Planktonic foraminifera stratigraphy and datums of ODP Site 184-1143 and Hole 184-1146A, South China Sea

The biostratigraphy of Miocene-age sediment samples recovered from Ocean Drilling Program Sites 1143 and 1146, South China Sea, is presented. The preservation of the planktonic foraminifers recovered from both sites varies widely, from poor to very good. The volume of biogenic sediment in the >63-µm size fraction also varies considerably, with many samples being dominated by mud. In comparison to shipboard biostratigraphy, based on core catcher analyses with a depth resolution of ~10 m, we analyzed samples from the two stratigraphic columns every 2-3 m (~45- to 93-k.y. resolution). The placement of planktonic foraminifer zonal boundaries was made at a resolution of ~1.5 m at Site 1146 and ~3.0 m at Site 1143. The higher resolution has resulted in significant changes in biostratigraphic zonal boundary locations compared to shipboard results. For the time interval of 5.54-10.49 Ma, the changes in zonation reveal similar age-depth models at both sites, with three segments of changing sedimentation rate through the upper Miocene, though the differences in sedimentation rates at Site 1146 are subtler than those at Site 1143. The boundary between lithologic Units II and III at Site 1146 corresponds to a sharp change in sedimentation rate (58 to 21 m/m.y.) at 15.1 Ma (the first occurrence of Orbulina suturalis). At this site, the interval from 16.4 to 15.1 Ma is characterized by very high mass accumulation rates in the noncarbonate fraction. Above this interval the carbonate fraction becomes increasingly important in the sediment flux to the South China Sea. At Site 1143, sedimentation rates increase from 8 to 99 m/m.y. at 8.6 Ma. This corresponds to a dramatic increase in both carbonate and noncarbonate mass accumulation rates at the site, but no change in lithology.

Chemistry of secondary minerals from the deep sheeted dike complex of ODP Holes 137-504B and 140-504B

Dolerites sampled from the lower sheeted dikes from Hole 504B during Ocean Drilling Program Legs 137 and 140, between 1562.4 and 2000.4 mbsf, were examined to document the mineralogy, petrography, and mineral parageneses associated with secondary alteration, to constrain the thermal history and composition of hydrothermal fluids. The main methods used were mineral chemical analyses by electron microprobe, X-ray diffraction, and cathodoluminescence microscopy. Temperatures of alteration were estimated on the basis of single and/or coexisting mineral chemistry. Permeability is important in controlling the type and extent of alteration in the studied dike section. At the meter-scale, intervals of weakly altered dolerites containing fresh olivine are interpreted as having experienced restricted exposure to hydrothermal fluids. At the centimeter- or millimeter-scale, alteration patches and extensively altered halos adjacent to veins reflect the permeability related to intergranular primary porosity and cracks. Most of the sheeted dike alteration in this case resulted from non-focused, pervasive fluid-rock interaction. This study confirms and extends the previous model for hydrothermal alteration at Hole 504B: hydrothermal alteration at the ridge axis followed by seawater recharge and off-axis alteration. The major new discoveries, all related to higher temperatures of alteration, are: (1) the presence of hydrothermal plagioclase (An80-95), (2) the presence of deuteric and/or hydrothermal diopside, and (3) the general increasing proportion of amphiboles, and particularly magnesio-hornblende with depth. We propose that the dolerites at Hole 504B were altered in five stages. Stage 1 occurred at high temperatures (less than 500° to 700°C) and involved late-magmatic formation of Na- and Ti-rich diopside, the hydrothermal formation of Na, Ti-poor diopside and the hydrothermal formation of an assemblage of An-rich plagioclase + hornblende. Stage 2 occurred at lower temperatures (250°-320°C) and is characterized by the appearance of actinolite, chlorite, chlorite-smectite, and/or talc (in low permeability zones) and albite. During Stage 3, quartz and epidote precipitated from evolved hydrothermal fluids at temperatures between 310° and 320°C. Anhydrite appeared during Stage 4 and likely precipitated directly from heated seawater. Stage 5 occurred off-axis at low temperatures (250°C) with laumontite and prehnite from evolved fluids.

In-situ sediment temperature and pore water chloride concentration at pockmarks of the Nigerian continental margin

A joint research expedition between the French IFREMER and the German MARUM was conducted in 2011 using the R/V 'Pourquoi pas?' to study gas hydrate distributions in a pockmark field (1141-1199 m below sea surface) at the continental margin of Nigeria. The seafloor drill rig MeBo of MARUM was used to recover sediments as deep as 56.74 m below seafloor. The presence of gas hydrates in specific core sections was deduced from temperature anomalies recorded during continuous records of infrared thermal scanning and anomalies in pore water chloride concentrations. In situ sediment temperature measurements showed elevated geothermal gradients of up to 258 °C/km in the center of the so-called pockmark A which is up to 4.6 times higher than that in the background sediment (72 °C/km). The gas hydrate distribution and thermal regime in the pockmark are largely controlled by the intensity, periodicity and direction of fluid flow. The joint interaction between fluid flow, gas hydrate formation and dissolution, and the thermal regime governs pockmark formation and evolution on the Nigerian continental margin.