Oxygen isotope concentrations of minerals from the upper kilometer of the ocean crust, DSDP Hole 504B

DSDP Hole 504B is the deepest basement hole in the oceanic crust, penetrating through a 571.5 m pillow section, a 209 m lithologic transition zone, and 295 m into a sheeted dike complex. An oxygen isotopic profile through the upper crust at Site 504 is similar to that in many ophiolite complexes, where the extrusive section is enriched in 18O relative to unaltered basalts, and the dike section is variably depleted and enriched. Basalts in the pillow section at Site 504 have delta 18O values generally ranging from +6.1 to +8.5? SMOW (mean= +7.0?), although minor zeolite-rich samples range up to 12.7?. Rocks depleted in 18O appear abruptly at 624 m sub-basement in the lithologic transition from 100% pillows to 100% dikes, coinciding with the appearance of greenschist facies minerals in the rocks. Whole-rock values range to as low as +3.6?, but the mean values for the lithologic transition zone and dike section are +5.8 and +5.4?, respectively. Oxygen and carbon isotopic data for secondary vein minerals combined with the whole rock data provide evidence for the former presence of two distinct circulation systems separated by a relatively sharp boundary at the top of the lithologic transition zone. The pillow section reacted with seawater at low temperatures (near 0°C up to a maximum of around 150°C) and relatively high water/rock mass ratios (10-100); water/rock ratios were greater and conditions were more oxidizing during submarine weathering of the uppermost 320 m than deeper in the pillow section. The transition zone and dikes were altered at much higher temperatures (up to about 350°C) and generally low water/rock mass ratios (~1), and hydrothermal fluids probably contained mantle-derived CO2. Mixing of axial hydrothermal fluids upwelling through the dike section with cooler seawater circulating in the overlying pillow section resulted in a steep temperature gradient (~2.5°C/m) across a 70 m interval at the top of the lithologic transition zone. Progressive reaction during axial hydrothermal metamorphism and later off-axis alteration led to the formation of albite- and Ca-zeolite-rich alteration halos around fractures. This enhanced the effects of cooling and 18O enrichment of fluids, resulting in local increases in delta 18O of rocks which had been previously depleted in 18O during prior axial metamorphism.

Ages of rocks and minerals from the Okhotsk-Chukotka volcanic belt

Current geochronological data on the Okhotsk-Chukotka volcanic belt (OCVB) and relevant problems are discussed. The belt evolution is suggested to be modeled based on 40Ar/39Ar and U-Pb dates more useful in several aspects than common K-Ar or Rb-Sr dates and methods of paleobotanical correlation. Based on new40Ar/39Ar and U-Pb dates obtained for volcanic rocks in the OCVB northern part, the younger (Coniacian) age is established for lower stratigraphic units in the Central Chukotka segment of the belt, and eastward migration of volcanic activity is shown for terminal stages of this structure evolution.

Minerals and geochemistry abundance and occurance, as well as K-Ar determinations for DSDP Site 92-597 basalts

Preliminary studies of hydrothermally altered massive basalts formed at the fast-spreading Mendoza Rise and recovered from DSDP Holes 597B and 597C indicate the presence of three secondary mineral assemblages which formed in the following order: (1) trioctahedral chlorite and talc, (2) goethite and smectite, and (3) calcite and celadonite. The sequential precipitation of these mineral assemblages denotes high water:rock ratios and time-varying conditions of temperature (early >200°C to late <30°C) and state of oxidation (early nonoxidative to late oxidative). A decrease in the relative proportion of oxidative mineral assemblages with depth to 70 m in Site 597 basement indicates a zone of oxidative alteration that became shallower with time as the deeper, more constricted fracture systems were filled by secondary mineralization. In this report we present the first results of the K-Ar dating of celadonite formation age; celadonite formation reflects end-stage hydrothermal alteration in Site 597 basement. Three celadonite dates obtained from Site 597 samples include 13.1 ± 0.3 m.y. from 17 m basement depth (Hole 597B), 19.9 ± 0.4 m.y. from 18 m basement depth (Hole 597C), and 19.3 ± 1.6 m.y. from 60 m basement depth (Hole 597C). The age of host rock crystallization (28.6 m.y.) and the K-Ar dates of celadonite formation establish that hydrothermal alteration in the upper 70 m of Site 597 basement continued for at least 10 m.y. and possibly as long as 16 m.y. after basalt crystallization at the ridge crest. Assuming a half-spreading rate of 55 km/m.y., we calculate that hydrothermal circulation was active in shallow basement at a distance of at least 550 km off ridge crest and possibly as far as 1000 km off ridge crest.

Chemical composition of rocks and minerals from the Mid-Atlantic Ridge near 15°20'N

The monograph summarizes results of petrological and geochemical studies of rocks from the ocean floor collected by the authors during expeditions to the Central Atlantic. Detailed work in the Capa Verde transform fault zone gave a large amount of new information about magmatic and hydrothermal systems of the Mid-Atlantic Ridge.

Clay minerals in Mesozoic and Cenozoic sediments at DSDP Leg 62 Holes

The main tasks of this study were (1) identification of minerals of the clay fraction, (2) identification of clay-mineral associations in relation to stratigraphic intervals, and (3) elucidation of genetic relations of clay minerals with types of sediments and factors of sedimentation. Identification of clay minerals was carried out mainly with an X-ray diffractometer (DRON-I). X-ray diffractograms were prepared by means of CuKalpha radiation, at 35 kW and a current of 20 ma. The scanning rate was 2°/min. Oriented specimens were prepared for the <1-µm fraction (and partly for the <10-µm fraction because of insufficient core material) in three states: air-dried, saturated with glycerine, and heated at 550°C.

Minerals, geochemistry and x-ray power characteristics at DSDP Sites 54-424, 60-458 and 60-459

Secondary minerals filling veins and vesicles in volcanic basement at Deep Sea Drilling Project Sites 458 and 459 indicate that there were two stages of alteration at each site: an early oxidative, probably hydrothermal, stage and a later, low-temperature, less oxidative stage, probably contemporaneous with faulting in the tectonically active Mariana forearc region. The initial stage is most evident in Hole 459B, where low-Al, high Fe smectites and iron hydroxides formed in vesicles in pillow basalts and low-Al palygorskite formed in fractures. Iron hydroxides and celadonite formed in massive basalts next to quartz-oligoclase micrographic intergrowths. Palygorskite was found in only one sample near the top of basement in Hole 458, but it too is associated with iron hydroxides. Palygorskite has previously been reported only in marine sediments in DSDP and other occurrences. It evidently formed here as a precipitate from fluids in which Si, Mg, Fe, and even some Al were concentrated. Experimental data suggest that the solutions probably had high pH and somewhat elevated temperatures. The compositions of associated smectites resemble those in hydrothermal sediments and in basalts at the Galapagos mounds geothermal field. The second stage of alteration was large-scale replacement of basalt by dioctahedral, trioctahedral, or mixed-layer clays and phillipsite along zones of intense fracturing, especially near the bottom of Holes 458 and 459B. The basalts are commonly slickensided, and there are recemented microfault offsets in overlying sediments. Native copper occurs in one core of Hole 458, but associated smectites are dominantly dioctahedral, unlike Hole 459B, where they are mainly trioctahedral, indicating nonoxidative alteration. The alteration in both holes is more intense than at most DSDP ocean crust sites and may have been augmented by water derived from subducting ocean crust beneath the fore-arc region.

Minerals of bulk samples and the fine-grained (<2-µm) fractions from DSDP Leg 67 Holes

Leg 67 sample sediments are mainly composed of biogenic carbonate and biogenic siliceous materials. Apart from calcite, crystallized minerals are scarce; however, they are better represented in sites near the continent and in all Quaternary sediments. These minerals are: quartz, feldspars, smectite, and, rarely, chlorite, dolomite, and zeolite.

Geochemistry and minerals of glass shards at DSDP Leg 66 Holes

Deep Sea Drilling Project Leg 66 drilled eight sites along a transect across the Middle America Trench off Mexico, including continental (Sites 493 and 489), oceanic (Site 487), and trench (Site 486) reference sites and four sites (490, 492, 491, 488) in the trench inner wall. Because of their location - close to volcanic sources and subject to prevailing winds and marine currents (N to S, NW to SE) - analysis of airborne ashes intercalated within the sediments at these sites provides a reliable record of explosive volcanism in the area. Intense onshore volcanic activity in Mexico during the Oligo-Miocene has been well documented by the andesites and ignimbrites of the Sierra Madre Occidental and Sierra Madre del Sur and in the Plio-Quaternary by the andesites and basalts from the Trans-Mexican Neovolcanic Belt and the eastern border of Baja California.

Geochemical compositions of minerals from chilled dike margins of ODP Hole 140-504B

Mineral and whole-rock geochemical data are presented for chilled dike margins from the lower sheeted dike complex of Deep Sea Drilling Project/Ocean Drilling Program (DSDP/ODP) Hole 504B. Compositions of phenocrystic plagioclase (An80-89); olivine (Fo82-86); clinopyroxene (Wo52En40Fs8, with Cr2O3 up to 1.2%); and rare chromian spinel (Cr# 43) are consistent with those from the lavas and the upper dike complex recovered previously (DSDP Legs 69, 70, 83, and ODP Leg 111). Major and trace element compositions fall in group D of Autio and Rhodes (1983) and have high CaO/Na2O, and low TiO2, K2O, and (La/Sm)N values consistent with previous analyses from this site.

Age of bottom sediments and minerals from the Atlantic and Pacific oceans

Application of nuclear geochronology methods in study of recent sedimentation processes, in paleoceanology, tectonics, geomorphology, and other problems associated with accumulation of sedimentary material in oceans and seas are under consideration in the book. A comparative analysis of dating results obtained by biostratigraphy, paleomagnetic and nuclear geochronology methods is given.

Geochemistry and minerals at DSDP Leg 65 Holes

Petrologic studies of mid-ocean ridge basalt (MORB) (e.g., Melson et al., 1975; Flower, et al., 1977; Byerly and Wright, 1978; Melson, 1979; Byerly and Sinton, 1980; Thompson, 1980) show that magmatic liquid-fraction trends are indicated by the compositions of fresh glass selvedges, usually, but not always, associated with pillow basalts. In contrast, whole-rock compositional variation will often reflect the complicating effects of syn- and post-eruptive phenocryst accumulation. Additional variation may be introduced by the reaction of basalts with seawater. While comparatively severe alteration of variable type was noted locally in the young basalts recovered across the mouth of the Gulf of California on Leg 65, most of the basalts were extremely fresh, making them ideal for studies of compositional variation.