Oceanographic data in the Greenland Sea and around Svalbard in 1991-1993

The Arctic Ocean is connected with the North Atlantic Ocean by the Fram Strait between Greenland and Svalbard. The strait is located in the northern part of the Greenland Sea. In the eastern part of the strait, warm saline water flows northward as the West Spitsbergen Current; while in the western part, cold less-saline water flows southward as the East Greenland Current. The northwestern part of the Greenland Sea is normally covered with sea ice even in summer. Furthermore, this region is regarded as a major area where the Arctic sea ice is discharged into mid latitude oceans. Thus, this area plays an important role in heat and salt exchange processes in the Arctic marine system. The reveal exchange processes of water masses and ocean-atmosphere interaction in high-latitude oceans, a number of international research programs have been focused on the Greenland Sea and its surrounding waters. As one of the international Arctic research programs, oceanographic studies have been executed in cooperation with the Norsk Polarinstitutt and other institutes under the leadership of the National Institute of Polar Research since 1991. Japanese scientists have been carrying out field observations in and around Svalbard. The observations include not only physical measurements but also biological surveys. This report presents physical oceanographic data obtained in the Greenland Sea in 1992 and 1993, and data around Svalbard from 1991 to 1993.

Heat flow measurements in the Weddell Sea

From January to March 1987, heat flow measurements were tried at four sites (Sites 689, 690, 695, and 696) during ODP Leg 113, in the Weddell Sea, Antarctica. At Site 690 (Maud Rise), a convex upward shaped temperature vs. depth profile was observed. This profile cannot be explained by steady-state conduction through solid materials only. We conclude that the minimum heat flow value at Site 690 is 45 mW/m2. A prominent bottom simulating reflector (BSR) was observed at 600 mbsf at Site 695. However, the observed temperature is too high to explain the BSR as a gas hydrate. The origin of the BSR remains unknown, although it is probably of biogenic origin as observed in the Bering Sea during DSDP Leg 19. After correcting for the effects of sedimentation, heat flow values at Sites 695 and 696 are 69 and 63 mW/m2, respectively. Furthermore, we compiled heat flow data south of 50°S. In the Weddell Sea region, the eastern part shows relatively low heat flow in comparison with the western part, with the boundary between them at about 15°W longitude.

Abundance of mesozooplankton in the Mediterranean Sea in August and September 2008 during SES_GR2

The SES_GR2_Mesozooplankton dataset is based on samples taken during August-September 2008 in Ionian Sea, Libyan Sea, Southern Aegean Sea and Northern Aegean Sea. Sampling volume was estimated by the net mouth surface and the towing distance for WP-2. The sample was split on board in two halves by using the beaker approach. The first sub-sample was immediately fixed and preserved in a seawater formalin solution containing about 4% buffered formaldehyde to allow the determination of species composition abundance. Pipette for the subsamples used in the taxonomic analysis of zooplankton under binocular microscope.

Abundance of mesozooplankton in the Marmara Sea collected during the Bilim 2 cruise in April 2008

The Sesame dataset contains mesozooplankton data collected during April 2008 in the Marmara Sea (between 40°15' - 34°00N latitude and 19°00 - 23°10'E longitude). Sampling was always performed in day hours (07:00-18:00 local time). Samples were taken at 6 stations in the Marmara Sea. Mesozooplankton samples were collected by using a WP-2 closing net with 200 µm mesh size. Sample was immediately fixed and preserved in a formaldehyde-seawater solution (4% final concentration) to be successively analyzed in the laboratory for species composition, abundance and total biomass. The algal organisms materials were then seperated from the mesozooplankton subsample at the dissecting microscope in the laboratory because of the contamination of the net samples with large-sized algae and mucilaginous organic matters. Afterwards, each samples were filtered on GF/C (pre combusted and weighed) for biomass measurements for dry weight. The dataset includes samples analyzed for mesozooplankton species composition, abundance and total mesozooplankton biomass. Sampling volume was estimated by multiplying the mouth area with the wire length. Sampling biomass was measured by weighing filters and then determined according to sampling volume. 1/2 sample or an aliquot was analyzed under the binocular microscope. Copepod species were identified and enumerated; the other mesozooplankters were identified and enumerated at higher taxonomic level (commonly named as mesozooplankton groups). Taxonomic identification was done at the METU-Institute of Marine Sciences by Tuba Terbiyik using the relevant taxonomic literatures.

Abundance of mesozooplankton in the SESAME Italian cruise S-IT2 in the Ionian Sea in March 2008

The "SESAME_IT2_ZooAbundance_0-50-100m_SZN" dataset contains data of mesozooplankton species composition and abundance (ind. m-3) from samples collected in the Ionian Sea in the late winter (2-8 March) of 2008 during the SESAME-WP2 cruise IT2. Samples were collected by vertical tows with a closing WP2 net (56 cm diameter, 200 ?m mesh size) in the following depth layers: 100-200 m, 50-100 m, 0-50 m. Sampling was always performed in light hours. A flowmeter was applied to the mouth of the net, however, due to its malfunctioning, the volume of filtered seawater was calculated by multiplying the the area by the height of the sampled layer from winch readings. After collection, each sample was split in two halves (1/2) after careful mixing with graduated beakers. Half sample was immediately fixed and preserved in a formaldehyde-seawater solution (4% final concentration) for species composition and abundance. The other half sample was kept fresh for biomass measurements (data already submitted to SESAME database in different files).Here, only the zooplankton abundance of samples in the upper layers 0-50 m and 50-100 m are presented. The abundance data of the samples in the layer 50-100 m will be submitted later in a separate file. The volume of filtered seawater was estimated by multiplying the the area by the height of the sampled layer from winch readings. Identification and counts of specimens were performed on aliquots (1/20-1/5) of the fixed sample or on the total sample (half of the original sample) by using a graduate large-bore pipette. Copepods were identified to the species level and separated into females, males and juveniles (copepodites). All other taxa were identified at the species level when possible, or at higher taxonomic levels. Taxonomic identification was done according to the most relevant and updated taxonomic literature. Total mesozooplankton abundance was computed as sum of all specific abundances determined as explained above.