(Table 1) Deuterium ratios, chloride content and hydrate volume of pore water and hydrate meltwater from ODP Site 164-996

Site 996 is located above the Blake Diapir where numerous indications of vertical fluid migration and the presence of hydrate existed prior to Ocean Drilling Program (ODP) Leg 164. Direct sampling of hydrates and visual observations of hydrate-filled veins that could be traced 30-40 cm along cores suggest a connection between fluid migration and hydrate formation. The composition of pore water squeezed from sediment cores showed large variations due to melting of hydrate during core recovery and influence of saline water from the evaporitic diapir below. Analysis of water released during hydrate decomposition experiments showed that the recovered hydrates contained significant amounts of pore water. Solutions of the transport equations for deuterium (d2H) and chloride (Cl-) were used to determine maximum (d2H) and minimum (Cl-) in situ concentrations of these species. Minimum in situ concentrations of hydrate were estimated by combining these results with Cl- and d2H values measured on hydrate meltwaters and pore waters obtained by squeezing of sediments, by the means of a method based on analysis of distances in the two-dimensional Cl- d2H space. The computed Cl- and d2H distribution indicates that the minimum hydrate amount solutions are representative of the actual hydrate amount. The highest and mean hydrate concentrations estimates from our model are 31% and 10% of the pore space, respectively. These concentrations agree well with visual core observations, supporting the validity of the model assumptions. The minimum in situ Cl- concentrations were used to constrain the rates of upward fluid migration. Simulation of all available data gave a mean flow rate of 0.35 m/k.y. (range: 0.125-0.5 m/k.y.).

Annotated record of the detailed examination of Mn deposits from R/V Atlantis Cruise 164 stations

The cores described were taken by the personnel of the Lamont-Doherty Earth Observatory (LDEO) operating as guests scientists during the R/V Atlantis Cruise 164 undertaken by the Woods Hole Oceanographic Institution from July until September 1950. A total of 63 cores were recovered and are available at Lamont-Doherty Earth Observatory for sampling and study.

(Table 1) Stable oxygen isotope ratios of interstitial waters from ODP Sites 164-994 and 164-997

The d18O values of interstitial waters from Site 994 and Site 997 sediments, Blake Ridge, western Atlantic, tend to decrease with depth from 0.3 per mil to -0.5 per mil Standard Mean Ocean Water in the upper 200 mbsf, then fluctuate with significant positive spikes of Delta = 0.2 per mil - 0.5 per mil in the gas hydrate zone (200 to 450 mbsf), and finally increase from -0.4 per mil to -0.2 per mil toward 700 mbsf. Positive shifts of d18O IW in the gas hydrate zone are probably caused by the dissociation of gas hydrates originally contained in sediment cores. Gas hydrates recovered from the sites are enriched in 18O, d18O ranging between 2.7 per mil and 3.5 per mil. d18O values of gas hydrates and ambient interstitial waters give an oxygen isotopic fractionation factor of 1.0034-1.0040 at 12°-16°C and ~31 MPa (3 km below sea level). Based on this fractionation and observed isotopic anomalies in the gas hydrate zone, gas hydrates occupy 6% to 12% of pore-space volume within Blake Ridge sediments.

Gas, water and volume characteristics during controlled degassing experiments on ODP Leg 164 PCS cores

A pressurized core with CH4 hydrate or dissolved CH4 should evolve gas volumes in a predictable manner as pressure is released over time at isothermal conditions. Incremental gas volumes were collected as pressure was released over time from 29 pressure core sampler (PCS) cores from Sites 994, 995, 996, and 997 on the Blake Ridge. Most of these cores were kept at or near 0ºC with an ice bath, and many of these cores yielded substantial quantities of CH4. Volume-pressure plots were constructed for 20 of these cores. Only five plots conform to expected volume and pressure changes for sediment cores with CH4 hydrate under initial pressure and temperature conditions. However, other evidence suggests that sediment in these five and at least five other PCS cores contained CH4 hydrate before core recovery and gas release. Detection of CH4 hydrate in a pressurized sediment core through volume-pressure relationships is complicated by two factors. First, significant quantities of CH4-poor borehole water fill the PCS and come into contact with the core. This leads to dilution of CH4 concentration in interstitial water and, in many cases, decomposition of CH4 hydrate before a degassing experiment begins. Second, degassing experiments were conducted after the PCS had equilibrated in an ice-water bath (0ºC). This temperature is significantly lower than in situ values in the sediment formation before core recovery. Our results and interpretations for PCS cores collected on Leg 164 imply that pressurized containers formerly used by the Deep Sea Drilling Project (DSDP) and currently used by ODP are not appropriately designed for direct detection of gas hydrate in sediment at in situ conditions through volume-pressure relationships.

Chemical composition of samples from DSDP Holes 16-163 and 17-164

Considerable postsedimentational alteration of fine dispersed minerals in Cretaceous sedimentary sequences was found in three deep-sea drillholes (163, 164, 169). Original Fe-montmorillonites formed from basalts were converted during lithification to mixed-layer montmorillonite-hydromicas and then to pure hydromicas (celadonites). An assumption that the minerals were originally of authigenic-diagenetic composition is based on a broad spectrum of other diagenetic minerals present: silica group from opal A to opal CT and quartz, clinoptilolite and palygorskite. In addition, quartz-hydromica ratio is strikingly atypical of aeolian transport.