708 resultados para Amsterdam Mud Volcano


Relevância:

80.00% 80.00%

Publicador:

Relevância:

80.00% 80.00%

Publicador:

Relevância:

80.00% 80.00%

Publicador:

Resumo:

Subduction of the Pacific plate beneath the Mariana forearc releases fluids to the overlying mantle wedge that ascend, producing serpentinite "mud" that discharges on the ocean floor. As part of Leg 195 of the Ocean Drilling Program cores were obtained from drill-holes into the mud volcanoes. We report the isotopic composition of Sr in water squeezed from intervals of the cores, in the serpentinite mud, in leaches of the serpentinite mud, and in entrained small harzburgitic clasts. Except in the upper few meters below the seawater-mud interface, where pore water approaches seawater Sr concentration and isotopic ratio, Sr concentration and isotopic composition remain constant at 3-6 µmol/kg and ~0.7054. Because the elemental chemistry of the pore water is unlike seawater, this isotopic composition reflects fluids derived from the subducted slab, probably modified by reaction with mantle material during ascent. Higher Sr isotopic ratios, up to 0.7087, - but not with higher Sr concentrations in pore water - occur superimposed on an advection profile at 13-16 mbsf surrounding a thin layer of foraminiferal sand. Since the upward seepage velocity of slab fluids in the mud volcano vents is a few cm/yr, exchange of Sr between these carbonates and the rising fluids must have occurred within a maximum of a few hundred years, essentially instantaneously given the millions, or tens of millions, of years the mud volcanoes have been in existence. In contrast, the strontium isotopic compositions of leached serpentinite mud, and of small harzburgite clasts entrained in the mud, are always significantly greater than that of the pore water. In small harzburgite clasts the ratio reaches 0.7088, almost as high as the seawater value of 0.7092 and much higher than the value of typical mantle-derived strontium of ~0.704. The serpentinite muds and harzburgite clasts clearly equilibrated with seawater Sr when they were initially deposited at the surface of the seamount, but following burial they have not fully equilibrated with strontium in the pore water now discharging through the vents. These variations in the strontium isotopic composition of solids and pore waters are more consistent with episodic expulsion of fluids in the subduction zone than steady state flow. Whereas strontium in carbonates equilibrates isotopically within a few hundred years, strontium in buried harzburgite clasts does not equilibrate in the same time, assuming steady state rates of upward fluid flow. By inference, the harzburgite clasts and associated serpentinite mud must have been near the seafloor, unburied, for a yet undetermined but much longer period of time to have equilibrated from ~0.704 to 0.709 prior to subsequent burial. It may be possible to characterize at least the periodicity of fluid release in the mud volcano setting by investigating the zonation of strontium isotopic composition of hartzburgite clasts throughout the 60-meter deep composite cores.

Relevância:

80.00% 80.00%

Publicador:

Relevância:

80.00% 80.00%

Publicador:

Relevância:

80.00% 80.00%

Publicador:

Relevância:

80.00% 80.00%

Publicador:

Relevância:

80.00% 80.00%

Publicador:

Relevância:

80.00% 80.00%

Publicador:

Resumo:

Geophysical surveys of the Mariana forearc, in an area equidistant from the Mariana Trench and the active Mariana Island Arc, revealed a 40-m-deep graben about 13 km northwest of Conical Seamount, a serpentine mud volcano. The graben and its bounding horst blocks are part of a fault zone that strikes northwest-southeast beneath Conical Seamount. One horst block was drilled during Leg 125 of the Ocean Drilling Program (Site 781). Three lithologic units were recovered at Site 781: an upper sedimentary unit, a middle basalt unit, and a lower sedimentary unit. The upper unit, between 0 and 72 mbsf, consists of upper Pliocene to Holocene diatomaceous and radiolarian-bearing silty clay that grades down into vitric silty clay and vitric clayey silt. The middle unit is a Pleistocene vesicular, porphyritic basalt, the top of which corresponds to a high-amplitude reflection on the reflection profiles. The lower unit is a middle to upper (and possibly some lower) Pliocene vitric silty clay and vitric clayey silt similar to the lower part of the upper unit. The thickness of the basalt unit can only be estimated to be between 13 and 25 m because of poor core recovery (28% to 55%). The absence of internal flow structures and the presence of an upper glassy chilled zone and a lower, fine-grained margin suggest that the basalt unit is either a single lava flow or a near-surface sill. The basalt consists of plagioclase phenocrysts with subordinate augite and olivine phenocrysts and of plagioclase-augite-olivine glomerocrysts in a groundmass of plagioclase, augite, olivine, and glass. The basalt is an island arc tholeiite enriched in large-ion-lithophile elements relative to high-field-strength elements, similar to the submarine lavas of the southern arc seamounts. In contrast, volcanic rocks from the active volcanoes on Pagan and Agrigan islands, 100 km to the west of the drill site, are calc-alkaline. The basalt layer, the youngest in-situ igneous layer reported from the Izu-Bonin and Mariana forearcs, is enigmatic because of its location more than 100 km from the active volcanic arc. The sediment layers above and below the basalt unit are late Pliocene in age (about 2.5 Ma) and normally magnetized. The basalt has schlierenlike structures, reverse magnetization, and a K-Ar age of 1.68±0.37 Ma. Thus, the basalt layer is probably a sill fed by magma intruded along a fault zone bounding the horst and graben in the forearc. The geochemistry of the basalt is consistent with a magma source similar to that of the active island arc and from a mantle source above the subducting Pacific plate.

Relevância:

80.00% 80.00%

Publicador:

Resumo:

Multibeam data were measured as part of the project HERMES during R/V Polarstern cruise ARK-XXII/1 (2007-05-29 to 2007-07-25) along transits and survey profiles and partly during stationary work. Data were achieved mainly in the coastal areas of northern Norway, at the Hakon Mosby Mud Volcano at the continental margin approx. 200 nm off the norwegian coast and the AWI-Hausgarten area approx. 150 nm west of Svalbard. A number of surveys were carried out in the coastal areas of northern Norway (Sula Reef, Roest Reef, Traena area, Floholmen area, Sotbakken area) and around the area of the Hakon Mosby Mud Volcano. The multibeam sonar system Atlas Hydrosweep DS-2 (Atlas Hydrographic, http://www.atlashydro.com) was operated using 59 beams and 90° aperture angle. The refraction correction was achieved using CTD profiles measured during this cruise or, during transits, utilizing the system's own cross fan calibration. The quality of data might be reduced during bad weather periods or adverse sea ice conditions (only in the AWI-Hausgarten area). This dataset contains raw data that are not processed and thus may contain errors and blunders in depth and position.

Relevância:

80.00% 80.00%

Publicador:

Resumo:

Products of two mud volcanoes from the distal part of the Mediterranean Ridge accretionary complex have been investigated regarding their B, C, and O stable isotope signatures. The mud breccias have been divided into mud matrix, lithified clasts, biogenic deposits, and authigenic cements and crusts related to fluid flow and cementation. Isotope geochemistry is used to evaluate the depth of mobilization of each phase in the subduction zone. B contents and isotope ratios of the mud and mud clasts show a general trend of B enrichment and decreasing d11B values with increasing consolidation (i.e., depth). However, the majority of the clast and matrix samples relate to moderate depths of mobilization within the wedge (1-2 km below seafloor). The carbonate cements of most of these clasts as well as the authigenic crusts, however, provide evidence for a deep fluid influence, probably associated with the décollement at 5-6 km depth. This interpretation is supported by d13C ratios of the crust, which indicate precipitation of C from thermogenic methane, and by the d11B ratios of pore-water samples of mud-breccia drill cores. Clams (Vesicomya sp.) living adjacent to fluid vents have d11B and d18O values corresponding to brines known in the area, which acted as the parent solution for shell precipitation. Such brines are most likely Miocene pore waters trapped at deep levels within the backstop to the accretionary prism, probably prior to desiccation of the Mediterranean in the Messinian (6-5 Ma). Combining all results, deep fluid circulation and expulsion are identified as the main processes triggering mud liquefaction and extrusion, whereas brines contribute only locally. Given the high B contents, mud extrusion has to be considered a major backflux mechanism of B into the hydrosphere.