(Table 2) Petrophysical, petrological, and geochemical characteristics of ODP Hole 163-990A sediments

Ocean Drilling Program Hole 990A penetrated 131 m of subaerially emplaced Paleocene flood basalts on the Southeast Greenland margin with a recovery of 74%. Shipboard P-wave velocity (Vp), density, and magnetic susceptibility were measured with 2- to 15-cm intervals on the core. Individual flow units were divided into four zones based on the observed petrophysical characteristics. From the top, these are Zone I (<7 m thick with a Vp of ~2.5 km/s), Zone II (3-5 m thick with a strongly increasing Vp from 2.5 to 5.5 km/s), Zone III (up to 20 m thick with a Vp of ~5.5-6.0 km/s), and Zone IV (<2 m thick with a strongly decreasing Vp from 6.0 to 2.5 km/s). Eighteen samples were selected from three of the fourteen penetrated basalt units for geochemical, petrological, and petrophysical studies focusing on the altered, low-velocity upper lava Zones I and II. Zone I is strongly altered to >50% clay minerals (smectite) and iron hydroxides, and the petrophysical properties are primarily determined by the clay properties. Zone II is intermediately altered with 5%-20% clay minerals, where the petrophysical properties are a function of both the degree of alteration and porosity variations. Shipboard and shore-based measurements of the same samples show that storage permanently lowers the elastic moduli of basalt from Zones I to III. This is related to the presence of even small quantities of swelling clays. The data show that alteration processes are important in determining the overall seismic properties of flood basalt constructions. The degree and depth of alteration is dependent on the primary lava flow emplacement structures and environment. Thus, the interplay of primary emplacement and secondary alteration structures determine the elastic properties of basalt piles. Rock property theories for sand-clay systems are further used to model the physical property variations in these altered crystalline rocks.

(Supplement Table1) Abundances of major elements from KH93-3_DR10 at the Southwest Indian Ridge near the Rodriguez Triple Junction

Petrographic and geochemical analyses of basaltic rocks dredged from the first segment of the Southwest Indian Ridge near the Rodriguez Triple Junction have been completed in order to investigate water-rock interaction processes during mid-ocean ridge (MOR) hydrothermal alteration in the Indian Ocean. In the study area, we have successfully recovered a serial section of upper oceanic crust exposed along a steep rift valley wall which was uplifted and emplaced along a low angle normal fault. On the basis of microscopic observation, dredged samples are classified into three types: fresh lavas, low-temperature altered rocks, and high-temperature altered rocks. The fresh lavas have essentially the same chemical composition as typical N-MORB, although LILE and Nb are slightly enriched and depleted, respectively. Low temperature alteration brought about the enrichment of K2O, Rb, and U due to the presence of K-rich celadonite and U-adsorption onto Fe-oxyhydroxide and clay minerals. On the other hand, chloritization, albitization, and addition of base metals by high temperature hydrothermal alteration result in enrichments of MnO, MgO, Na2O, Cu, and Zn and depletions of CaO, K2O, Cr, Co, Ni, Rb, Sr, and Ba. In addition, U-enrichment is also observable in the high temperature altered rocks probably due to the decrease of uranite solubility in the reducing high-temperature hydrothermal solution. These petrological and geochemical features are comparable to those of the volcanic zone to transition zone rocks in the DSDP/ODP Hole 504B, indicating that our samples were recovered from the upper ~1000 m section of the oceanic crust. Only the alteration minerals related to off-axis alteration are absent in our samples dredged from near the spreading axis. The similarity of alteration between our samples from the Indian Ocean and the Hole 504B rocks from the Pacific Ocean suggests that MOR hydrothermal systems are probably similar across all world oceans.

(Table 2) Chlorine geochemistry and mineralogy of altered oceanic crust samples

Bulk chlorine concentrations and chlorine stable isotope compositions were determined for hydrothermally altered basalt (extrusive lavas and sheeted dikes) and gabbro samples (n = 50) from seven DSDP/ODP/IODP drill sites. These altered oceanic crust (AOC) samples span a range of crustal ages, tectonic settings, alteration type, and crustal depth. Bulk chlorine concentrations range from < 0.01 wt.% to 0.09 wt.%. In general, higher chlorine concentrations coincide with an increase in temperature of alteration and amphibole content. d37Cl values of whole rock AOC samples range from -1.4 to +1.8 per mil. High d37Cl values (>=~0.5 per mil) are associated with areas of higher amphibole content. This observation is consistent with theoretical calculations that estimate amphibole should be enriched in 37Cl compared to co-existing fluid. Negative to near zero d37Cl values are found in areas dominated by clay minerals. Chlorine geochemistry is a rough indicator of metamorphic grade and mineralogy. AOC is a major Cl host in the subducting oceanic lithospheric slab. Here we show that bulk chlorine concentrations are ~3 times higher than previous estimates resulting in a greater contribution of Cl to the mantle.

(Table 1) Basement penetration, recovery, and lithology of crustal DSDP holes in the North Atlantic Ocean

Oceanic crustal drilling by R. V. Glomar Challenger at 15 sites in the North Atlantic has led to a complex picture of the upper half kilometer of the crust. Elements of the picture include the absence of the source for linear magnetic anomalies, marked episodicity of volcanic activity, ubiquitous low temperature alteration and evidence for large scale tectonic disturbance. Comparison sections in the Pacific and much deeper crustal drilling are needed to attack problems arising from the North Atlantic results.

Strontium isotope and rare earth element geochemistry of basalts from DSDP Leg 37

87Sr/S6Sr ratios have been determined on eleven whole rock basalt samples from DSDP Leg 37. The 87Sr/S6Sr ratios range from 0.70305 +/- 4 to 0.70451 +/- 4 due to alteration and contamination with seawater Sr. Leaching with 5% HF has only a small effect on the 87Sr/86Sr of the samples. However, treatment with 6M HCl in acid digestion bombs at 130°C removes the contaminant more effectively. Altered plagioclase and olivine are dissolved during this process. The mean 87Sr/86Sr of four HCl-treated samples from hole 332A is 0.70299 and that for five samples from hole 332B is 0.70297. The 87Sr/86Sr ratios of treated samples from holes 333A and 335 are 0.70304 +/- 4 and 0.70316 +/- 4, respectively. These 87Sr/86Sr ratios are within the range observed for other basalts elsewhere along the Mid-Atlantic Ridge in the North Atlantic. REE distribution patterns have been determined for four samples, three from hole 332B and one from hole 335. CeN/YbN ratios range from 0.58 to 1.30 and do not correlate with 87Sr/86Sr ratios. The source regions of these basalts appear to have been variable in REE abundances.