(Table 2) Estimated basement temperatures at DSDP Hole 69-504B

The achievement of deep penetration (562 m) of seafloor basalts at Hole 504B, near the Costa Rica Rift (1°13.63'N, 83°43.81'W), on DSDP Legs 69 and 70 presented a rare opportunity to examine the structure of young (6 m.y.) oceanic crust. In addition to the recovery of samples for laboratory studies, an extensive suite of downhole logs and experiments was carried out at this site, for two main purposes: (1) to allow reliable deductions about the nature of the entire section of penetrated crust, because recovery of samples was far from complete (-25%); (2) to probe the physical state of rock around the drilled hole on a scale of tens of meters to kilometers. Information on the latter large-scale phenomena at Hole 504B were provided mainly by the oblique seismic experiment, utilizing a bore-hole seismometer (Stephen 1983), and by the large-scale-electrical- resistivity experiment described below.

(Table 1) Paleomagnetic properties of specimens from DSDP Holes 69-504B and 70-504B

Paleomagnetic and rock magnetic measurements of basalt specimens from DSDP Hole 504B, associated with the Costa Rica Rift, have a mean natural remanence intensity (Jn) between 5 and 10 x 10**-3 gauss, consistent with the presence of a magnetized layer that is 0.5 to 1 km thick, which produces the observed magnetic anomalies. A mean Koenigsberger ratio (Qn) greater than 10 indicates that the remanence dominates the magnetic signal of the drilled section. The susceptibility (x) increases with depth, and the median demagnetizing field (MDF) decreases with increasing depth in Hole 504B, congruent with the downhole increase in the relative abundance of massive flow units. Hole 504B is composed of at least 12 units with distinct stable average inclinations (Is), which probably represent extrusion at times of different geomagnetic field directions and possibly also the effects of faulting. The thickness of basalt associated with these inclination units varies from less than 9 meters to possibly as much as 160 meters. Two relatively thick magnetic units (40 m and 45 m, separated by 100 m) have anomalously high Is values of -53° and -63°, in contrast with the near zero inclinations expected for the equatorial latitude of Site 504. For this reason and because the average inclination of all the magnetic units is skewed to a negative value, it might be that the entire section at Hole 504B was tilted by approximately 30°.

Sample descriptions, d-spacing and geochemistry at DSDP Holes 68-501 and 69-504B

Mössbauer analyses were conducted on a sample of saponite selected from DSDP Leg 69 basalt core. The sample was initially placed within a nitrogen-purged container on-board Glomar Challenger approximately three hours after recovery, where it remained until analysis. The Mössbauer data revealed an original, in situ Fe2O3/FeO ratio of 0.46, with both Fe**2+ and Fe**3+ in octahedral coordination. With controlled exposure to air under ambient laboratory storage conditions, the proportion of Fe**3+ increased from an original 30% to 51% over a period of about 11.5 months. The Fe**3+ thus produced remained in octahedral coordination, and no observable changes occurred in the physical appearance of the sample.

(Table 1) K-Ar age and inert-gas-isotopes at DSDP Holes 68-501, 69-504B and 69-505B

Conventional K-Ar ages have been determined and inert-gas abundances have been measured on representative samples of altered rocks from Deep Sea Drilling Project Holes 501, 504B, and 505B in an attempt to correlate their degree of alteration with inert-gas and K-Ar data. Samples taken from the first 60 meters below the sediment/basalt interface give significantly higher ages than would be expected from the magnetic stratigraphy, though at greater depths the calculated ages are in broad agreement with the expected age. The inert gas ratios 20Ne/36Ar, 36Ar/84Kr, and 84Kr/130Xe also show a marked discontinuity at the 60-meter depth, and all these effects are interpreted as being a consequence of low-temperature alteration produced by burial metamorphism and by interaction with sea water (halmyrolysis).