Seawater carbonate chemistry and hydrogen ions and carbonate chemistry in calcifying fluid of coral Astrangia poculata during experiments, 2011

A generalized physicochemical model of the response of marine organisms' calcifying fluids to CO2-induced ocean acidification is proposed. The model is based upon the hypothesis that some marine calcifiers induce calcification by elevating pH, and thus Omega aragonite, of their calcifying fluid by removing protons (H+). The model is explored through two end-member scenarios: one in which a fixed number of H+ is removed from their calcifying fluid, regardless of atmospheric pCO2, and another in which a fixed external-internal proton ratio ([H+]E/[H+]I) is maintained. The model is able to generate the full range of calcification response patterns observed in prior ocean acidification experiments and is consistent with the assertion that organisms' calcification response to ocean acidification is more negative for marine calcifiers that exert weaker control over their calcifying fluid pH. The model is empirically evaluated for the temperate scleractinian coral Astrangia poculata with in situ pH microelectrode measurements of the coral's calcifying fluid under control and acidified conditions. These measurements reveal that (1) the pH of the coral's calcifying fluid is substantially elevated relative to its external seawater under both control and acidified conditions, (2) the coral's [H+]E/[H+]I remains constant under control and acidified conditions, and (3) the coral removes fewer H+ from its calcifying fluid under acidified conditions than under control conditions. Thus, the carbonate system dynamics of A. poculata's calcifying fluid appear to be most consistent with the fixed [H+]E/[H+]I end-member scenario. Similar microelectrode experiments performed on additional taxa are required to assess the model's general applicability.

Sedimentology and geochemistry of ODP Leg 129 siliceous deposits

Siliceous deposits drilled on Ocean Drilling Program Leg 129 accumulated within a few degrees of the equator during the Jurassic through early Tertiary, as constrained by paleomagnetic data. During the Jurassic and Early Cretaceous, radiolarian ooze, mixed with a minor amount of pelagic clay, was deposited near the equator, and overall accumulation rates were moderate to low. At a smaller scale, in more detail, periods of relatively higher accumulation rates alternated with periods of very low accumulation rates. Higher rates are represented by radiolarite and limestone; lower rates are represented by radiolarian claystone. Our limited data from Leg 129 suggests that accumulation of biogenic deposits was not symmetrical about the equator or consistent over time. In the Jurassic, sedimentation was siliceous; in the Cretaceous there was significant calcareous deposition; in the Tertiary claystone indicates significantly lower accumulation rates at least the northern part of the equatorial zone. Accumulation rates for Leg 129 deposits in the Cretaceous were higher in the southern part of the equatorial zone than in the northern part, and the southern side of this high productivity zone extended to approximately 15°S, while the northern side extended only to about 5°N. Accumulation rates are influenced by relative contributions from various sediment sources. Several elements and element ratios are useful for discriminating sedimentary sources for the equatorial depositional environments. Silica partitioning calculations indicate that silica is dominantly of biogenic origin, with a detrital component in the volcaniclastic turbidite units, and a small hydrothermal component in the basal sediments on spreading ridge basement of Jurassic age at Site 801. Iron in Leg 129 sediments is dominantly of detrital origin, highest in the volcaniclastic units, with a minor hydrothermal component in the basal sediments at Site 801. Manganese concentrations are highest in the units with the lowest accumulation rates. Fe/Mn ratios are >3 in all units, indicating negligible hydrothermal influence. Magnesium and aluminum concentrations are highest in the volcaniclastic units and in the basal sediments at Site 801. Phosphorous is very low in abundance and may be detrital, derived from fish parts. Boron is virtually absent, as is typical of deep-water deposits. Rare earth element concentrations are slightly higher in the volcaniclastic deposits, suggesting a detrital source, and lower in the rest of the lithologic units. Rare earth element abundances are also low relative to "average shale." Rare earth element patterns indicate all samples are light rare earth element enriched. Siliceous deposits in the volcaniclastic units have patterns which lack a cerium anomaly, suggesting some input of rare earth elements from a detrital source; most other units have a distinct negative Ce anomaly similar to seawater, suggesting a seawater source, through adsorption either onto biogenic tests or incorporation into authigenic minerals for Ce in these units. The Al/(Al + Fe + Mn) ratio indicates that there is some detrital component in all the units sampled. This ratio plotted against Fe/Ti shows that all samples plot near the detrital and basalt end-members, except for the basal samples from Site 801, which show a clear trend toward the hydrothermal end-member. The results of these plots and the association of high Fe with high Mg and Al indicate the detrital component is dominantly volcaniclastic, but the presence of potassium in some samples suggests some terrigenous material may also be present, most likely in the form of eolian clay. On Al-Fe-Mn ternary plots, samples from all three sites show a trend from biogenic ooze at the top of the section downhole to oceanic basalt. On Si-Fe-Mn ternary plots, the samples from all three sites fall on a trend between equatorial mid-ocean spreading ridges and north Pacific red clay. Copper-barium ratios show units that have low accumulation rates plot in the authigenic field, and radiolarite and limestone samples that have high accumulation rates fall in the biogenic field.

(Table 2) Concentrations of dissolved aluminum in interstitial water from sediments of the Indian Ocean

Results are presented of application of laser stepwise photoionization of atoms in combination with thermal atomization of matter in vacuum for direct determination of aluminum dissolved in sea and interstitial waters. Dry residue from evaporation of 40 ?l sea water was atomized in a crucible at 1800°C, and aluminum atoms in the beam thus formed were energized into Rydberg state in two steps by two tunable dye laser beams; the atoms were then ionized by an electric pulse and resulting ions were recorded by secondary emission electron multiplier (ion detector). Ionic signal dependence on sample vaporization time was studied. The procedure is suggested for separating out a selective signal in a single measurement. Dissolved aluminum concentrations in interstitial waters of the Indian Ocean and in waters of the river-sea zone were determined using preliminarily plotted calibration characteristics for aluminum solutions in deionized and sea waters. The minimum detectable Al concentration in seawater was 1 ?g/l that corresponds to 40 pg of Al in a sample.

Chemical composition of phosphorites from the Peru and Chile shelves

Recent and Late Quaternary shelf phosphorites have low Fe, Ti and Al contents. These elements enter the phosphorites with terrigenous impurities and organic detritus. Ti, Al, and some Fe are removed when the phosphorites are lithified, whereas remaining iron settles in the phosphorites as sulfides. Ti/Fe, Al/Fe and Ti/Al ratios are used as examples of difference between behavior of Fe and that of Ti and Al.