Geochemistry of interstitial waters from ODP Leg 115 sites

As a part of the shipboard scientific program, interstitial waters were routinely analyzed for pH, alkalinity, salinity, chlorinity, calcium, and magnesium during Leg 116. Unfortunately, the tables containing these data for Sites 718 and 719 were inadvertently omitted from the Initial Results volume (Cochran, Stow et al., 1989, doi:10.2973/odp.proc.ir.116.1989). The missing data are presented here (Tables 1-3) along with the Site 717 data, reproduced for completeness.

Mineralogy of silts from the Bengal Fan

Early Miocene to Quaternary sediments drilled from the Bengal Fan are divided into six zones by modal proportions of heavy minerals. The sediments were mostly derived from the Himalayas. Detritus from the Indian subcontinent is found sporadically in clay-rich sediments that were deposited during periods of slow sedimentation, when the deep-sea channel migrated away from the drilled sites. The oldest sediments, ranging from 17 to about 15 Ma, were derived mostly from the Precambrian and Paleozoic sedimentary rocks of the lower Himalayas. At about 15 Ma, metamorphic terrains were eroded in the source area. Further large-scale unroofing of metamorphic rocks occurred around 11 Ma. After 10 Ma, the major constituents in the drainage basin or the drainage pattern changed a few times. Between 3.5 and 0.5 Ma, a large peridotite body was unroofed by uplift and successive erosion of the central Himalayas. At this time, the single large river that had supplied detritus to the early Bengal Fan was divided into the Indus and Ganges rivers.

Consolidation characteristics of outer Bengal Fan deposits (Table 1)

The state of consolidation of outer Bengal Fan deposits is closely related to their depositional history. Early Pleistocene sediments are underconsolidated, i.e., fabric strength is lower than under equilibrium with the present overburden stress, at depths greater than 60-80 mbsf. This may be due to rapid accumulation (>15-20 cm/k.y.) and overlying low-permeability (<10**-7 cm/s) deposits. The underlying Pliocene sediments are overconsolidated, i.e., fabric strength is higher than in equilibrium with the present overburden stress; at Sites 717 and 719 the sediments are slightly overconsolidated, whereas at Site 718 the overconsolidation is significant. Overconsolidation is explained by erosion that occurred during the early Pleistocene for which a stratigraphic gap was recorded in the drilled cores. The eroded section is estimated to be in the range of 10-40 m at Sites 717 and 719, respectively, and 130-150 m at Site 718. Below 250-300 mbsf the most sediments are normally consolidated. The amount of erosion seems to be related to block rotation and uplift due to intraplate deformation.