Geochemistry of silicate melt inclusions from ODP Holes 137-504B and 140-504B

Geochemical data from plagioclase-hosted silicate melt inclusions from Leg 140, Hole 504B diabase dikes are reported. Hand-picked plagioclase grains were heated to 1260°-1280°C to remelt the glass inclusions and to infer trapping temperatures. The samples were then polished to expose the inclusions, which were analyzed by electron and ion microprobes. Inclusion compositions are mainly in equilibrium with the host plagioclase and are more depleted in incompatible elements than the host rock. Simple crystal-liquid equilibrium calculations show that the melt inclusions could have been in equilibrium with depleted abyssal peridotite diopsides, whereas whole-rock basalt compositions generally could not have been. The melt inclusions are significantly more depleted than normal (N-type) mid-ocean-ridge basalt (MORB) and are consistent with being produced by 8%-16% incremental or open-system melting with 2% residual porosity in the peridotite source. These magmas were formed during pressure-release melting of the mantle over a range of depths between 30 and 15 km.

Geochemistry of lower sheeted dike complex samples of ODP Holes 137-504B and 140-504B

Rocks of the lower sheeted dike complex of Hole 504B sampled during Leg 140 were analyzed for major and trace element compositions to investigate the effects of igneous processes and hydrothermal alteration on the compositions of the rocks. The rocks are relatively uniform in composition and similar to the shallower dikes. They are moderately evolved mid-ocean-ridge basalts (MORB) with relatively high MgO (7.9-10 wt%) and Mg# (0.60-0.70), and have unusually low incompatible element contents (TiO2 = 0.42-1.1 wt%, Zr = 23-62 ppm). Discrete compositional intervals in the hole reflect varying degrees of differentiation, and olivine and plagioclase accumulation in the rocks, and may be related to injection of packets of dikes having similar compositions. Systematic depletions of total REE, Zr, Y, TiO2, and P2O5 in centimeter-size patches are most likely attributed to exclusion of highly differentiated, late-stage interstitial liquids from small portions of the rocks. The rocks exhibit increased H2O+ reflecting hydrothermal alteration. Replacement of primary plagioclase by albite and oligoclase led to local gains of Na2O, losses of CaO, and slightly positive Eu anomalies. Some mobility of P2O5 led to minor increases and decreases in P2O5 contents, and some local mobility of Ti may have occurred during alteration of titanomagnetite to titanite. Higher temperatures of alteration in the lower sheeted dikes led to breakdown of pyroxene and sulfide minerals and losses of Zn, Cu, and S to hydrothermal fluids. Later addition of anhydrite to the rocks in microfractures and replacing plagioclase caused local increases in sulfur contents. The lower sheeted dikes are a major source of metals to hydrothermal fluids for the formation of metal sulfide deposits on and within the seafloor.

(Table 3) Geochemistry of borehole fluids of ODP Hole 137-504B

Circulation of seawater through basaltic basement for several million years after crustal emplacement has been inferred from studies of surface heat flow, and may play a significant role in the exchange of elements between the oceanic crust and seawater. Without direct observation of the fluid chemistry, interpretations regarding the extent and timing of this exchange must be based on the integrated signal of alteration found in sampled basalts. Much interest has thus been expressed in obtaining and analyzing fluids directly from basaltic formations. It has been proposed that open oceanic boreholes can be used as oceanic groundwater wells to obtain fluids that are circulating within the formation. Water samples were collected from the open borehole in Hole 504B prior to drilling operations on Leg 137, with the original intention of collecting formation fluids from the surrounding basaltic rocks. Past results have yielded ambiguous conclusions as to the origin of the fluids recovered-specifically, whether or not the fluids were true formation fluids or merely the result of reaction of seawater in the borehole environment. The chemistry of eight borehole fluid samples collected during Leg 137 is discussed in this paper. Large changes in major, minor, and isotopic compositions relative to unaltered seawater were observed in the borehole fluids. Compositional changes increased with depth in the borehole. The samples exhibit the effect of simple mixing of seawater, throughout the borehole, with a single reacted fluid component. Analysis and interpretation of the results from Leg 137 in light of past results suggest that the chemical signals observed may originate predominantly from reaction with basaltic rubble residing at the bottom of the hole during the interim between drilling legs. Although this endeavor apparently did not recover formation waters, information on the nature of reaction between seawater and basalt at the prevalent temperatures in Hole 504B (>160°C) has been gained that can be related to reconstruction of the alteration history of the oceanic crust. Isotopic analyses allow calculation of element-specific water/rock mass ratios (Li and Sr) and are related to the extent of chemical exchange between the borehole fluids and basalt.

Strontium chemistry of anhydrite from DSDP/ODP Hole 504B

A unique record of the chemical evolution of seawater during hydrothermal recharge into oceanic crust is preserved by anhydrite from the volcanic sequences and sheeted dike complex in ODP Hole 504B. Chemical and isotopic analyses 87Sr/86Sr, delta18O, delta34S of anhydrite constrain the changing composition of fluids due to reaction with basalt. There is a general trend of decreasing 87Sr/86Sr of anhydrite, corresponding to the minor incorporation of basaltic strontium with depth in the volcanic rocks. 87Sr/86Sr ratios decrease rapidly with depth in the dikes to values identical to host basalt (0.7029). Sr/Ca ratios (<0.1 mmol/mol) suggest that recharge fluids have very low Sr concentrations and fluids evolve by first precipitating Sr-bearing phases before extensive exchange of Sr with the host basalt. There is a background trend of decreasing sulfate delta18O with depth from +12-13? in the lower volcanics to +7? in the lower sheeted dikes recording an increase in recharge fluid temperature from c. 150° to c. 250°C, and confirming the presence of sulfate in hydrothermal fluids at elevated temperatures. From the amount of anhydrite recovered from Hole 504B and the amount of seawater sulfur that has been reduced to sulfide, a minimum seawater recharge flux can be calculated. This value is 4-25 times lower than estimates of high-temperature fluid fluxes based on either thermal constraints or global chemical budgets and suggests that there is significant deficit of seawater-derived sulfur in the oceanic crust. Only a minor proportion of the seawater that percolates into the crust near the axis is heated to high temperatures and exits as black smoker-type fluids. A significant proportion of the axial heat loss must be advected at 200-250°C by sulfate-bearing hydrothermal solutions that egress diffusely from the crust. These fluids penetrate into the dikes and exchange both heat and chemical tracers without the extensive clogging of porosity by anhydrite precipitation, which would halt hydrothermal circulation for any reasonable fluid flux. The heating of the major proportion of hydrothermal fluids to only moderate temperatures (c. 250°C) reconciles estimates of hydrothermal fluxes derived from thermal models and global geochemical budgets. The flux of hydrothermal sulfate would be of a magnitude similar to the riverine input, and oxygen-isotopic exchange at 200-250°C between dissolved sulfate and recharge fluids during hydrothermal circulation provides a mechanism to continuously buffer seawater sulfate oxygen to the light isotopic composition observed.

(Table 1) Strontium concentrations and isotope ratios of anhydrite from DSDP/ODP Hole 504B

In samples from 1575 to 1982 mbsf anhydrite leached from whole-rock powders. 87Sr/86Sr and Sr/Ca determined following methods described in (Teagle et al., 1996, doi:10.2973/odp.proc.sr.148.113.1996, Teagle et al., 1998, doi:10.2973/odp.proc.sr.158.223.1998). For the period of the analysis (Jan. 1994-Dec. 1995) NIST SRM 987 gave 87Sr/86Srs0.710244 +/- 0.000018 (2 sigma, n = 115). Full analytical procedural blanks were <50 pg for Sr. delta18O following (Pickthorn and O´Neil, 1985). Repeated extractions and measurements of samples and standards were reproducible within +/- 0.5.

Geochemistry of the oceanic crust from ocean drilling samples

This book presents new data on chemical and mineral compositions and on density of altered and fresh igneous rocks from key DSDP and ODP holes drilled on the following main tectonomagmatic structures of the ocean floor: 1. Mid-ocean ridges and abyssal plains and basins (DSDP Legs 37, 61, 63, 64, 65, 69, 70, 83, and 91 and ODP Legs 106, 111, 123, 129, 137, 139, 140, 148, and 169); 2. Seamounts and guyots (DSDP Legs 19, 55, and 62 and ODP Legs 143 and 144); 3. Intraplate rises (DSDP Legs 26, 33, 51, 52, 53, 72, and 74 and ODP Legs 104, 115, 120, 121, and 183); and 4. Marginal seas (DSDP Legs 19, 59, and 60 and ODP Legs 124, 125, 126, 127, 128, and 135). Study results of altered gabbro from the Southwest Indian Ridge (ODP Leg 118) and serpentinized ultramafic rocks from the Galicia margin (ODP Leg 103) are also presented. Samples were collected by the authors from the DSDP/ODP repositories, as well as during some Glomar Challenger and JOIDES Resolution legs. The book also includes descriptions of thin sections, geochemical diagrams, data on secondary mineral assemblages, and recalculated results of chemical analyses with corrections for rock density. Atomic content of each element can be quantified in grams per standard volume (g/1000 cm**3). The suite of results can be used to estimate mass balance, but parts of the data need additional work, which depends on locating fresh analogs of altered rocks studied here. Results of quantitative estimation of element mobility in recovered sections of the upper oceanic crust as a whole are shown for certain cases: Hole 504B (Costa Rica Rift) and Holes 856H, 857C, and 857D (Middle Valley, Juan de Fuca Ridge).

(Table 2) Chlorine geochemistry and mineralogy of altered oceanic crust samples

Bulk chlorine concentrations and chlorine stable isotope compositions were determined for hydrothermally altered basalt (extrusive lavas and sheeted dikes) and gabbro samples (n = 50) from seven DSDP/ODP/IODP drill sites. These altered oceanic crust (AOC) samples span a range of crustal ages, tectonic settings, alteration type, and crustal depth. Bulk chlorine concentrations range from < 0.01 wt.% to 0.09 wt.%. In general, higher chlorine concentrations coincide with an increase in temperature of alteration and amphibole content. d37Cl values of whole rock AOC samples range from -1.4 to +1.8 per mil. High d37Cl values (>=~0.5 per mil) are associated with areas of higher amphibole content. This observation is consistent with theoretical calculations that estimate amphibole should be enriched in 37Cl compared to co-existing fluid. Negative to near zero d37Cl values are found in areas dominated by clay minerals. Chlorine geochemistry is a rough indicator of metamorphic grade and mineralogy. AOC is a major Cl host in the subducting oceanic lithospheric slab. Here we show that bulk chlorine concentrations are ~3 times higher than previous estimates resulting in a greater contribution of Cl to the mantle.

Distribution of Au and Pd in basalts and diabases in DSDP/ODP Hole 504B

Au contents have been determined in 77 samples of basalts and sheeted diabase dikes. Pd has been evaluated in 39 of the samples. The mean amount of Au is 3 parts per billion (ppb), fluctuating from 0.4 to 10 ppb. Au contents appear to be independent in type and intensity of alteration as well as with depth sub-bottom, although in the lower part of Hole 504B, 1900-2000 mbsf, Au contents are markedly decreased (mean: 1.1 ppb) and show a distinct correlation with a decrease in Zn contents. Pd contents vary from 2 to 360 ppb (mean: 37 ppb) Pd is higher in basalts (53.7 ppb) and lower in diabase dikes (30 ppb), especially in moderately or strongly altered ones (12.5 ppb).