87Sr/86Sr ratios, Sr and Rb concentrations and stable oxygen isotope values for some basalts from ODP Hole 504B (Table 1)

Seventeen whole-rock samples, generally taken at 25-50 m intervals from 5 to 560 m sub-basement in Hole 504B, drilled in 6.2 m.y. old crust, were analysed for 87Sr/86Sr ratios, Sr and Rb concentrations, and 18O/16O ratios. Sr isotope ratios for 8 samples from the upper 260 m of the hole range from 0.70287 to 0.70377, with a mean of 0.70320. In the 330-560 m interval, 5 samples have a restricted range of 0.70255-0.70279, with a mean of 0.70266, the average value for fresh mid-ocean ridge basalts (MORB). In the 260-330 m interval, approximately intermediate Sr isotopic ratios are found. Delta18O values (?) range from 6.4 to 7.8 in the upper 260 m, 6.2-6.4 in the 270-320 m interval, and 5.8-6.2 in the 320-560 m interval. The values in the upper 260 m are typical for basalts which have undergone low-temperature seawater alteration, whereas the values for the 320-560 m interval correspond to MORB which have experienced essentially no oxygen isotopic alteration. The higher 87Sr/86Sr and 18O/16O ratios in the upper part of the hole can be interpreted as the result of a greater overall water/rock ratio in the upper part of the Hole 504B crust than in the lower part. Interaction of basalt with seawater (87Sr/86Sr = 0.7091) increased basalt 87Sr/86Sr ratios and produced smectitic alteration products which raised whole-rock delta18O values. Seawater circulation in the lower basalts may have been partly restricted by the greater number of relatively impermeable massive lava flows below about 230 m sub-basement. These flows may have helped to seal off lower basalts from through-flowing seawater.

(Table 1) Age of Cretaceous seamounts in the Western Pacific

Dynamics of the Pacific Plate is recorded in the systematic variation of location and the 40Ar-39Ar age of seamounts in the Western Pacific from 120 to 65 Ma ago. The seamounts are grouped into three linear zones as long as 5000 km. The seamounts become younger in the southeastern direction along the strike of these zones. Correlation between age and location of seamounts allows to divide the history of their formation into three stages. Rate of seamount growth was relatively low (2-4 cm/yr) during the first and the third stages within intervals of 120-90 and 85-65 Ma, whereas during the second stage (90-85 Ma), the seamounts were growing very fast (80-100 cm/yr). In the midst of this stage, at ~87 Ma ago, magmatic activity increased abruptly. Dynamics of seamount building is in good agreement with (1) pulses in development of the Ontong Java, Manihiki, and Caribbean-Colombian oceanic plateaus; (2) age of spreading acceleration in the mid-Cretaceous; and (3) a short period when the Izanagi Plate ceased to exist and the Kula Plate was formed. Variation in seamounts' age and location are in consistence with the hypothesis of diffuse extension of the Pacific Plate in course of its motion with formation of impaired zones of decompression melting. Direction of extension (325°-340° NW) calculated from the strike of seamount zones is consistent with the path of the Pacific Plate (330° NW) in the Late Cretaceous. Immense perioceanic volcanic belts were formed at that time along the margin of the Asian continent. The Okhotsk-Chukchi Peninsula Belt extends at a right angle to the compression vector. Three stages of this belt's evolution are synchronous with the stages of seamount formation in the Pacific Plate. Delay in origination of the East Sikhote-Alin Volcanic Belt and its different orientation were caused by counterclockwise rotation of the vector of convergence of oceanic and continental plates in the mid-Cretaceous. At the same time, i.e. 95-85 Ma ago, volcanic activity embraced the entire continental margin and tin granites were emplaced everywhere in the Eastern Asia. This short episode (90+/-5 Ma) corresponds to the mid-Cretaceous maximum of compression of the continental margin, and its age fits well a culmination in extension of the Pacific Plate.

(Table 1) Two-way travel times and depths of picked internal reflection horizons (IRHs) of the NGRIP ice core

During the summer of 2003, a ground-penetrating radar survey around the North Greenland Icecore Project (NorthGRIP) deep ice-core drilling site (75°06' N, 42°20' W; 2957 m a.s.l.) was carried out using a shielded 250 MHz radar system. The drill site is located on an ice divide, roughly 300 km north-northwest of the summit of the Greenland ice sheet. More than 430 km of profiles were measured, covering a 10 km by 10 km area, with a grid centered on the drilling location, and eight profiles extending beyond this grid. Seven internal horizons within the upper 120 m of the ice sheet were continuously tracked, containing the last 400 years of accumulation history. Based on the age-depth and density-depth distribution of the deep core, the internal layers have been dated and the regional and temporal distribution of accumulation rate in the vicinity of NorthGRIP has been derived. The distribution of accumulation shows a relatively smoothly increasing trend from east to west from 145 kg/m**2/a to 200 kg/m**2/a over a distance of 50 km across the ice divide. The general trend is overlain by small-scale variations on the order of 2.5 kg/m**2/a/km, i.e. around 1.5% of the accumulation mean. The temporal variations of the seven periods defined by the seven tracked isochrones are on the order of +-4% of the mean of the last 400 years, i.e. at NorthGRIP ±7 kg/m**2/a. If the regional accumulation pattern has been stable for the last several thousand years during the Holocene, and ice flow has been comparable to today, advective effects along the particle trajectory upstream of NorthGRIP do not have a significant effect on the interpretation of climatically induced changes in accumulation rates derived from the deep ice core over the last 10 kyr.

Major oxides for tektites and for conglomerate clast of the Upper Eocene ejecta-bearing layer of ODP Hole 150-904A (Table 1)

Evidence for the Chesapeake Bay Crater as the source for New Jersey continental margin ejecta is provided by fine-grained tektites and coarse-grained unmelted ejecta. The Upper Eocene ejecta deposit, now demonstrated to be part of the North American strewn field, occurs on the New Jersey continental margin at Ocean Drilling Program (ODP) Sites 904 and 903. The mineralogy, major oxide composition of the ejecta materials, and biostratigraphic age of the enclosing sediments link the origin of these ejecta to the recently recognized Chesapeake Bay impact crater, located only 330 km away. Sediments associated with the ejecta provide information about the dynamics of impact events. The 35-cm-thick ejecta-bearing layer can be subdivided into three subunits that indicate a sequence of events. Bottom subunit III documents sediment failure and deposition of gravel-sized fragments, middle subunit II records deposition of abundant sand-sized ejecta by gravity settling, and upper subunit I contains a 12-cm-thick sedimentary deposit containing rare silt-sized tektites and evidence of waning currents. These events are interpreted by linking sediment deposition to seismic ground motion and subsequent tsunami waves triggered by both the Chesapeake Bay impact and slope failures.

Spores and pollen at DSDP Holes 36-330 and 71-511

Samples from Upper Jurassic and Lower Cretaceous sediments at Site 511 were analyzed for palynomorphs. Three palynological assemblages were identified: Upper Jurassic (presumably Tithonian), Neocomian-Aptian, and lower Albian. These were correlated to synchronous assemblages in Argentina, South Africa, and Australia and were compared with Jurassic palynoassemblages from Hole 330, Leg 36.