Points and dates of tagging and recapture of mature cod in the southern Barents Sea in 1937-1955

Barents cod spawn in the Motovsky Bay during the periods of warming in the Arctic when proportion of mature fish in the population is high enough. Cod spawning is most likely to occur in the Motovsky Bay when large cod forage in southeastern waters, and prespawning fish migrate close by the Murmansk coast. Under such conditions cod spawn in the Motovsky Bay, but low water temperature and slow egg drift toward Murmansk coastal waters delay development of cod eggs. As a result the eggs remain at the first stage for a long time; this causes high egg mortality before hatching. Larvae that survive and become pelagic and then bottom juveniles nevertheless have little chance to survive in winter because they are not biologically ready for overwintering. Thus, delay in egg development at the first stage delays subsequent stages of fish ontogeny, and strongly impairs survival of cod juveniles from the Motovsky Bay.

Digital elevation model (DEM), surveyed stream network (SSN), mask and stream sampling points (SSP)

These data are provided to allow users for reproducibility of an open source tool entitled 'automated Accumulation Threshold computation and RIparian Corridor delineation (ATRIC)'

Composite depth scales, ash layer correlations and splice tie points of ODP Site 186-1151

We present composite depth scales for the multiply cored intervals from Sites 1150 and 1151. These new depth scales place coeval strata recovered in cores from different holes at a single site into a common stratigraphic framework. At Site 1150, double coring between Holes 1150A and 1150B occurred over only a short interval between ~703 and 713 meters below seafloor (mbsf), but this is sufficient to tie the upper portion of the stratigraphic section cored in Hole 1150A to the lower portion cored in Hole 1150B. The upper ~100 m of the sedimentary section at Site 1151 was double cored with the advanced piston corer and partially cored with the rotary core barrel, resulting in the complete recovery of this interval. The composite depth scales were constructed using Splicer software to vertically adjust the relative depths of various cores from one hole to the depths from another hole so as to align distinct physical properties measured on cores. The magnetic susceptibility data was the physical property most easily correlated between holes, and therefore primarily used to create a composite depth scale and spliced stratigraphic section. The spliced section is a continuous stratigraphic section constructed from representative cored intervals from the holes at a site. Both the splice and the composite depth scale can be applied to other data sets from Site 1151 to provide a stratigraphically continuous and laterally consistent basis for interpreting lithologic features or data sets. The resulting composite scale showed a 30% improvement in correlation of the magnetic susceptibility data relative to the original mbsf depth scale, and comparable improvement when applied to the other data sets.