Chemical and isotope composition of poor fluid from gas-hydrate samples of ODP Site 146-892

Although the presence of extensive gas hydrate on the Cascadia margin, offshore from the western U.S. and Canada, has been inferred from marine seismic records and pore water chemistry, solid gas hydrate has only been found at one location. At Ocean Drilling Program (ODP) Site 892, offshore from central Oregon, gas hydrate was recovered close to the sediment-water interface at 2-19 m below the seafloor (mbsf) at 670 m water depth. The gas hydrate occurs as elongated platy crystals or crystal aggregates, mostly disseminated irregularly, with higher concentrations occurring in discrete zones, thin layers, and/or veinlets parallel or oblique to the bedding. A 2- to 3-cm thick massive gas hydrate layer, parallel to bedding, was recovered at ~17 mbsf. Gas from a sample of this layer was composed of both CH4 and H2S. This sample is the first mixed-gas hydrate of CH4-H2S documented in ODP; it also contains ethane and minor amounts of CO2. Measured temperatures of the recovered core ranged from 2 to -1.8°C and are 6 to 8 degrees lower than in-situ temperatures. These temperature anomalies were caused by the partial dissociation of the CH4-H2S hydrate during recovery without a pressure core sampler. During this dissociation, toxic levels of H2S (delta34S, +27.4?) were released. The delta13C values of the CH4 in the gas hydrate, -64.5 to -67.5? (PDB), together with deltaD values of -197 to -199? (SMOW) indicate a primarily microbial source for the CH4. The delta18O value of the hydrate H2O is +2.9? (SMOW), comparable with the experimental fractionation factor for sea-ice. The unusual composition (CH4-H2S) and depth distribution (2-19 mbsf) of this gas hydrate indicate mixing between a methane-rich fluid with a pore fluid enriched in sulfide; at this site the former is advecting along an inclined fault into the active sulfate reduction zone. The facts that the CH4-H2S hydrate is primarily confined to the present day active sulfate reduction zone (2-19 mbsf), and that from here down to the BSR depth (19-68 mbsf) the gas hydrate inferred to exist is a >=99% CH4 hydrate, suggest that the mixing of CH4 and H2S is a geologically young process. Because the existence of a mixed CH4-H2S hydrate is indicative of moderate to intense advection of a methane-rich fluid into a near surface active sulfate reduction zone, tectonically active (faulted) margins with organic-rich sediments and moderate to high sedimentation rates are the most likely regions of occurrence. The extension of such a mixed hydrate below the sulfate reduction zone should reflect the time-span of methane advection into the sulfate reduction zone.

Geochemical composition of sulfide and oxide minerals from ODP Sites 193-1188 and 193-1189, PACMANUS field

Ocean Drilling Program (ODP) Leg 193 recovered core from the active PACMANUS hydrothermal field (eastern Manus Basin, Papua New Guinea) that provided an excellent opportunity to study mineralization related to a seafloor hydrothermal system hosted by felsic volcanic rocks. The purpose of this work is to provide a data set of mineral chemistry of the sulfide-oxide mineralization and associated gold occurrence in samples drilled at Sites 1188 and 1189. PACMANUS consists of five active vent sites, namely Rogers Ruins, Roman Ruins, Satanic Mills, Tsukushi, and Snowcap. In this work two sites were studied: Snowcap and Roman Ruins. Snowcap is situated in a water depth of 1670 meters below sea level [mbsl], covers a knoll of dacite-rhyodacite lava, and is characterized by low-temperature diffuse venting. Roman Ruin lies in a water depth of 1693-1710 mbsl, is 150 m across, and contains numerous large, active and inactive, columnar chimneys. Sulfide mineralogy at the Roman Ruins site is dominated by pyrite with lesser amounts of chalcopyrite, sphalerite, pyrrhotite, marcasite, and galena. Sulfide minerals are relatively rare at Snow Cap. These are dominated by pyrite with minor chalcopyrite and sphalerite and traces of pyrrhotite. Native gold has been found in a single sample from Hole 1189B (Roman Ruins). Oxide minerals are represented by Ti magnetite, magnetite, ilmenite, hercynite (Fe spinel), and less abundant Al-Mg rich chromite (average = 10.6 wt% Al2O3 and 5.8 wt% MgO), Fe-Ti oxides, and a single occurrence of pyrophanite (Mn Ti O3). Oxide mineralization is more developed at Snowcap, whereas sulfide minerals are more extensive and show better development at Roman Ruins. The mineralogy was obtained mainly by a detailed optical microscopy study. Oxide mineral identifications were confirmed by X-ray diffraction, and mineral chemistry was determined by electron probe microanalyses.

(Table T1) Dissolved sulfide concentration and d34S of dissolved sulfate and sulfide in pore waters of ODP Leg 204

We report dissolved sulfide sulfur concentrations and the sulfur isotopic composition of dissolved sulfate and sulfide in pore waters from sediments collected during Ocean Drilling Program Leg 204. Porewater sulfate is depleted rapidly as the depth to the sulfate/methane interface (SMI) occurs between 4.5 and 11 meters below seafloor at flank and basin locations. Dissolved sulfide concentration reaches values as high as 11.3 mM in Hole 1251E. Otherwise, peak sulfide concentrations lie between 3.2 and 6.1 mM and occur immediately above the SMI. The sulfur isotopic composition of interstitial sulfate generally becomes enriched in 34S with increasing sediment depth. Peak d34S-SO4 values occur just above the SMI and reach up to 53.1 per mil Vienna Canyon Diablo Troilite (VCDT) in Hole 1247B. d34S-Sigma HS values generally parallel the trend of d34S-SO4 values but are more depleted in 34S relative to sulfate, with values from -12.7 per mil to 19.3 per mil VCDT. Curvilinear sulfate profiles and carbon isotopic composition of total dissolved carbon dioxide at flank and basin sites strongly suggest that sulfate depletion is controlled by oxidation of sedimentary organic matter, despite the presence of methane gas hydrates in underlying sediments. Preliminary data from sulfur species are consistent with this interpretation for Leg 204 sediments at sites not located on or near the crest of Hydrate Ridge.

The distribution of sulfur in oceanic crust with respect to oxidative diagenesis (Table 1)

A detailed geochemical-petrological examination of layer 2 basalts recovered during Leg 37 of the DSDP has revealed that the original distribution, form and abundance of igneous sulfide have been profoundly altered during low-grade oxidative diagenesis. The net result appears to have been a rather pervasive remobilization of igneous sulfide to form secondary pyrite accompanied by a bulk loss of sulfur equivalent to about 50-60% of the original igneous value, assuming initial saturation. It is suggested that during infiltration of seawater into the massive crystalline rock, igneous sulfide has experienced pervasive oxidation, under conditions of limited oxidation potential, to form a series of unstable, soluble sulfur species, primarily in the form of SO3[2-] and S2O3[2-]. Spontaneous decomposition of these intermediate compounds through disproportionation has resulted in partial reconstitution of the sulfur as secondary pyrite and the generation of SO4[2-] ion, which, due to its kinetic stability, has been lost from the basalt system and ultimately transferred to the ocean. This model not only satisfies the geochemical and petrological observations but also provides a suitable explanation for the highly variable delta34S values which characterize secondary sulfides in deep ocean floor basalts.

Chemical composition of basalts from the Atlantic Ocean

Basalt recovered beneath Jurassic sediments in the western Atlantic at Deep Sea Drilling Project sites 100 and 105 of leg 11 has petrographic features characteristic of water-quenched basalt extruded along modern ocean ridges. Site 100 basalt appears to represent two or three massive cooling units, and an extrusive emplacement is probable. Site 105 basalt is less altered and appears to be a compositionally homogeneous pillow lava sequence related to a single eruptive episode. Although the leg 11 basalts are much more closely related in time to the Triassic lavas and intrusives of eastern continental North America, their geochemical features are closely comparable to those of modern Mid-Atlantic Ridge basalts unrelated to postulated "mantle plume" activity. Projection of leg 11 sites back along accepted spreading "flow lines" to their presumed points of origin shows that these origins are also outside the influence of modern" plume" activity. Thus, these oldest Atlantic seafloor basalts provide no information on the time of initiation of these "plumes". The Triassic continental diabases show north to south compositional variations in Rb, Ba, La, and Sr which lie within the range of " plume "-related basalt on the Mid-Atlantic Ridge (20° - 40° N) This suggests that these diabases had mantle sources similar in composition to those beneath the present Mid-Atlantic Ridge. "Plumes" related to deep mantle sources may have contributed to the LIL-element enrichment in the Triassic diabase and may also have been instrumental in initiating the rifting of the North Atlantic. Systematically high values for K and Sr87/Sr86 in the Triassic diabases may reflect superimposed effects of crustal contamination in the Triassic magmas.