(Table 1) Pore-water composition of ODP Leg 126 sites

The Ocean Drilling Program Leg 126 sites may be classified into two categories depending on the presence (Group I: Sites 787, 792, and 793) or absence (Group II: Sites 788, 790, and 791) of steep concentration gradients. Shipboard X-ray diffraction analyses of bulk sediments from Group I sites revealed the presence of a number of diagenetic minerals (some of which are incompatible), but no systematic diagenetic zonation. The results of the chemical analyses of the pore waters from Group I have been used to estimate the activities of dissolved species. Thermodynamic analyses of the composition of the pore waters and the stability of authigenic minerals (gypsum, zeolites, feldspars, smectites, chlorites, and micas) show that the pore waters are close to equilibrium with most of the observed phases. Thus, only a small perturbation of the system (substitution in minerals and fluctuations in pore-water composition, in particular, in pH and SiO2 activity) will cause any of these phases to precipitate. Therefore, one would not expect mineralogical observations to show systematic vertical zonations at these sites. It is suggested that chlorites and high-temperature zeolites are not diagenetic sensu stricto, but were eroded from volcaniclastic highs. The absence of concentration gradients at the Group II sites has been analyzed in terms of reaction kinetics, hydrothermal advection, and temperature distribution. The absence of diagenetic imprints on the pore-water concentration profiles at these sites is probably caused by the slow nucleation of silica phases.

Geochemistry of the oceanic crust from ocean drilling samples

This book presents new data on chemical and mineral compositions and on density of altered and fresh igneous rocks from key DSDP and ODP holes drilled on the following main tectonomagmatic structures of the ocean floor: 1. Mid-ocean ridges and abyssal plains and basins (DSDP Legs 37, 61, 63, 64, 65, 69, 70, 83, and 91 and ODP Legs 106, 111, 123, 129, 137, 139, 140, 148, and 169); 2. Seamounts and guyots (DSDP Legs 19, 55, and 62 and ODP Legs 143 and 144); 3. Intraplate rises (DSDP Legs 26, 33, 51, 52, 53, 72, and 74 and ODP Legs 104, 115, 120, 121, and 183); and 4. Marginal seas (DSDP Legs 19, 59, and 60 and ODP Legs 124, 125, 126, 127, 128, and 135). Study results of altered gabbro from the Southwest Indian Ridge (ODP Leg 118) and serpentinized ultramafic rocks from the Galicia margin (ODP Leg 103) are also presented. Samples were collected by the authors from the DSDP/ODP repositories, as well as during some Glomar Challenger and JOIDES Resolution legs. The book also includes descriptions of thin sections, geochemical diagrams, data on secondary mineral assemblages, and recalculated results of chemical analyses with corrections for rock density. Atomic content of each element can be quantified in grams per standard volume (g/1000 cm**3). The suite of results can be used to estimate mass balance, but parts of the data need additional work, which depends on locating fresh analogs of altered rocks studied here. Results of quantitative estimation of element mobility in recovered sections of the upper oceanic crust as a whole are shown for certain cases: Hole 504B (Costa Rica Rift) and Holes 856H, 857C, and 857D (Middle Valley, Juan de Fuca Ridge).

Geochemistry of oceanic arc basement rocks of Sumisu Rift and Ohmachi Seamount

Prehnite-pumpellyite facies metamorphism is described in the oceanic-arc basement rocks of Ocean Drilling Program Leg 126, Site 791 in the Sumisu Rift, western Pacific. Chemical variations of pumpellyite, epidote, chlorite, and prehnite are examined and paragenetic relations discussed. The metamorphism took place during the pre-rifting stage of an intraoceanic arc. During the backarc rifting stage, the geothermal gradient of the area was not as high as that of a spreading mid-oceanic ridge.

Geochemistry of Pliocene-Pleistocene volcanic rocks from the Izu Arc

The igneous geochemistry of lavas and breccias from the basement of Sites 790 and 791, and pumice clasts from the Pliocene-Pleistocene sedimentary section of Sites 788, 790, 791, and 793 were studied. Arc volcanism became silicic about 1.5 m.y. before the inception of rifting in the Sumisu Rift at 2 Ma, but eruption of these silicic magmas reflects changes in stress regime, especially during the last 130,000 yr, rather than crustal anatexis. Arc magmas have had a larger proportion of slab-derived components since the inception of rifting than before, but are otherwise similar. Rift basalts and rhyolites are derived from a different source than are arc andesites to rhyolites. The rift source has less slab-derived material and is an E-MORB-like source, in contrast to an N-MORB-type source overprinted with more slab-derived material beneath the arc. Rift magma types, in the form of rare pumice and lithic clasts, preceded the rift, and the earliest magmas that erupted in the rift already differed from those of the arc. The earliest large rift eruption produced an exotic explosion breccia ("mousse") despite eruption at >1800 mbsl. Although this rock type is attributed primarily to high magmatic water content, the clasts are more MORB-like in trace element and isotopic composition than are modern Mariana Trough basalts. After rifting began, arc volcanism continued to be predominantly silicic, with individual pumice deposits containing clasts that vary in composition by about 5 wt% SiO2, or about as much as in historical eruptions of submarine Izu Arc volcanoes. The overall variations in magma composition with time during the inception of arc rifting are broadly similar in the Sumisu Rift and Lau Basin, though newly tapped OIB-type mantle seems to be present earlier during basin formation in the Sumisu than Lau case.