861 resultados para EPMA geochemistry
Resumo:
Deep Sea Drilling Project Legs 59 and 60 drilled 15 sites along an east-west transect at 18°N from the West Philippine Basin to the Mariana Trench (Fig. 1) in order to study the nature and genesis of the back-arc, marginal basins and the remnant and active arcs of the region. Leg 59 drilled at five sites at the western end of the traverse: Site 447 in the West Philippine Basin; Site 448 on the Palau-Kyushu Ridge; Sites 449 and 450 in the Parece Vela Basin; and Site 451 on the West Mariana Ridge. Penetration into basaltic basement of these sites was 183.5 meters at 447 (8 basalt flows); 623 meters at 448 (46 basalt flows, sills, and dikes and volcaniclastic units); 40.5 meters at 449 (2 basalt flows); 7 meters at 450 (1 basalt intrusion); and 4 meters of basalt breccia at 451 overlain by 861 meters of volcaniclastic sedimentary rocks.
Resumo:
During Deep Sea Drilling Project (DSDP) Leg 84 a core 1 m long and 6 cm in diameter of massive gas hydrate was unexpectedly recovered at Site 570 in upper slope sediment of the Middle America Trench offshore of Guatemala. This core contained only 5-7% sediment, the remainder being the solid hydrate composed of gas and water. Samples of the gas hydrate were decomposed under controlled conditions in a closed container maintained at 4°C. Gas pressure increased and asymptotically approached the equilibrium decomposition pressure for an ideal methane hydrate, CH4.5-3/4H2O, of 3930 kPa and approached to this pressure after each time gas was released, until the gas hydrate was completely decomposed. The gas evolved during hydrate decomposition was 99.4% methane, ~0.2% ethane, and ~0.4% CO2. Hydrocarbons from propane to heptane were also present, but in concentrations of less than 100 p.p.m. The carbon-isotopic composition of methane was -41 to -44 per mil, relative to PDB standard. The observed volumetric methane/water ratio was 64 or 67, which indicates that before it was stored and analyzed, the gas hydrate probably had lost methane. The sample material used in the experiments was likely a mixture of methane hydrate and water ice. Formation of this massive gas hydrate probably involved the following processes: (i) upward migration of gas and its accumulation in a zone where conditions favored the growth of gas hydrates, (ii) continued, unusually rapid biological generation of methane, and (iii) release of gas from water solution as pressure decreased due to sea level lowering and tectonic uplift.
Resumo:
Primary and secondary mineral phases from Holes 1268A (11 samples), 1272A (9 samples), and 1274A (12 samples) were analyzed by electron microprobe in Bonn and Cologne (Germany). Bulk rock powders of these samples were also analyzed geochemically, including major and trace elements (Paulick et al., 2006, doi:10.1016/j.chemgeo.2006.04.011). Ocean Drilling Program (ODP) Leg 209 Holes 1268A, 1272A, and 1274A differ remarkably in alteration intensity and mineralogy, and details regarding their lithologic characteristics are presented in Bach et al. (2004, doi:10.1029/2004GC000744) and Shipboard Scientific Party (2004, doi:10.2973/odp.proc.ir.209.101.2004). Because of the least altered character of peridotite in Hole 1274A, abundant clinopyroxene, orthopyroxene, olivine, and spinel were analyzed at this site. In Hole 1272A, primary silicates are rare and analyses were restricted to some samples that contain traces of olivine and orthopyroxene. Because of the intensity of alteration, Hole 1268A is devoid of primary phases except spinel. Commonly, alteration is pseudomorphic and serpentinization of olivine and orthopyroxene can be distinguished. Accordingly, compositional variations of the alteration minerals with regard to the precursor minerals are one of the issues investigated in this data report.
Resumo:
Biological productivity in the modern equatorial Pacific Ocean, a region with high nutrients and low chlorophyll, is currently limited by the micronutrient Fe. In order to test whether Fe was limiting in the past and to identify potential pathways of Fe delivery that could drive Fe fertilization (i.e., dust delivery from eolian inputs vs. Fe supplied by the Equatorial Undercurrent), we chemically isolated the terrigenous material from sediment along a cross-equatorial transect in the central equatorial Pacific at 140°W and at Ocean Drilling Program Site 850 in the eastern equatorial Pacific. We quantified the contribution from each potential Fe-bearing terrigenous source using a suite of chemical- and isotopic discrimination strategies as well as multivariate statistical techniques. We find that the distribution of the terrigenous sources (i.e., Asian loess, South American ash, Papua New Guinea, and ocean island basalt) varies through time, latitude, and climate. Regardless of which method is used to determine accumulation rate, there also is no relationship between flux of any particular Fe source and climate. Moreover, there is no connection between a particular Fe source or pathway (eolian vs. Undercurrent) to total productivity during the Last Glacial Maximum, Pleistocene glacial episodes, and the Miocene "Biogenic Bloom". This would suggest an alternative process, such as an interoceanic reorganization of nutrient inventories, may be responsible for past changes in total export in the open ocean, rather than simply Fe supply from dust and/or Equatorial Undercurrent processes. Additionally, perhaps a change in Fe source or flux is related to a change in a particular component of the total productivity (e.g., the production of organic matter, calcium carbonate, or biogenic opal).
Resumo:
Two ash horizons have been identified in Hole 549, one in the upper Paleocene (basal NP9), the other in the upper Eocene (NP18); both are mixed lithic crystal tuffs of rhyolitic composition. These tuffs are absent in Hole 550 owing to unconformities, but the basal Eocene (NP10) of Hole 550 includes a series of over 50 thin bentonite layers. Intermediate plagioclase associated with these bentonites indicates that the original ash was of basaltic to andesitic composition. The bentonites are absent in Hole 549, probably because of an unconformity, but they have been identified in Hole 401 (Leg 48, Bay of Biscay). Two of the pyroclastic phases can be matched with phases previously reported for the North Sea Basin. The bentonites of Site 550 are probably equivalent to the widespread "ash series" of northwestern Europe, which may therefore be regarded as being lower Eocene in terms of Martini's calcareous nannoplankton zonation.
Resumo:
We report the major, rare earth, and other trace element compositions of clinopyroxenes from two Leg 140, Hole 504B diabase dikes. These pyroxenes reflect a complex history of crystal growth and magma evolution. The large ranges of composition found reflect incorporation of exotic phenocrysts into the melt, the early formation of crystal clots before dike intrusion during an undercooling event, and in-situ fractionation of melt during and following dike emplacement. Some of the pyroxenes occur in coarse two- and three-phase glomerocrysts, which may be ôprotogabbrosö representing early stages of melt crystallization in the lower crust. Large variations in trace element composition are found. These likely reflect heterogeneous nucleation and growth of plagioclase and pyroxene in the melt, as well as complex interface kinetics that may affect partition coefficients during rapid crystal growth expected during undercooling. This can explain the formation of irregular chemical sector zoning in some equant anhedral phenocrysts. Undercooling of magmas in the lower crust most likely reflects input of fresh hot melt into a stagnating melt-storage zone. Dikes intruded upward from an inflated melt-storage zone during such a cycle are likely to be larger than those intruded from the storage zone between such cycles, when it would be deflated, consistent with the greater overall thickness of the phyric dikes in the Leg 140 section of Hole 504B.