Parameters of the Earths orbit for the last 5 Million years in 1 kyr resolution

New values for the astronomical parameters of the Earth's orbit and rotation (eccentricity, obliquity and precession) are proposed for paleoclimatic research related to the Late Miocene, the Pliocene and the Quaternary. They have been obtained from a numerical solution of the Lagrangian system of the planetary point masses and from an analytical solution of the Poisson equations of the Earth-Moon system. The analytical expansion developed in this paper allows the direct determination of the main frequencies with their phase and amplitude. Numerical and analytical comparisons with the former astronomical solution BER78 are performed so that the accuracy and the interval of time over which the new solution is valid can be estimated. The corresponding insolation values have also been computed and compared to the former ones. This analysis leads to the conclusion that the new values are expected to be reliable over the last 5 Ma in the time domain and at least over the last 10 Ma in the frequency domain.

(Table 1) Soil physical parameters of sediments obtained in the Lüchow-Dannenberg district, Lower Saxony

The mobility of the radionuclides of the elements Sr, I, Cs and Ce were investigated for three typical sands of Northern Germany under simulated natural, undersaturated flow conditions. The laboratory experiments include the determination of the flow parameters of the seepwater movement as well as the transport velocities of the radionuclides in the sands. For the three selected sands, the following mobility sequence/order has been established for the radionuclides: I < Sr < Cs < Ce

Magnetic susceptibility parameters of ODP Leg 204 sites

In this paper, we present a rock magnetic data set produced for sediments from Hydrate Ridge recovered during Ocean Drilling Program Leg 204. Our data set is based on several artificially induced magnetic properties that can be used as a diagnostic for the presence of magnetic iron sulfides. The occurrence of magnetic iron sulfides within the gas hydrate stability zone in locations where gas hydrates are present seems to confirm previous interpretations linking formation of such minerals with generation of gas hydrate. Magnetic iron sulfides are also found at positions deeper than the gas hydrate stability zone. We suggest that these positions, which include intervals located just below the bottom-simulating reflector and also at deeper positions, may mark the former presence of gas hydrates that have been later dissociated as the gas hydrate stability zone moved upward through time. Detailed characterization of the magnetic iron sulfide mineralogy and comparison with sedimentological and geochemical data will be attempted for better determining the significance of magnetic iron sulfides in Hydrate Ridge sediments and their possible applications in the study of gas hydrates.

Some parameters of distribution of hydrocarbon paraffin fraction in bottom sediments of the Kara Sea and the Yenisey estuary

During Cruise 49 of R/V Dmitry Mendeleev in the Kara Sea (August-September, 1993) chemical-bitumenological studies of bottom sediments were carried out. Hydrocarbons were analyzed by gas-liquid chromatography. It was found on the basis of distribution of n-alkanes and isoprenoids (pristan and phytan) that organic matter is mainly terrigenous consisting of higher plant remains.

(Table 1) Conditions of vertical near-bottom profiling and the main parameters of the benthic boundary layer in several regions of the Black Sea shelf

Measurements of 14 vertical profiles of currents and hydrological parameters in the near-bottom layer with depth resolution of 0.1 m were carried out in several regions of the Black Sea shelf, at five points over the continental slope, and in three deep water regions. The upper boundary of the benthic boundary layer (BBL) was reliably determined at a point at distance from 5-7 to 35-40 m from the bottom where the gradients of density and current velocity changed. Experimental data obtained were used to determine the coefficient of bottom friction, friction velocity, coefficients of vertical diffusion of momentum and density, and vertical fluxes of temperature and salinity in the BBL.

Geochemical parameters of bottom sediments from the Tajura Rift, Gulf of Aden

Results of a geochemical study of bottom sediments from the Tadjura rift zone are reported. The sediments were analyzed for CaCO3, Si, Al, Ti, Fe, Mn, Cu, Zn, Ni, Co, Cr, V, Zr, Ga, Yb and Y. It was found that formation of chemical composition of the sediments was controlled by factors being appropriate for a near-continental area of the arid climatic zone (aeolian supply of terrigenous material and high biological productivity), as well as by hydrothermal activity in the rift valley. It was shown that high Mn contents were typical for the sediments in study while maximal contents of Fe were found near supposed hydrothermal sources. Total flux of Mn into sediments was been calculated. Diagenetic redistribution gives the main contribution of Mn in surface layer sediments. Speciations of Fe, Mn, Cu, Zn, Ni, Co, and Al were studied. In the surface layer sediments iron and manganese were in hydroxides. Model calculations of contents of chemical elements in sediments of the area in study are given.

Total organic carbon, bitumen ratio, hopane and sterane parameters of ODP Sites 128-798 and 128-799

Notable compositional changes of organic matter are observed below the silica transition zone in thermally immature sediments. The increase of bitumen ratio, and hopane and sterane isomerization parameters indicate an acceleration of the kinetics of the chemical reactions which transform the organic matter. This phenomenon is probably due to the numerous mineral and textural changes induced by the transformation of amorphous biogenic silica into crystalline authigenic silica.

(Table 1) Sample characteristics, test consolidations and calculated elastic parameters of ODP Sites 194-1193 and 194-1196

This study is based on rock mechanical tests of samples from platform carbonate strata to document their petrophysical properties and determine their potential for porosity loss by mechanical compaction. Sixteen core-plug samples, including eleven limestones and five dolostones, from Miocene carbonate platforms on the Marion Plateau, offshore northeast Australia, were tested at vertical effective stress, sigma1', of 0-70 MPa, as lateral strain was kept equal to zero. The samples were deposited as bioclastic facies in platform-top settings having paleo-water depths of <10-90 m. They were variably cemented with low-Mg calcite and five of the samples were dolomitized before burial to present depths of 39-635 m below sea floor with porosities of 8-46%. Ten samples tested under dry conditions had up to 0.22% strain at sigma1' = 50 MPa, whereas six samples tested saturated with brine, under drained conditions, had up to 0.33% strain. The yield strength was reached in five of the plugs. The measured strains show an overall positive correlation with porosity. Vp ranges from 3640 to 5660 m/s and Vs from 1840 to 3530 m/s. Poisson coefficient is 0.20-0.33 and Young's modulus at 30 MPa ranged between 5 and 40 GPa. Water saturated samples had lower shear moduli and slightly higher P- to S-wave velocity ratios. Creep at constant stress was observed only in samples affected by pore collapse, indicating propagation of microcracks. Although deposited as loose carbonate sand and mud, the studied carbonates acquired reef-like petrophysical properties by early calcite and dolomite cementation. The small strains observed experimentally at 50 MPa indicate that little mechanical compaction would occur at deeper burial. However, as these rocks are unlikely to preserve their present high porosities to 4-5 km depth, further porosity loss would proceed mainly by chemical compaction and cementation.