(Table 1.4) Ratios of petrogenic components in glassy and crystalline basalts from the north part of the Bougault anomaly, Mid-Atlantic Ridge 15°N

Structure and composition of sub-surface bottom sediments from the southwest Barents Sea have been under study. The study has revealed heterogeneity of sediment structure resulted from temporal irregularity and variability of sedimentation processes. The study of the heavy minerals from 0.1-0.01 mm grain size fraction has shown prevalence of green hornblende, epidote, garnet, and ilmenite in all types of sediments; these minerals are the basis of terrigenous-mineralogical province. At the same time in different areas local terrigenous-mineralogical associations have been identified. Clay mineral composition of in the sediments was quite uniform: biotite, chlorite, hydromica, smectite. Despite this, a number of features indicating initial stages of clay mineral transformation has been identified. Differences in material composition and structure of the studied sediments are associated with rapid change in paleogeographic situation on the land - ice cover melting on the Kola Peninsula and subsequent Holocene climatic situation.

Foraminiferal study of ODP Hole 189-1171

Sequence boundary ages determined in shallow-water sediments obtained from ODP (Ocean Drilling Program) Leg 189 Site 1171 (South Tasman Rise) compare well with other stratigraphic records (New Jersey, United States, and northwestern Europe) and d18O increases from deep-sea records, indicating that significant (>10 m) eustatic changes occurred during the early to middle Eocene (51-42 Ma). Sequence boundaries were identified and dated using lithology, bio- and magnetostratigraphy, water-depth changes, CaCO3 content, and physical properties (e.g., photospectrometry). They are characterized by a sharp bioturbated surface, low CaCO3 content, and an abrupt increase in glauconite above the surface. Foraminiferal biofacies and planktonic/benthic foraminiferal ratios were used to estimate water-depth changes. Ages of six sequence boundaries (50.9, 49.2, 48.5-47.8, 47.1, 44.5, and 42.6 Ma) from Site 1171 correlate well to the timings of d18O increases and sequence boundaries identified from other Eocene studies. The synchronous nature of sequence boundary development from globally distal sites and d18O increases indicates a global control and that glacioeustasy was operating in this supposedly ice-free world. This is supported by previous modeling studies and atmospheric pCO2 estimates showing that the first time pCO2 levels decreased below a threshold that would support the development of an Antarctic ice sheet occurred at ca. 51 Ma. Estimates of sea-level amplitudes range from ~20 m for the early Eocene (51-49 Ma) and ~25 m to ~45 m for the middle Eocene (48-42 Ma) using constraints established for Oligocene d18O records.

Tab 1-4 Weight and volume reduction as well as surface subsidence during abrasion experiments

Antarctic land surfaces in South Victoria Land, all without a covering of vegetation, are actively formed by winds which often reach velocities of more than 100 km/h. Consequently, deflation and abrasion are essential factors in the process of slope formation. Water erosion, active only during the very short summer period, is limited to a few localities in South Victoria Land. Experiments in a wind tunnel proved that ventifacts in the Dry Valleys can be formed within a few decades or at the most, a few centuries. Yearly corrasion rates average around a maximum of a few millimeters. Considerable variability is caused by the different exposures of ventifacts within the micro relief end the varying resistance of the rocks. The importance of ice crystals (snow) for abrasion processes should not be overestimated.