Physical oceanography during POLARSTERN cruise ANT-V/3

The work carried out by the physical oceanography group on POLARSTERN Leg ANT-V/3 concentrated on four major topics: A. A large scale survey of the eastern boundary between the Weddell gyre and the open ocean. On the way to the coastal polynya in early October 12 CTD stations were carried out between 54°30'S, 6°E and 70°30'S 8°W. Another set of 16 stations was obtained in early December on the way back north. During this transsect three current meter moorings were recovered at Maud Rise. The path between the current meter arrays was used to run an additional section to the NNE across the top of Maud Rise. B. A large scale survey of the Antarctic Coastal Current along the eastern shelf area. To obtain the water mass characteristics along the eastern Weddell shelf 36 CTD stations were carried out between Atka Bay and the Filchner Trench. Most of the stations were located on the shelf. Cross shelf sections were obtained both near Drescher Inlet and off Halley Bay, in the divergence area of the Coastal Current where the continental slope turns to the west and south of Vestkapp at Neptune's Point. A longshore section over 120 km was run north of Vestkapp. C. A mesoscale survey of the Antarctic Coastal Current off Drescher Inlet. The experimental work consisted of 37 CTD-stations and direct current measurements. The CTD-profiles were grouped into seven sections perpendicular to the coast line off Drescher Inlet extending once over 70 km but normally over 35 km. The profile depth ranged from 300 m on one section to the complete water column at two sections. Most sections consist of five stations providing highest resolution over the upper continental slope with offshore increasing spacing. The stations were chosen to represent the shelf (450 m), the shelf break (800 m), the upper slope (1600 m), the lower slope (2400 m) and the transition to the abyssal plain (3400 m). Rough topography and difficult ice conditions made it impossible to meet those requirements in all cases. D. A small scale survey of the hydrographic conditions under the sea ice. The motivation for these studies arose during the cruise. Consequently a suitable Instrumentation had to be developed at sea. This was done with a NB-Smart CTD which was inserted on an L-shaped lever through a hole in the ice. However, various water intrusions into the instrument resulted in the failure of this technique. In consequence a special lever system was built to position a NB Mark 3b weighing about 40 kg below the ice. Twenty four profiles were obtained reaching from the bottom of the ice down to 2 m below the ice surface with a maximum distance of 1 m from the entry hole. As the conductivity sensor was influenced by nearby ice platelets, salinity samples where drawn to check the sensor.

(Table 2, page 2172) Chemical analytical data on thirty-two manganese nodules and crusts

Mn, Fe, Ca, Co, Ni, Cu, Zn, Cd, Sn, Tl, Pb and Bi have been estimated in thirty-two nodules from the Pacific, Atlantic and Indian oceans. Various features about the composition of manganese nodules are discussed: element abundances, degrees of enrichment, inter-element relationships (notably between Ni and Cu, and between Zn and Cd), regional variations and some aspects of statistical distribution.

Undergrowth removal in Salgesch: Soil volumetric water content and temperature time series, hourly time resolution, 2010-2015

In the Salgesch forest in the Canton of Valais in Switzerland, the understory has been removed to test whether effects on pine tree vitality. The data set published here compromises 120 time series of 60 soil temperature and 60 volumetric water content (VWC) sensors (EC-TM and 5-TM) (Decagon Devices, WA, USA) at three soil depth levels (5, 30, 60 cm) employed in the direct vicinity of six control trees and six trees with the undergrowth removed. At the levels 5 and 60 cm, three replications were made whereas 4 replications were made at level 30 cm. Six loggers recorded hourly data since 2010 with 18% gaps or 11% when not considering winter months December, January and February. The figure attached to this repository shows the average VWC and temperature of all measurements within the same depth and treatment specific setting aggregated in a defined time interval and period. In addition to that, the standard deviations are plotted as transparent polygons. In case of insufficient values for calculating standard deviations, the setting specific mean standard deviation of the considered time period are inserted.