Age and clay mineralogy on sediment core GeoTü SL112 from the Mediterranean Sea

The present-day clay mineral distribution in the southeastern Levantine Sea and its borderlands reveals a complex pattern of different sources and distribution paths. Smectite dominates the suspended load of the Nile River and of rivers in the Near East. Illite sources are dust-bearing winds from the Sahara and southwestern Europe. Kaolinite is prevalent in rivers of the Sinai, in Egyptian wadis, and in Saharan dust. A high-resolution sediment core from the southeastern Levantine Sea spanning the last 27 ka shows that all these sources contributed during the late Quaternary and that the Nile River played a very important role in the supply of clay. Nile influence was reduced during the glacial period but was higher during the African Humid Period. In contrast to the sharp beginning and end of the African Humid Period recorded in West African records (15 and 5.5 ka), our data show a more transitional pattern and slightly lower Nile River discharge rates not starting until 4 ka. The similarity of the smectite concentrations with fluctuations in sea-surface temperatures of the tropical western Indian Ocean indicates a close relationship between the Indian Ocean climate system and the discharge of the Nile River.

Calculated sea surface temperatures of two sediment cores

The reconstruction of ocean history employs a large variety of methods with origins in the biological, chemical, and physical sciences, and uses modern statistical techniques for the interpretation of extensive and complex data sets. Various sediment properties deliver useful information for reconstructing environmental parameters. Those properties that have a close relationship to environmental parameters are called ''proxy variables'' (''proxies'' for short). Proxies are measurable descriptors for desired (but unobservable) variables. Surface water temperature is probably the most important parameter for describing the conditions of past oceans and is crucial for climate modelling. Proxies for temperature are: abundance of microfossils dwelling in surface waters, oxygen isotope composition of planktic foraminifers, the ratio of magnesium or strontium to calcium in calcareous shells or the ratio of certain organic molecules (e.g. alkenones produced by coccolithophorids). Surface water salinity, which is important in modelling of ocean circulation, is much more difficult to reconstruct. At present there is no established method for a direct determination of this parameter. Measurements associated with the paleochemistry of bottom waters to reconstruct bottom water age and flow are made on benthic foraminifers, ostracodes, and deep-sea corals. Important geochemical tracers are d13C and Cd/Ca ratios. When using benthic foraminifers, knowledge of the sediment depth habitat of species is crucial. Reconstructions of productivity patterns are of great interest because of important links to current patterns, mixing of water masses, wind, the global carbon cycle, and biogeography. Productivity is reflected in the flux of carbon into the sediment. There are a number of fluxes other than those of organic carbon that can be useful in assessing productivity fluctuations. Among others, carbonate and opal flux have been used, as well as particulate barite. Furthermore, microfossil assemblages contain clues to the intensity of production as some species occur preferentially in high-productivity regions while others avoid these. One marker for the fertility of sub-surface waters (that is, nutrient availability) is the carbon isotope ratio within that water (13C/12C, expressed as d13C). Carbon isotope ratios in today's ocean are negatively correlated with nitrate and phosphate contents. Another tracer of phosphate content in ocean waters is the Cd/Ca ratio. The correlation between this ratio and phosphate concentrations is quite well documented. A rather new development to obtain clues on ocean fertility (nitrate utilization) is the analysis of the 15N/14N ratio in organic matter. The fractionation dynamics are analogous to those of carbon isotopes. These various ratios are captured within the organisms growing within the tagged water. A number of reconstructions of the partial pressure of CO2 have been attempted using d13C differences between planktic and benthic foraminifers and d13C values of bulk organic material or individual organic components. To define the carbon system in sea water, two elements of the system have to be known in addition to temperature. These can be any combination of total CO2 , alkalinity, or pH. To reconstruct pH, the boron isotope composition of carbonates has been used. Ba patterns have been used to infer the distribution of alkalinity in past oceans. Information relating to atmospheric circulationand climate is transported to the ocean by wind or rivers, in the form of minerals or as plant andanimal remains. The most useful tracers in this respect are silt-sized particles and pollen.

Siliceous microplankton in surface sediments and the water column of the Red Sea

We studied the siliceous microplankton assemblages (mainly diatoms) from plankton tows (mesh size 20 µm) and surface sediment samples collected along a N-S transect in the northern Red Sea (28-21°N). In addition, we analyzed differences/similarities between plankton and sediment assemblages within a brine-filled basin (the southern basin) of the Shaban Deep and compared these assemblages with those from outside the brine. Plankton samples revealed the overwhelming dominance of diatoms over other siliceous groups. Diatoms accounted for ca. 97% of all biosiliceous particles at 120-20 m (vs. 2.9% silicoflagellates and 0.4% radiolarians), and ca. 94% at 200-120 m (vs. 4.5% silicoflagellates and 1.6% radiolarians). In general, a marine, warm-water (tropical/subtropical) diatom assemblage characterizes the plankton samples. Representatives of the Nitzschia bicapitata group are by far the most abundant contributors at both depth intervals (average=43%), ranging from ca. 30% in the North to ca. 60% in the South. Biogenic opal content in non-brine surface sediments is very low, (below 0.2 wt.% SiO2); and concentration of siliceous microorganisms is also low and of the order of 5*10**3-10**4 microorganisms/g dry sediment. Diatoms are the main contributors to the opal signal in the 20-40 µm fraction, while they share dominance with radiolarians in the >40 µm fraction. Total diatom concentrations average 1.2*10**4 valves/g in the 20-40 µm fraction and 4*10**3 valves/g in the >40 µm fraction. Robust taxa of warm water affinity (Alveus marinus, Azpeitia neocrenulata, Azpeitia nodulifera and Roperia tesselata) characterize the surface sediments. In contrast, biogenic opal content in brine surface sediment samples is much higher than in the non-brine samples, ranging from 2.8 to 3.8 wt.% SiO2, and concentration of siliceous microorganisms is 3-4 orders of magnitude higher. In addition here, diatoms dominate the opal signal. The taxa found in these samples are a mixture of non-brine and plankton samples, and fragile forms (e.g., N. bicapitata group, Neodelphineis indica) are well preserved in these sediments. Thus, brine sediments in this region seem to offer a great potential for palaeoenvironmental studies.

(Table 4) Estimated surface water phosphate concentrations for the past 200 kyr at the location of sediment core GeoB1016-3

We compared ocean atlas values of surface water [PO4]3- and [CO2(aq)] against the carbon isotopic fractionation (ep) of alkenones obtained from surface sediments of the South Atlantic and the central Pacific (Pacific data are from Pagani et al. 2002, doi:10.1029/2002PA000756). We observed a positive correlation between ep and 1/[CO2(aq)], which is opposite of what would be expected if the concentration of CO2(aq) were the major factor controlling the carbon isotopic fractionation of C37:2 alkenones. Instead, we found inverse relationships between ep and [PO4]3- for the two ocean basins (for the Atlantic, ep = -4.6*[PO4]3- + 15.1, R = 0.76; for the Pacific, ep = -4.1*[PO4]3- + 13.7, R = 0.64), suggesting that ep is predominantly controlled by growth rate, which in turn is related to nutrient concentration. The similarity of the slopes implies that a general relationship between both parameters may exist. Using the relationship obtained from the South Atlantic, we estimated surface water nutrient concentrations for the past 200,000 years from a deep-sea sediment core recovered off Angola. Low ep values, indicating high nutrient concentrations, coincide with high contents of total organic carbon and C37 alkenones, low surface water temperatures, and decreased bulk d15N values, suggesting an increased upwelling of nutrient-rich cool subsurface waters as the main cause for the observed ep decrease.

Terrestrial organic matter in marine sediments of the Central Equatorial Atlantic

Terrestrial organic matter (OM) in pelagic sediments is discussed with regard to depositional processes and land-sea interactions in the modern and past glacial/interglacial Equatorial Atlantic. Special emphasis is placed on a critical evaluation of different analytical approaches (C/N, Rock-Eval Pyrolysis, stable carbon isotopes, palynology, organic petrology, and selected biomarkers) which are currently used for the qualitative and quantitative assessment of terrigenous organic carbon. If binary mixing equations are used to calculate terrestrial and marine proportions of organic carbon, we consider the definition of endmember values to be most critical since these values may be biased by a great number of independent controls. A combination of geochemical methods including optical studies (organic petrology and palynology) is therefore suggested to evaluate each individual proxy. Organic geochemical analyses performed on sediments from the modern and Late Quaternary Equatorial Atlantic evidence fluctuations in eolian supply of terrigenous OM related to changes in intensity of the trade winds. Quantification of this organic fraction leads to differing proportions depending on the approach applied, i.e. the organic carbon isotopic composition or maceral analyses. Modern distribution of terrigenous OM reveals a decrease in supply towards the basin contributing less than a fifth of the total OM in pelagic areas. Organic geochemical data indicate that sedimentation in the modern northeastern Brasil Basin is affected by lateral advection of reworked OM probably from southern source areas. Glacial/interglacial deposits from the pelagic Equatorial Atlantic (ODP Site 663), covering isotopic stages 12 and 11, reveal that deposition of terrigenous OM was higher under past glacial conditions, in correspondence to generally enhanced dust fluxes. Proportions of terrigenous OM, however, never exceed 50% of the total OM according to maceral analyses. Other estimates, recently proposed by Verardo and Ruddiman (1996), are considered to be too high probably for analytical reasons. Palynological records in the Equatorial Atlantic parallel dust records. Increased portions of grass pollen suggest the admixture of C4-plant material under modern and past glacial conditions. It is therefore assumed, as one possible interpetation, that C4-plant debris has an effect on sedimentary d13Corg and might explain differences between isotopic and microscopic quantitative estimates. Using the difference between these two records, we calculate that maximum supply of C4-material remains below 20% of the total OM for the deep modern and past glacial/interglacial Equatorial Atlantic.

Mid-Pliocene deep-sea bottom water temperatures based on ostracode Mg/Ca ratios

We studied magnesium:calcium (Mg/Ca) ratios in shells of the deep-sea ostracode genus Krithe from a short interval in the middle Pliocene between 3.29 and 2.97 Ma using deep-sea drilling sites in the North and South Atlantic in order to estimate bottom water temperatures (BWT) during a period of climatic warmth. Results from DSDP and ODP Sites 552A, 610A, 607, 658A, 659A, 661A and 704 for the period Ma reveal both depth and latitudinal gradients of mean Mg/Ca values. Shallower sites (552A, 610A and 607) have higher mean Mg/Ca ratios (10.3, 9.7, 10.1 mmol/mol) than deeper sites (661A, 6.3 mmol/mol), and high latitude North Atlantic sites (552A, 610 and 607) have higher Mg/Ca ratios than low latitude (658A: 9.8 mmol/mol, 659A: 7.7 mmol/mol, 661A: 6.3 mmol/mol) and Southern Ocean (704: 8.0 mmol/mol) sites. Converting Mg/Ca ratios into estimated temperatures using the calibration of Dwyer et al. (1995) [Dwyer, G.S., Cronin, T.M., Baker, P.A., Raymo, M.E., Buzas, J.S., Corrège, T., 1995. North Atlantic deepwater temperature change during late Pliocene and late Quaternary climatic cycles. Science 270, 1347-1351] suggests that mean middle Pliocene bottom water temperatures at the study sites in the deep Atlantic were about the same as modern temperatures. However, brief pulses of elevated BWT occurred several times between 3.29 and 2.97 Ma in both the North and South Atlantic Ocean suggesting short-term changes in deep ocean circulation.

Alkenone variations, total organic carbon and stable oxygen isotope ratios of the western Arabian Sea

We here present records of total organic carbon (TOC) and C37 alkenones, used as indicators for past primary productivity, from the western (WAS) and eastern Arabian Sea (EAS). New data from an open ocean site of the WAS upwelling area are compared with similar records from Ocean Drilling Program (ODP) Site 723 from the continental margin off Oman and MD 900963 from the EAS. These records together with other proxies used to reconstruct upwelling intensity, indicate periods of high productivity in tune with precessional forcing. On the basis of their phase relationship to boreal summer insolation they can be divided into three groups: in the WAS differences between monsoonal proxies (1) and productivity (2) document a combined signal of moderate SW monsoon winds and of strengthened and prolonged NE monsoon winds, whereas in the EAS phasing indicates maximum productivity (3) at times of stronger NE monsoon winds associated with precession-related maxima in ice volume.

Geochemistry of bulk sediment from the Cape Basin

A technique for onsite application of X-ray fluorescence (XRF) spectrometry to samples from sediment cores aboard a research vessel was developed and tested. The method is sufficiently simple, precise, and fast to be used routinely for high-resolution analyses of depth profiles as well as surface samples. Analyses were performed with the compact high-performance energy-dispersive polarisation X-ray fluorescence (EDPXRF) analyser Spectro Xepos. Contents of the elements Si, Ti, Al, Fe, Mn, Mg, Ca, K, Sr, Ba, Rb, Cu, Ni, Zn, P, S, Cl and Br were simultaneously determined on 200-225 samples of each core within 24 h of recovery. This study presents a description of the employed shipboard preparation and analysis technique, along with some example data. We show land-based datasets that support our decisions to use powder samples and to reduce the original measuring time for onboard analyses. We demonstrate how well the results from shipboard measurements for the various elements compare with the land-based findings. The onboard geochemical data enabled us to establish an element stratigraphy already during the cruise. Correlation of iron, calcium and silicon enrichment trends with an older reference core provided an age model for the newly retrieved cores. The Spectro Xepos instrument performed without any analytical and technical difficulties which could have been caused by rougher weather conditions or continuous movement and vibration of the research vessel. By now, this XRF technique has been applied during three RV Meteor cruises to approximately 5,000 Late Quaternary sediment samples from altogether 23 gravity cores, 25 multicorer cores and two box cores from the eastern South Atlantic off South Africa/Namibia and the eastern Atlantic off NW Africa.