Mean grain size and structure of ODP Hole 140-504B samples

Microstructural investigations of ocean crust samples provide a complementary approach to both marine surveys and laboratory experiments. The recovery of relatively undeformed diabases from Deep Sea Drilling Project (DSDP)/Ocean Drilling Program (ODP) Hole 504B provides a first opportunity to examine a reference section of microstructural features that influence strain localization at depths of 2 km in the ocean crust. Syn- and post-crystallization features in plagioclase and augite crystals have been examined by optical microscopy and secondary and backscattered electron imaging. These features show a strong influence of modal composition and primary textures on early sites of strain localization. Thermal cracking and subsequent alteration intensities and distribution are strongly phase dependent. A consistently higher intragranular fracture density is observed in augite crystals relative to plagioclase. The impact of alteration on the mechanical response of diabases is likely to depend on the primary textural characteristics. Even where extensive augite alteration occurs, the rock remains supported by a framework of weakly altered plagioclase crystals. The Hole 504B diabases from Leg 140 provide a valuable comparison for future studies of more deformed sections likely to be encountered at depth. Advances in constraining the detailed rheology of the ocean crust at spreading centers would benefit from experimental deformation of texturally diverse diabase and gabbro samples.

(Table 2) Estimated basement temperatures at DSDP Hole 69-504B

The achievement of deep penetration (562 m) of seafloor basalts at Hole 504B, near the Costa Rica Rift (1°13.63'N, 83°43.81'W), on DSDP Legs 69 and 70 presented a rare opportunity to examine the structure of young (6 m.y.) oceanic crust. In addition to the recovery of samples for laboratory studies, an extensive suite of downhole logs and experiments was carried out at this site, for two main purposes: (1) to allow reliable deductions about the nature of the entire section of penetrated crust, because recovery of samples was far from complete (-25%); (2) to probe the physical state of rock around the drilled hole on a scale of tens of meters to kilometers. Information on the latter large-scale phenomena at Hole 504B were provided mainly by the oblique seismic experiment, utilizing a bore-hole seismometer (Stephen 1983), and by the large-scale-electrical- resistivity experiment described below.

Geochemistry of ODP Hole 111-504B basalts (Table 2)

Fifty samples of basalt recovered during ODP Leg 111 from the dikes (Layer 2C) of Hole 504B (1350.0-1562.3 m below seafloor) were analyzed by X-ray-fluorescence techniques. All of the samples are highly depleted in magmaphile elements relative to other mid-ocean ridge basalts, with TiO2 = 0.75-1.24 wt%, Na2O = 1.59-2.22 wt%, Zr = 38-64 ppm, Nb = 0.3-1.5 ppm, and Y = 20-30 ppm (for samples containing 0%-2% phenocrysts), but have ratios of highly incompatible elements similar to normal Type I mid-ocean ridge basalts (e.g., Zr/Nb > 30). Abundances of compatible elements are similar to those of typical mid-ocean ridge basalts, with MgO = 7.2-9.2 wt%, Fe2O3* = 9.3-12.5 wt%, Ni = 55-164 ppm, and Cr = 26-388 ppm. Approximately 2% of the samples recovered from the top part of Hole 504B are similar to normal Type I or Type II ocean floor basalts. However, all of the analyzed Leg 111 samples from Hole 504B are depleted basalts. Aphyric dike rocks from Leg 111 are virtually identical to the depleted aphyric samples recovered from the pillow lavas and dikes in the upper 1075 m of Hole 504B during DSDP Legs 69, 70, and 83, with the exception of elements readily altered by seawater (Sr, Rb, and K). These elements reach a maximum in both abundance and variability in the pillow lavas of the upper 571.5 m of Hole 504B and decline to more constant values in the dike system sampled on Legs 83 and 111, apparently as a result of a decrease in porosity and increase in alteration temperatures relative to the pillow lavas. Based on compositional similarities to the vast majority of the pillows and flows, the dikes sampled on Leg 111 appear to be the feeder system for the pillow lavas in the upper part of Hole 504B. The incompatible-element-depleted compositions of the Costa Rica Rift Zone basalts are consistent with multistage melting of a normal mid-ocean ridge source.