(Table 1) Summary of basalt unit thickness, vesicularity, number of flow units, and average porosity at ODP Site 135-839

An inflatable drill-string packer was used at Site 839 to measure the bulk in-situ permeability within basalts cored in Hole 839B. The packer was inflated at two depths, 398.2 and 326.9 mbsf; all on-board information indicated that the packer mechanically closed off the borehole, although apparently the packer hydraulically sealed the borehole only at 398.2 mbsf. Two pulse tests were run at each depth, two constant-rate injection tests were run at the first set, and four were run at the second. Of these, only the constant-rate injection tests at the first set yielded a permeability, calculated as ranging from 1 to 5 * 10**-12 m**2. Pulse tests and constant-rate injection tests for the second set did not yield valid data. The measured permeability is an upper limit; if the packer leaked during the experiments, the basalt would be less permeable. In comparison, permeabilities measured at other Deep Sea Drilling Project and Ocean Drilling Program sites in pillow basalts and flows similar to those measured in Hole 839B are mainly about 10**-13 to 10**-14 m**2. Thus, if our results are valid, the basalts at Site 839 are more permeable than ocean-floor basalts investigated elsewhere. Based on other supporting evidence, we consider these results to be a valid measure of the permeability of the basalts. Temperature data and the geochemical and geotechnical properties of the drilled sediments all indicate that the site is strongly affected by fluid flow. The heat flow is very much less than expected in young oceanic basalts, probably a result of rapid fluid circulation through the crust. The geochemistry of pore fluids is similar to that of seawater, indicating seawater flow through the sediments, and sediments are uniformly underconsolidated for their burial depth, again indicating probable fluid flow. The basalts are highly vesicular. However, the vesicularity can only account for part of the average porosity measured on the neutron porosity well log; the remainder of the measured porosity is likely present as voids and fractures within and between thin-bedded basalts. Core samples, together with porosity, density, and resistivity well-log data show locations where the basalt section is thin bedded and probably has from 15% to 35% void and fracture porosity. Thus, the measured permeability seems reasonable with respect to the high measured porosity. Much of the fluid flow at Site 839 could be directed through highly porous and permeable zones within and between the basalt flows and in the sediment layer just above the basalt. Thus, the permeability measurements give an indication of where and how fluid flow may occur within the oceanic crust of the Lau Basin.

(Table 1, page 661) Average composition of fossil nodules from three localities studied in the Transdanubian Central Mountains of Hungary

Fossil manganese nodules and encrustations from seamount' and basin' localities in the Transdanubian Central Mountains of Hungary are lithologically, mineralogically and chemically similar to some modern marine ferromanganese oxide deposits, and show no evidence of postdepositional changes other than cementation. Five groups of deposits were encountered: Fe/Mn nodules, encrusted shells, pavements, stains, and Fe oxide encrusted intraclasts, the first three of which are specific to the 'seamount' environment and the last to the basins'. Optical and electron microprobe investigation of the samples shows them to exhibit many similarities with modern ferromanganese oxide deposits, and that many of the nodules are surrounded by a halo of dispersed ferromanganese oxides, strongly suggesting that they continued to accrete metals through the pore waters of unlithified sediments for a period after burial. By contrast, pavements which appear to have grown on hardgrounds at the sea floor show little or no evidence of derivation of metals from underlying sediments. Geochemical investigations on the deposits show the seamount' varieties to be closer in composition to most modern nodules and crusts than the basin' varieties, and that the latter are essentially manganese and trace-element-poor ferruginous deposits. Nevertheless, all can be more or less compositionally equated with modern ferromanganese oxide deposits forming in marginal Atlantic environments, which would be in accord with the proposed depositional environment of the Transdanubian Central Mountains based on other evidence.

(Table 2, Page 252) Average chemical composition of 11 manganese nodules and crust from the Pacific Ocean

The ability of the hydrated oxides of manganese and iron to adsorb ions from solution (scavenging) is considered in relation to some problems in marine geology, chemistry, and biology. In the ferruginous sediments of the Pacific Ocean, iron oxides are accompanied by titanium, cobalt, and zirconium in amounts proportional to the iron content. Similarly, copper and nickel are linearly related to the manganese content. These observations are explained on the basis of scavenging. An electrochemical theory for the formation of manganese nodules is presented. Marine sediments are classified on the basis of the geosphere in which the solid phases originate. The distribution of certain ionic species in sea water between the solid and aqueous phases is considered on the basis of scavenging and co-ordination compound theory. The concentration of minor elements by members of the marine biosphere is explained either by the direct uptake of the element or by the uptake of iron or manganese oxides with the accompanying scavenged element.

Ostracode relative abundances and geochemistry in surface sediments from Lake Ohrid

Understanding the ecology of bioindicators such as ostracods is essential in order to reconstruct past environmental and climate change from analysis of fossil assemblages preserved in lake sediment cores. Knowledge of the ecology of ancient Lake Ohrid's ostracod fauna is very limited and open to debate. In advance of the Ohrid ICDP-Drilling project, which has potential to generate high-resolution long-term paleoenvironmental data of global importance in paleoclimate research, we sampled Lake Ohrid and a wide range of habitat types in its surroundings to assess 1) the composition of ostracod assemblages in lakes, springs, streams, and short-lived seasonal water bodies, 2) the geographical distribution of ostracods, and 3) the ecological characteristics of individual ostracod species. In total, 40 species were collected alive, and seven species were preserved as valves and empty carapaces. Of the 40 ostracod species, twelve were endemic to Lake Ohrid. The most common genus in the lake was Candona, represented by 13 living species, followed by Paralimnocythere, represented by five living species. The most frequent species was Cypria obliqua. Species with distinct distributions included Heterocypris incongruens, Candonopsis kingsleii, and Cypria lacustris. The most common species in shallow, flooded areas was H. incongruens, and the most prominent species in ditches was C. kingsleii. C. lacustris was widely distributed in channels, springs, lakes, and rivers. Statistical analyses were performed on a "Lake Ohrid" dataset, comprising the subset of samples from Lake Ohrid alone, and an "entire" dataset comprising all samples collected. The unweighted pair group mean average (UPGMA) clustering was mainly controlled by species-specific depth preferences. Canonical Correspondence Analysis (CCA) with forward selection identified water depth, water temperature, and pH as variables that best explained the ostracod distribution in Lake Ohrid. The lack of significance of conductivity and dissolved oxygen in CCA of Ohrid data highlight the uniformity across the lake of the well-mixed waters. In the entire area, CCA revealed that ostracod distribution was best explained by water depth, salinity, conductivity, pH, and dissolved oxygen. Salinity was probably selected by CCA due to the presence of Eucypris virens and Bradleystrandesia reticulata in short-lived seasonal water bodies. Water depth is an important, although indirect, influence on ostracod species distribution which is probably associated with other factors such as sediment texture and food supply. Some species appeared to be indicators for multiple environmental variables, such as lake level and water temperature.

Diatom abundance in surface sediments of the Southern Ocean

Based on the quantitative analysis of diatom assemblages preserved in 274 surface sediment samples recovered in the Pacific, Atlantic and western Indian sectors of the Southern Ocean we have defined a new reference database for quantitative estimation of late-middle Pleistocene Antarctic sea ice fields using the transfer function technique. The Detrended Canonical Analysis (DCA) of the diatom data set points to a unimodal distribution of the diatom assemblages. Canonical Correspondence Analysis (CCA) indicates that winter sea ice (WSI) but also summer sea surface temperature (SSST) represent the most prominent environmental variables that control the spatial species distribution. To test the applicability of transfer functions for sea ice reconstruction in terms of concentration and occurrence probability we applied four different methods, the Imbrie and Kipp Method (IKM), the Modern Analog Technique (MAT), Weighted Averaging (WA), and Weighted Averaging Partial Least Squares (WAPLS), using logarithm-transformed diatom data and satellite-derived (1981-2010) sea ice data as a reference. The best performance for IKM results was obtained using a subset of 172 samples with 28 diatom taxa/taxa groups, quadratic regression and a three-factor model (IKM-D172/28/3q) resulting in root mean square errors of prediction (RMSEP) of 7.27% and 11.4% for WSI and summer sea ice (SSI) concentration, respectively. MAT estimates were calculated with different numbers of analogs (4, 6) using a 274-sample/28-taxa reference data set (MAT-D274/28/4an, -6an) resulting in RMSEP's ranging from 5.52% (4an) to 5.91% (6an) for WSI as well as 8.93% (4an) to 9.05% (6an) for SSI. WA and WAPLS performed less well with the D274 data set, compared to MAT, achieving WSI concentration RMSEP's of 9.91% with WA and 11.29% with WAPLS, recommending the use of IKM and MAT. The application of IKM and MAT to surface sediment data revealed strong relations to the satellite-derived winter and summer sea ice field. Sea ice reconstructions performed on an Atlantic- and a Pacific Southern Ocean sediment core, both documenting sea ice variability over the past 150,000 years (MIS 1 - MIS 6), resulted in similar glacial/interglacial trends of IKM and MAT-based sea-ice estimates. On the average, however, IKM estimates display smaller WSI and slightly higher SSI concentration and probability at lower variability in comparison with MAT. This pattern is a result of different estimation techniques with integration of WSI and SSI signals in one single factor assemblage by applying IKM and selecting specific single samples, thus keeping close to the original diatom database and included variability, by MAT. In contrast to the estimation of WSI, reconstructions of past SSI variability remains weaker. Combined with diatom-based estimates, the abundance and flux pattern of biogenic opal represents an additional indication for the WSI and SSI extent.