Mineral, chemical and isotopic compositions of altered rocks at ODP Sites 193-1188 and 193-1189

During ODP Leg 193, 4 sites were drilled in the active PACMANUS hydrothermal field on the crest of the felsic Pual Ridge to examine the vertical and lateral variations in mineralization and alteration patterns. We present new data on clay mineral assemblages, clay and whole rock chemistry and clay mineral strontium and oxygen isotopic compositions of altered rocks from a site of diffuse low-temperature venting (Snowcap, Site 1188) and a site of high-temperature venting (Roman Ruins, Site 1189) in order to investigate the water-rock reactions and associated elemental exchanges. The volcanic succession at Snowcap has been hydrothermally altered, producing five alteration zones: (1) chlorite+/-illite-cristobalite-plagioclase alteration apparently overprinted locally by pyrophyllite bleaching at temperatures of 260-310°C; (2) chlorite+/-mixed-layer clay alteration at temperatures of 230°C; (3) chlorite and illite alteration; (4) illite and chlorite+/-illite mixed-layer alteration at temperatures of 250-260°C; and (5) illite+/-chlorite alteration at 290-300°C. Felsic rocks recovered from two holes (1189A and 1189B) at Roman Ruins, although very close together, show differing alteration features. Hole 1189A is characterized by a uniform chlorite-illite alteration formed at ~250°C, overprinted by quartz veining at 350°C. In contrast, four alteration zones occur in Hole 1189B: (1) illite+/-chlorite alteration formed at ~300°C; (2) chlorite+/-illite alteration at 235°C; (3) chlorite+/-illite and mixed layer clay alteration; and (4) chlorite+/-illite alteration at 220°C. Mass balance calculations indicate that the chloritization, illitization and bleaching (silica-pyrophyllite assemblages) alteration stages are accompanied by different chemical changes relative to a calculated pristine precursor lava. The element Cr appears to have a general enrichment in the altered samples from PACMANUS. The clay concentrate data show that Cr and Cu are predominantly present in the pyrophyllites. Illite shows a significant enrichment for Cs and Cu relative to the bulk altered samples. Considerations of mineral stability allow us to place some constraints on fluid chemistry. Hydrothermal fluid pH for the chloritization and illitization was neutral to slightly acidic and relatively acidic for the pyrophyllite alteration. In general the fluids, especially from Roman Ruins and at intermediate depths below Snowcap, show only a small proportion of seawater mixing (<10%). Fluids in shallow and deep parts of the Snowcap holes, in contrast, show stronger seawater influence.

Major and rare earth element concentrations of basalts beneath ODP Hole 118-735B (Table 3)

A wide-angle seismic experiment at the Atlantis II Fracture Zone, Southwest Indian Ridge, together with geochemical analyses of dredged basalt glass samples from a site conjugate to Ocean Drilling Program hole 735B has allowed determination of the thickness and the most likely lithological composition of the crust beneath hole 735B. The measured Na, composition of 3.3 +/- 0.1 corresponds to a melt thickness of 3 +/- 1 km, a result consistent with rare earth element inversions which indicate a melt thickness of between 1.5 and 4.5 km. The seismic crustal thickness to the north and south of the Atlantis Platform (on which hole 735B is located) is 4 +/- 1 km, and probably consists largely of magmatic material since the seismic and inferred melt thicknesses agree within experimental uncertainty. Beneath hole 735B itself. the Moho is at a depth of 5 +/- 1 km beneath the seafloor. The seismic model suggests that, on average. about 1 km of upper crust has been unroofed on the Atlantis Platform. However, allowing for the inferred local unroofing of 2 km of upper crust at 735B, the base of the magmatic crust beneath this location is probably about 2 km beneath the seafloor, and is underlain by a 2-3 km thick layer of serpentinised mantle peridotite. The P-wave velocity of 6.9 km/s for the serpentinised peridotite layer corresponds to a 35 +/- 10 vol% serpentine content. The Moho beneath hole 735B probably represents a serpentinisation front.