia at ca. 25 Ma.

AMS 14C ages and isotopic compositions of samples from the Derugin Basin, Sea of Okhotsk

An area of massive barite precipitations was studied at a tectonic horst in 1500 m water depth in the Derugin Basin, Sea of Okhotsk. Seafloor observations and dredge samples showed irregular, block- to column-shaped barite build-ups up to 10 m high which were scattered over the seafloor along an observation track 3.5 km long. High methane concentrations in the water column show that methane expulsion and probably carbonate precipitation is a recently active process. Small fields of chemoautotrophic clams (Calyptogena sp., Acharax sp.) at the seafloor provide additional evidence for active fluid venting. The white to yellow barites show a very porous and often layered internal fabric, and are typically covered by dark-brown Mn-rich sediment; electron microprobe spectroscopy measurements of barite sub-samples show a Ba substitution of up to 10.5 mol% of Sr. Rare idiomorphic pyrite crystals (~1%) in the barite fabric imply the presence of H2S. This was confirmed by clusters of living chemoautotrophic tube worms (1 mm in diameter) found in pores and channels within the barite. Microscopic examination showed that micritic aragonite and Mg-calcite aggregates or crusts are common authigenic precipitations within the barite fabric. Equivalent micritic carbonates and barite carbonate cemented worm tubes were recovered from sediment cores taken in the vicinity of the barite build-up area. Negative d13C values of these carbonates (>-43.5 per mill PDB) indicate methane as major carbon source; d18O values between 4.04 and 5.88 per mill PDB correspond to formation temperatures, which are certainly below 5°C. One core also contained shells of Calyptogena sp. at different core depths with 14C-ages ranging from 20 680 to >49 080 yr. Pore water analyses revealed that fluids also contain high amounts of Ba; they also show decreasing SO4**2- concentrations and a parallel increase of H2S with depth. Additionally, S and O isotope data of barite sulfate (d34S: 21.0-38.6 per mill CDT; d18O: 9.0-17.6 per mill SMOW) strongly point to biological sulfate reduction processes. The isotope ranges of both S and O can be exclusively explained as the result of a mixture of residual sulfate after a biological sulfate reduction and isotopic fractionation with 'normal' seawater sulfate. While massive barite deposits are commonly assumed to be of hydrothermal origin, the assemblage of cheomautotrophic clams, methane-derived carbonates, and non-thermally equilibrated barite sulfate strongly implies that these barites have formed at ambient bottom water temperatures and form the features of a Giant Cold Seep setting that has been active for at least 49 000 yr.

Calcium isotope ratios of porewaters of ODP Leg 204 holes

The calcium isotopic composition of porewaters and authigenic carbonates in the anoxic sediments of a convergent continental margin drilled during Ocean Drilling Program (ODP) provides first insight into the different processes that control Ca geochemistry in clastic marine, organic-rich sedimentary environments. In 4 sites drilled during Leg 204 at Hydrate Ridge (Cascadia Margin, offshore Oregon/USA), sulfate is consumed during anaerobic oxidation of methane and of organic matter via sulfate reduction within the upper meters of the sedimentary section. These reactions promote the precipitation of authigenic carbonates through the generation of bicarbonate, which is reflected in a pronounced decrease in calcium concentration. Although Ca isotope fractionation is observed during carbonate precipitation, Ca concentration in the pore fluids from ODP Leg 204 is decoupled from Ca isotopy, which seems to be mainly controlled by the release of light Ca isotopes that completely overprint the carbonate formation effect. Different processes, such as the release of organically bound Ca, ion exchange and ion pair formation may be responsible for the released light Ca. Deeper within the sedimentary section, additional processes such as ash alteration influence the Ca isotopic composition of the porewater. Two sites, drilled into the deeper core of the accretionary prism, reveal the nature of fluids which have reacted with the oceanic basement. These deep fluids are characterized by relatively high Ca concentrations and low d44/40Ca ratios.

Halogene concentrations and iodine isotopic composition in pore water on Hydrare Ridge, Cascadia continental margin

We report iodine and bromine concentrations in a total of 256 pore water samples collected from all nine sites of Ocean Drilling Program Leg 204, Hydrate Ridge. In a subset of these samples, we also determined iodine ages in the fluids using the cosmogenic isotope 129I (T1/2 = 15.7 Ma). The presence of this cosmogenic isotope, combined with the strong association of iodine with methane, allows the identification of the organic source material responsible for iodine and methane in gas hydrates. In all cores, iodine concentrations were found to increase strongly with depth from values close to that of seawater (0.0004 mM) to concentrations >0.5 mM. Several of the cores taken from the northwest flank of the southern summit show a pronounced maximum in iodine concentrations at depths between 100 and 150 meters below seafloor in the layer just above the bottom-simulating reflector. This maximum is especially visible at Site 1245, where concentrations reach values as high as 2.3 mM, but maxima are absent in the cores taken from the slope basin sites (Sites 1251 and 1252). Bromine concentrations follow similar trends, but enrichment factors for Br are only 4-8 times that of seawater (i.e., considerably lower than those for iodine). Iodine concentrations are sufficient to allow isotope determinations by accelerator mass spectrometry in individual pore water samples collected onboard (~5 mL). We report 129I/I ratios in a few samples from each core and a more complete profile for one flank site (Site 1245). All 129I/I ratios are below the marine input ratio (Ri = 1500x10**-15). The lowest values found at most sites are between 150 and 250x10**-15, which correspond to minimum ages between 40 and 55 Ma, respectively. These ages rule out derivation of most of the iodine (and, by association, of methane) from the sediments hosting the gas hydrates or from currently subducting sediments. The iodine maximum at Site 1245 is accompanied by an increase in 129I/I ratios, suggesting the presence of an additional source with an age younger than 10 Ma; there is indication that younger sources also contribute at other sites, but data coverage is not yet sufficient to allow a definitive identification of sources there. Likely sources for the older component are formations of early Eocene age close to the backstop in the overriding wedge, whereas the younger sources might be found in recent sediments underlying the current locations of the gas hydrates.

Ages and stable isotope ratios from speleothem calcite from Cold Water Cave, Iowa

High-precision uranium-thorium mass spectrometric chronology and 18O-13C isotopic analysis of speleothem calcite from Cold Water Cave in northeast Iowa have been used to chart mid-Holocene climate change. Significant shifts in d18O and d13C isotopic values coincide with well-documented Holocene vegetation changes. Temperature estimates based on 18O/16O ratios suggest that the climate warmed rapidly by about 3°C at 5900 years before present and then cooled by 4°C at 3600 years before present. Initiation of a gradual increase in ?d13C at 5900 years before present suggests that turnover of the forest soil biomass was slow and that equilibrium with prairie vegetation was not attained by 3600 years before present.

Pb concentrations, Pb isotopic composition, and amount of metalliferous components in pelagic sediments from the Pacific Ocean

The amount of lead annually transferred from oceanic crust to metalliferous sediments was estimated in order to test the hypothesis that a non-magmatic flux of lead causes the Pb surplus in the continental crust. A Pb surplus has been inferred from global crust-mantle lead mass balances derived from lead concentration correlations with other trace elements and from lead isotope systematics in oceanic basalts. DSDP/ODP data on the amount of metalliferous sediments in the Pacific Ocean and along a South Atlantic traverse are used to calculate the mean worldwide thickness of 3 (+/-1) m for purely metalliferous sediment componens. Lead isotope ratios of 39 metalliferous sediments from the Pacific define mixing lines between continent-derived (seawater) and mantle-derived (basaltic) lead, with the most metal-rich sediments usually having the most mantle-like Pb isotope composition. We used this isotope correlation and the Pb content of the 39 metalliferous sediments to derive an estimate of 130 (+/-70) µg/g for the concentration of mantle-derived lead in the purely metalliferous end-member. Mass balance calculations show that at least 12 (+/-8)% of the lead, annually transferred from upper mantle to oceanic crust at the ocean ridges, is leached out by hydrothermal processes and re-deposited in marine sediments. If all of the metalliferous lead is ultimately transferred to the continental crust during subduction, the annual flux of this lead from mantle to continental crust is 2.6 (+/-2.0) * 10**6 kg. Assuming this transfer rate to be proportional to the rate of oceanic plate production, one can fit the lead transfer to models of plate production rate variations through time. Integrating over 4 Ga, hydrothermal lead transfer to the continental crust accounts for a significant portion of the Pb surplus in the continental crust. It therefore appears to be one of the main reasons for the anomalous behavior of lead in the global crust-mantle system.

(Appendix) Petrographic information, trace element and Sr isotope ratios of Pito Deep samples

Fluid flow through the axial hydrothermal system at fast spreading ridges is investigated using the Sr-isotopic composition of upper crustal samples recovered from a tectonic window at Pito Deep (NE Easter microplate). Samples from the sheeted dike complex collected away from macroscopic evidence of channelized fluid flow, such as faults and centimeter-scale hydrothermal veins, show a range of 87Sr/86Sr from 0.7025 to 0.7030 averaging 0.70276 relative to a protolith with 87Sr/86Sr of ~0.7024. There is no systematic variation in 87Sr/86Sr with depth in the sheeted dike complex. Comparison of these new data with the two other localities that similar data sets exist for (ODP Hole 504B and the Hess Deep tectonic window) reveals that the extent of Sr-isotope exchange is similar in all of these locations. Models that assume that fluid-rock reaction occurs during one-dimensional (recharge) flow lead to significant decreases in the predicted extent of isotopic modification of the rock with depth in the crust. These model results show systematic misfits when compared with the data that can only be avoided if the fluid flow is assumed to be focused in isolated channels with very slow fluid-rock exchange. In this scenario the fluid at the base of the crust is little modified in 87Sr/86Sr from seawater and thus unlike vent fluids. Additionally, this model predicts that some rocks should show no change from the fresh-rock 87Sr/86Sr, but this is not observed. Alternatively, models in which fluid-rock reaction occurs during upflow (discharge) as well as downflow, or in which fluids are recirculated within the hydrothermal system, can reproduce the observed lack of variation in 87Sr/86Sr with depth in the crust. Minimum time-integrated fluid fluxes, calculated from mass balance, are between 1.5 and 2.6 * 10**6 kg/m**2 for all areas studied to date. However, new evidence from both the rocks and a compilation of vent fluid compositions demonstrates that some Sr is leached from the crust. Because this leaching lowers the fluid 87Sr/86Sr without changing the rock 87Sr/86Sr, these mass balance models must underestimate the time-integrated fluid flux. Additionally, these values do not account for fluid flow that is channelized within the crust.