Strontium and Oxygen isotope compositions from DSDP Holes 54-424A, 54-424B and 70-509B

Strontium and O isotope compositions of green clay minerals from sediment cores of three boreholes drilled into (sites 424A and 509B) and close to a hydrothermal mound (site 424B) near the Galapagos Spreading Center (DSDP Legs 54 and 70) were determined. The green clays consist mostly of a transition from Fesmectite (nontronite) to glauconite. 87Sr/86Sr ratios were measured on clay size-fractions after gentle acid leaching and on the recovered leachates from different samples. The 87Sr/86Sr ratios of the clay residues from both the 424A and B sites are well below the modern seawater value, which points consistently to precipitation from hydrothermal fluids that contained variable amounts of seawater, even away from mound. However, most of the clay residues from mound site 509B have 87Sr/86Sr ratios significantly above the seawater value, suggesting the occurrence of a detrital component together with the new authigenic particles. The clay minerals of the hydrothermal mound are mixed with detrital components, and that of the sample taken outside but near the mound as a reference for the surrounding oceanic environment, yields a hydrothermal signature. Crystallization temperatures of the clays range from 32 to 63 °C assuming a d18O value of +2.2 per mil for the mineralizing fluids. Hydrothermal fluids generated in the underlying oceanic crust, mixed in varied proportions with ambient seawater and migrated into beds of the mound in a sequence of recurrent processes that ultimately resulted in the formation of the observed clay minerals. No significant temperature differences were detected for crystallization of the K-rich glauconite and K-depleted nontronite. The 87Sr/86Sr ratios of the Sr leached off the clay particles are near the value of modern seawater, inferring a progressive replacement of the hydrothermal fluids by seawater in the pore space of the mound sediments.

Pore-water chemistry at DSDP Leg 70 Holes

Geological and geophysical data collected during Deep Sea Drilling Project (DSDP) Leg 70 indicate that hydrothermal solutions are upwelling through the sediments of the mounds hydrothermal field (Sites 506, 507, and 509) and downwelling in the low heat-flow zone to the south (Site 508). Pore-water data are compatible with these conclusions. Pore waters at mounds sites are enriched in Ca and depleted in Mg relative to both seawater and Site 508 pore waters. These anomalies are believed to reflect prior reaction of the interstitial waters with basement rocks. The mounds solutions are also enriched in iron, which is probably hydrothermal and en route to forming nontronite. Concentrations of Si and NH3 in mounds pore water increase upcore as a result of the addition of dissolving biogenic debris to ascending hydrothermal solutions. Some low heat-flow pore-water samples (Site 508) are enriched in Ca and depleted in Mg. These anomalies likely reflect the presence of pockets of hydrothermal solutions in areas otherwise dominated by downwelling bottom water.

Mechanical properties and comparisons of dynamic and static Young's moduli at DSDP Holes 69-504B, 70-504B and 83-504B

From laboratory tests under simulated downhole conditions we tentatively conclude that the higher the triaxial-compressive strength, the lower the drilling rate of basalts from DSDP Hole 504B. Because strength is roughly proportional to Young's modulus of elasticity, which is related in turn to seismic-wave velocities, one may be able to estimate drilling rates from routine shipboard measurements. However, further research is needed to verify that P-wave velocity is a generally useful predictor of relative drilling rate.