(Table 2, Page 287) Chemical composition of manganese nodules from GH76-1 cruise

Chemical analyses of manganese nodules from the Central Pacific Basin show that their chemical composition varies regionally, although that of the associated sediments is markedly uniform throughout the basin. Mn content varies from 16 to 32% in average. Its higher value is generally found in nodules from siliceous clay and a few from deep-sea clay. Fe content tends to enrich in nodules from deep-sea clay area. Most manganese nodules, except those from deep-sea clay, are remarkably depleted in Fe compared with ones from the other Pacific regions. Mostly, Cu and Ni contents exceed 1% in nodules from siliceous clay, and decrease towards the northwest of the basin where deep-sea clay is distributed. The inter-element relationship between manganese nodules and associated sediments suggests that the mechanism of incorporation of major and minor elements in nodules is apparently different from that of the associated sediments. This finding seems to provide a new interpretation on the problem why manganese nodules having low accumulation rate are not buried by the associated sediments with greater sedimentation rate and then occur on sediment-seawater interface.

Geological reference standards (JLK-1,JSD-1, JSD-2, JSD-3,JMS-1, JMS-2) measured by Itrax-XRF core scanner in different exposure times

X-ray fluorescence (XRF) core-scanning is a fast and nondestructive technique to assess elemental variations of unprocessed sediments. However, although the exposure time of XRF-scanning directly affects the scanning counts and total measurement time, only a few studies have considered the influence of exposure time during the scan. How to select an optimal exposure time to achieve reliable results and reduce the total measurement time is an important issue. To address this question, six geological reference materials from the Geological Survey of Japan (JLK-1, JMS-1, JMS-2, JSD-1, JSD-2, and JSD-3) were scanned by the Itrax-XRF core scanner using the Mo- and the Cr-tube with different exposure times to allow a comparison of scanning counts with absolute concentrations. The regression lines and correlation coefficients of elements that are generally used in paleoenvironmental studies were examined for the different exposure times and X-ray tubes. The results show that for those elements with relatively high concentrations or high detectability, the correlation coefficients are higher than 0.90 for all exposure times. In contrast, for the low detectability or low concentration elements, the correlation coefficients are relatively low, and improve little with increased exposure time. Therefore, we suggest that the influence of different exposure times is insignificant for the accuracy of the measurements. Thus, caution must be taken when interpreting the results of elements with low detectability, even when the exposure times are long and scanning counts are reasonably high.

(Table XIII-2, Page 166) Physical characteristics of manganese nodules collected in the Pacific Ocean during cruise GH77-1 of R/V Hakurei Maru

In the GH77-1 cruise, manganese nodules were obtained from 31 stations among 37 total ones. Here are reported the preliminary results of the observation mainly done on-board. Special attention was paid to confirming the applicability of the nodule type classification tentatively established in the previous GH76-1 cruise and to delineating the pattern of the nodule distribution and clarifying its relation to the geological factors, such as topography, surface sediment types, and substrate stratigraphy. In addition, a short description of the obtained rock samples from a few stations is included in this chapter.

(Table 1) Geochemistry of the ETM-2 section from IODP Hole 302-M0004A

During the early Eocene, a series of short-term global warming events ("hyperthermals") occurred in response to the rapid release of carbon into the oceans and atmosphere. In order to investigate the response of ocean redox to global warming, we have determined the molybdenum isotope compositions (d98/95Mo) of samples spanning one such hyperthermal (Eocene Thermal Maximum 2 (ETM-2, 54.1 Ma)), from Integrated Ocean Drilling Program Expedition 302 Site M0004A in the Arctic Ocean. The highest d98/95Mo in our sample set (2.00 ± 0.11 per mil) corresponds to the development of local euxinia at Site M0004A during the peak of ETM-2, which we interpret as recording the global seawater d98/95Mo at that time. The ETM-2 seawater d98/95Mo is indistinguishable from a recent estimate of seawater d98/95Mo from an earlier hyperthermal (Paleocene Eocene Thermal Maximum (PETM, 55.9 Ma), d98/95Mo = 2.08 ± 0.11 per mil). We argue that the similarity in seawater d98/95Mo during ETM-2 and the PETM was caused by the development of transient euxinia in the Arctic Ocean during each hyperthermal that allowed sediments accumulating in this basin to capture the long-term d98/95Mo of early Eocene seawater. Our new data therefore place a minimum constraint on the magnitude of transient global seafloor deoxygenation during early Eocene hyperthermals.