Alkenones in the northwestern Mediterranean Sea

C37 alkenone fluxes were measured with sediment traps at 200 m depth over the years 1989/1990 and 1993/1994 to assess the interannual variability of the alkenone flux from the surface waters of the Mediterranean Sea. Fall and spring were identified as the high flux periods. SST estimates derived from the UK'37 index indicated 50 m and 30 m as major production depths in spring and fall, respectively. Althought interannual variation of alkenone fluxes was notable, the seasonality and depth of production appeared to be recurrent features of the coccolithophorid cycle of production. Alkenone fluxes at 1000 m measured over the year 1993/1994 were about 5 times lower than at 200 m and show no evidence of preferential preservation relative to the organic carbon between these depths. SST predicted at 200 m and 1000 m indicated a remarkably good transfer of the surface temperature signal to deeper layers.

Composition of Upper Quaternary bottom sediments from the Syrian area of the Mediterranean Sea

Results of a lithological study of bottom sediments in the Syrian region of the Mediterranean Sea during Cruise 27 of R/V Vityaz (1993) are reported. Suspended sediment discharge of the Nile River are of the greatest importance for terrigenous sedimentation in the SE part of the Mediterranean Sea, especially in deep-sea areas. Suspended load entering from the Syrian catchment area plays an important role in formation of recent shelf and slope deposits. Supply of aerosols from Syrian and Arabian deserts was distinguished by the patchiness of surface distribution of quartz. During Late Quaternary accumulation of terrigenous material supplied from both the Syrian and the Nile drainage areas was irregular. Sedimentation was remarkably enhanced during sapropel formation 7000-9000 years BP.

Holocene millenial-scale productivity record in the Mediterranean Sea

The calcareous nannofossil assemblages of Ocean Drilling Program Hole 963D from the central Mediterranean Sea have been investigated to document oceanographic changes in surface waters. The studied site is located in an area sensitive to large-scale atmospheric and climatic systems and to high- and low-latitude climate connection. It is characterized by a high sedimentation rate (the achieved mean sampling resolution is <70 years) that allowed the Sicily Channel environmental changes to be examined in great detail over the last 12 ka BP. We focused on the species Florisphaera profunda that lives in the lower photic zone. Its distribution pattern shows repeated abundance fluctuations of about 10-15%. Such variations could be related to different primary production levels, given that the study of the distribution of this species on the Sicily Channel seafloor demonstrates the significant correlation to productivity changes as provided by satellite imagery. Productivity variations were quantitatively estimated and were interpreted on the basis of the relocation of the nutricline within the photic zone, led by the dynamics of the summer thermocline. Productivity changes were compared with oceanographic, atmospheric, and cosmogenic nuclide proxies. The good match with Holocene master records, as with ice-rafted detritus in the subpolar North Atlantic, and the near-1500-year periodicity suggest that the Sicily Channel environment responded to worldwide climate anomalies. Enhanced Northern Hemisphere atmospheric circulation, which has been reported as one of the most important forcing mechanisms for Holocene coolings in previous Mediterranean studies, had a remarkable impact on the water column dynamics of the Sicily Channel.

A comprehensive analysis of tidal notches in the Mediterranean Sea

Recent works (Evelpidou et al., 2012) suggest that the modern tidal notch is disappearing worldwide due sea level rise over the last century. In order to assess this hypothesis, we measured modern tidal notches in several of sites along the Mediterranean coasts. We report observations on tidal notches cut along carbonate coasts from 73 sites from Italy, France, Croatia, Montenegro, Greece, Malta and Spain, plus additional observations carried outside the Mediterranean. At each site, we measured notch width and depth, and we described the characteristics of the biological rim at the base of the notch. We correlated these parameters with wave energy, tide gauge datasets and rock lithology. Our results suggest that, considering 'the development of tidal notches the consequence of midlittoral bioerosion' (as done in Evelpidou et al., 2012) is a simplification that can lead to misleading results, such as stating that notches are disappearing. Important roles in notch formation can be also played by wave action, rate of karst dissolution, salt weathering and wetting and drying cycles. Of course notch formation can be augmented and favoured also by bioerosion which can, in particular cases, be the main process of notch formation and development. Our dataset shows that notches are carved by an ensemble rather than by a single process, both today and in the past, and that it is difficult, if not impossible, to disentangle them and establish which one is prevailing. We therefore show that tidal notches are still forming, challenging the hypothesis that sea level rise has drowned them.

Abundance of mesozooplankton in the Mediterranean Sea during PELMED 1995 and PELMED 1996

The PELMED-ECOPEL dataset contains mesozooplankton data collected in 1995-1996 in the Gulf of Lion (North Western Mediterranean Sea) between 43°35' N, 2°50' E and 42°15' N, 6°15' E. Zooplankton taxonomy-related abundance per unit volume of the water column.

Faecal pellet production of copepoda collected in water depth up to 100 meters in the eastern Mediterranean Sea in March and April 2008 during SES_GR1

The SES_UNLUATA_GR1-Mesozooplankton faecal pellet production rates dataset is based on samples taken during March and April 2008 in the Northern Libyan Sea, Southern Aegean Sea and in the North-Eastern Aegean Sea. Mesozooplankton is collected by vertical tows within the 0-100 m layer or within the Black sea water body mass layer in the case of the NE Aegean, using a WP-2 200 µm net equipped with a large non-filtering cod-end (10 l). Macrozooplankton organisms are removed using a 2000 µm net. A few unsorted animals (approximately 100) are placed inside several glass beaker of 250 ml filled with GF/F or 0.2 µm Nucleopore filtered seawater and with a 100 µm net placed 1 cm above the beaker bottom. Beakers are then placed in an incubator at natural light and maintaining the in situ temperature. After 1 hour pellets are separated from animals and placed in separated flasks and preserved with formalin. Pellets and are counted and measured using an inverted microscope. Animals are scanned and counted using an image analysis system. Carbon- Specific faecal pellet production is calculated from a) faecal pellet production, b) individual carbon: Animals are scanned and their body area is measured using an image analysis system. Body volume is then calculated as an ellipsoid using the major and minor axis of an ellipse of same area as the body. Individual carbon is calculated from a carbon- total body volume of organisms (relationship obtained for the Mediterranean Sea by Alcaraz et al. (2003) divided by the total number of individuals scanned and c) faecal pellet carbon: Faecal pellet length and width is measured using an inverted microscope. Faecal pellet volume is calculated from length and width assuming cylindrical shape. Conversion of faecal pellet volume to carbon is done using values obtained in the Mediterranean from: a) faecal pellet density 1,29 g cm**3 (or pg µm**3) from Komar et al. (1981); b) faecal pellet DW/WW=0,23 from Elder and Fowler (1977) and c) faecal pellet C%DW=25,5 Marty et al. (1994).

Faecal pellet production of copepoda collected at different water depth in the eastern Mediterranean Sea during SES_GR2

The SES_GR2-Mesozooplankton faecal pellet production rates dataset is based on samples taken during August and September 2008 in the Northern Libyan Sea, Southern Aegean Sea and the North-Eastern Aegean Sea. Mesozooplankton is collected by vertical tows within the 0-100 m layer or within the Black sea water body mass layer in the case of the NE Aegean, using a WP-2 200 µm net equipped with a large non-filtering cod-end (10 l). Macrozooplankton organisms are removed using a 2000 µm net. A few unsorted animals (approximately 100) are placed inside several glass beaker of 250 ml filled with GF/F or 0.2 µm Nucleopore filtered seawater and with a 100 µm net placed 1 cm above the beaker bottom. Beakers are then placed in an incubator at natural light and maintaining the in situ temperature. After 1 hour pellets are separated from animals and placed in separated flasks and preserved with formalin. Pellets are counted and measured using an inverted microscope. Animals are scanned and counted using an image analysis system. Carbon- Specific faecal pellet production is calculated from a) faecal pellet production, b) individual carbon: Animals are scanned and their body area is measured using an image analysis system. Body volume is then calculated as an ellipsoid using the major and minor axis of an ellipse of same area as the body. Individual carbon is calculated from a carbon- total body volume of organisms (relationship obtained for the Mediterranean Sea by Alcaraz et al. (2003) divided by the total number of individuals scanned and c) faecal pellet carbon: Faecal pellet length and width is measured using an inverted microscope. Faecal pellet volume is calculated from length and width assuming cylindrical shape. Conversion of faecal pellet volume to carbon is done using values obtained in the Mediterranean from: a) faecal pellet density 1,29 g cm**3 (or pg µm**3) from Komar et al. (1981); b) faecal pellet DW/WW=0,23 from Elder and Fowler (1977) and c) faecal pellet C%DW=25,5 Marty et al. (1994).

Sapropels in the Mediterranean Sea

Eastern Mediterranean sediments are characterized by cyclic deposition of organic-rich sediments known as sapropels. Enhanced primary productivity combined with bottom water oxygen depletion are thought to be the main drivers for sapropel deposition. We selected sapropel layers from a suite of ODP-Leg 160 cores, and applied a set of geochemical proxies to determine paleo-productivity variations, redox conditions of the water column during deposition, and provenance of detrital material. High sedimentary Ba/Al and Corg contents indicate enhanced primary production, whereas the sedimentary La/Lu ratio, points to an enhanced contribution from a North African riverine source, during sapropel formation. These features are especially pronounced on Sapropels S5 and S7, deposited during a particularly warm climatic interval. This indicates a more intense North African drainage/weathering and consequently run-off for those sapropels that have the most enhanced expression of productivity too. Correspondingly, the latter has also resulted in bottom water redox conditions that have been more severe during these sapropels than during others. Deepwater formation from Adriatic and Aegean areas, thought to be mainly controlled by sustained cooling of preconditioned surface waters, triggers the onset of bottomwater ventilation, thus sapropel duration. Our data, therefore, suggest that the intensity of sapropel formation is determined by the North African monsoonal system, whereas their duration is directed by northern borderlands climatic conditions.

Faecal pellet production of copepoda collected in water depth up to 20 meters in the eastern Mediterranean Sea in March and April 2008 during SES_GR1

The SES_GR1-Mesozooplankton faecal pellet production rates dataset is based on samples taken during April 2008 in the North-Eastern Aegean Sea. Mesozooplankton is collected by vertical tows within the Black sea water body mass layer in the NE Aegean, using a WP-2 200 µm net equipped with a large non-filtering cod-end (10 l). Macrozooplankton organisms are removed using a 2000 µm net. A few unsorted animals (approximately 100) are placed inside several glass beaker of 250 ml filled with GF/F or 0.2 µm Nucleopore filtered seawater and with a 100 µm net placed 1 cm above the beaker bottom. Beakers are then placed in an incubator at natural light and maintaining the in situ temperature. After 1 hour pellets are separated from animals and placed in separated flasks and preserved with formalin. Pellets are counted and measured using an inverted microscope. Animals are scanned and counted using an image analysis system. Carbon- Specific faecal pellet production is calculated from a) faecal pellet production, b) individual carbon: Animals are scanned and their body area is measured using an image analysis system. Body volume is then calculated as an ellipsoid using the major and minor axis of an ellipse of same area as the body. Individual carbon is calculated from a carbon- total body volume of organisms (relationship obtained for the Mediterranean Sea by Alcaraz et al. (2003) divided by the total number of individuals scanned and c) faecal pellet carbon: Faecal pellet length and width is measured using an inverted microscope. Faecal pellet volume is calculated from length and width assuming cylindrical shape. Conversion of faecal pellet volume to carbon is done using values obtained in the Mediterranean from: a) faecal pellet density 1,29 g cm**3 (or pg µm**3) from Komar et al. (1981); b) faecal pellet DW/WW=0,23 from Elder and Fowler (1977) and c) faecal pellet C%DW=25,5 Marty et al. (1994).

Hydrography and water chemistry of the open Mediterranean Sea

On a cruise from the eastern into western Mediterranean Sea in November/December 1978 a total of 126 samples were collected from 8 vertical profiles and 7 coastal stations for trace metal analysis. The sampling, processing and analysis was performed under strict "clean room" conditions. The concentration of the open-sea samples are close to oceanic results gathered under similar conditions. The grand averages from all profiles (± st. dev. of the individual samples) of 0.40 ± 0.16 µg/l Zn, 17.4 ± 7.4 ng/l Cd, 0.21 ± 0.07 µg/l Cu, 0.21 ± 0.13 µg/l Mn and 0.25 ± 0.09 µg/l Fe indicate that a "metal problem" does not exist in the open Mediterranean. A biologically mediated deplition in surface waters or correlation with nutrients have not been observed under the conditions established on this cruise. This is probably due top low primary production and seasonal advection processes prevailing in this sea. The data for manganese show generally higher values in the surface layer (0-75 m) than in deep waters. This could evidently proved in the nearshore profile indicating a terrigenous source for manganese.

Physical oceanography of the GOIN project in the Mediterranean Sea (1987-1990)

This set provides 1779 CTD profiles of temperature and salinity measured with a russian "Zond-Bathometer" by the research vessels Yakov Gakkel and Vladimir Parshin, of the former Soviet Union, during 1987-1990. It is dedicated to the memory of Professor Ivan Ovchinnikov (1931-07-14 to 2000-06-10) who initiated the soviet program of research of the Mediterranean Sea and contributed significantly to the investigation of physical processes in the Mediterranean Sea.