Detrital zircon geochronology data, petrographic point count data and paleocurrent indicator data of Triassic turbidites in the Nanpanjiang Basin, South China

Triassic turbidites of the Nanpanjiang basin of south China represent the most expansive and voluminous siliciclastic turbidite accumulation in south China. The Nanpanjiang basin occurs at a critical junction between the southern margin of the south China plate and the Indochina, Siamo and Sibumasu plates to the south and southwest. The Triassic Yangtze carbonate shelf and isolated carbonated platforms in the basin have been extensively studied, but silicilastic turbidites in the basin have received relatively little attention. Deciphering the facies, paleocurrent indicators and provenance of the Triassic turbidites is important for several reasons: it promises to help resolve the timing of plate collisions along suture zones bordering the basin to the south and southwest, it will enable evaluation of which suture zones and Precambrian massifs were source areas, and it will allow an evaluation of the impact of the siliciclastic flux on carbonate platform evolution within the basin. Turbidites in the basin include the Early Triassic Shipao Formation and the Middle-Late Triassic Baifeng, Xinyuan, Lanmu Bianyang and Laishike formations. Each ranges upward of 700 m and the thickest is nearly 3 km. The turbidites contain very-fine sand in the northern part of the basin whereas the central and southern parts of the basin also commonly contain fine and rarely medium sand size. Coarser sand sizes occur where paleocurrents are from the south, and in this area some turbidites exhibit complete bouma sequences with graded A divisions. Successions contain numerous alternations between mud-rich and sand-rich intervals with thickness trends corresponding to proximal/ distal fan components. Spectacularly preserved sedimentary structures enable robust evaluation of turbidite systems and paleocurrent analyses. Analysis of paleocurrent measurements indicates two major directions of sediment fill. The northern part of the basin was sourced primarily by the Jiangnan massif in the northeast, and the central and southern parts of the basin were sourced primarily from suture zones and the Yunkai massif to the south and southeast respectively. Sandstones of the Lower Triassic Shipao Fm. have volcaniclastic composition including embayed quartz and glass shards. Middle Triassic sandstones are moderately mature, matrix-rich, lithic wackes. The average QFL ratio from all point count samples is 54.1/18.1/27.8% and the QmFLt ratio is 37.8/ 18.1/ 44.1%. Lithic fragments are dominantly claystone and siltstone clasts and metasedimentary clasts such as quartz mica tectonite. Volcanic lithics are rare. Most samples fall in the recycled orogen field of QmFLt plots, indicating a relatively quartz and lithic rich composition consistent with derivation from Precambrian massifs such as the Jiangnan, and Yunkai. A few samples from the southwest part of the basin fall into the dissected arc field, indicating a somewhat more lithic and feldspar-rich composition consistent with derivation from a suture zone Analysis of detrial zircon populations from 17 samples collected across the basin indicate: (1) Several samples contain zircons with concordant ages greater than 3000 Ma, (2) there are widespread peaks across the basin at 1800 Ma and 2500, (3) a widespread 900 Ma population, (3) a widespread population of zircons at 440 Ma, and (5) a larger population of younger zircons about 250 Ma in the southwestern part which is replaced to the north and northwest by a somewhat older population around 260-290 Ma. The 900 Ma provenance fits derivation from the Jiangnan Massif, the 2500, 1800, and 440 Ma provenance fits the Yunkai massif, and the 250 Ma is consistent with convergence and arc development in suture zones bordering the basin on the south or southwest. Early siliciclastic turbidite flux, proximal to source areas impacted carbonate platform evolution by infilling the basin, reducing accommodation space, stabilizing carbonate platform margins and promoting margin progradation. Late arrival, in areas far from source areas caused margin aggradation over a starved basin, development of high relief aggradational escarpments and unstable scalloped margins.

Geochemistry and lithology of clayey nannofossil ooze turbidites and hemipelagites at ODP Holes 135-834A and 135-835A

The western Lau Basin, between the Central and Eastern Lau Spreading Centers and the Lau Ridge, contains several small, elongate, fault-bounded, partially sediment-filled sub-basins. Sites 834 and 835 were drilled in the oldest part of the Lau Basin in two of these small extensional basins close to the Lau Ridge, formed on late Miocene to early Pliocene oceanic crust. Both sites show a similar sediment sequence that consists of clayey nannofossil oozes and mixed sediments interbedded with epiclastic vitric sands and silts. The vitric sands and silts are largely restricted to the deeper part of the sediment column (early Pliocene-late Pliocene), and the upper part of the sediment column at both sites consists of a distinctive sequence of brown clayey nannofossil ooze, stained by iron and manganese oxyhydroxides (late Pliocene-Holocene). However, the clayey nannofossil ooze sequence at Site 835 is anomalously thick and contains several medium- to very thick beds of matrix-supported, mud-clast conglomerate (interpreted as muddy debris-flow deposits), together with large amounts of redeposited clayey nannofossil ooze and coherent rafted blocks of older hemipelagic material. Redeposited clayey nannofossil oozes can be distinguished from hemipelagic nannofossil oozes using several sedimentological criteria. These include variation in color hue and chroma, presence or absence of bioturbation, presence or absence of scattered foraminifers, grain-size characteristics, variability in calcium carbonate content, presence or absence of pumice clasts, and micropaleontology. Clayey nannofossil ooze turbidites and hemipelagites are also geochemically distinct, with the turbidites being commonly enriched in Mn, Ni, Pb, Zn, Cr, and P. The sediment sequence at Site 835 is dominated by allochthonous sediments, either muddy debris-flow deposits, coherent rafted blocks, or thick clayey nannofossil ooze turbidites. Since 2.9 Ma, only 25% of the 133 m of sediments deposited represents hemipelagic deposition, with an average sedimentation rate of 1.5 cm/k.y.. Allochthonous sediments were the main sediment type deposited during the Brunhes geomagnetic Epoch and make up 80% of the thickness of sediment deposited during this period. Short intervals of mainly hemipelagic deposition occurred from 0.4 to 0.9 Ma, 1.0 to 1.4 Ma, and 1.7 to 2.1 Ma. However, allochthonous sediments were again the dominant sediment type deposited between 2.1 and 2.5 Ma, with a large slide complex emplaced around 2.5 Ma. We conclude that the adjacent high ground, surrounding the basin in which Site 835 was drilled, was affected by marked instability throughout the late Pliocene and Pleistocene. In contrast, sedimentation at Site 834 during this period has been dominated by hemipelagic deposition, with redeposited sediments making up slightly less than 17% of the total thickness of sediment deposited since 2.3 Ma. However, there was a marked increase in frequency and magnitude of redeposited sediments at around 0.2 Ma at Site 834, which broadly corresponds to the onset of a major episode of turbidite and debris-flow emplacement beginning about 0.4 Ma at Site 835. This episode of instability at both sites may be the effect of the approach and passing of the Central Lau propagator at the latitude of Sites 834 and 835 at about 0.5 Ma.

Grain size analysis on core plugs of sediment core CRP-1 (Table 1, 2)

Twenty four core samples from CRP-1, seven from Quaternary strata (20-43.55 meters below sea floor or mbsf) and seventeen from early Miocene strata (43.55 to 147.69 mbsf), have been analysed for their grain-size distribution using standard sieve and Sedigraph techniques. The results are in good agreement with estimates of texture made as part of the visual core description for the 1 :20 core logs for CRP-1 (Cape Roberts Science Team, 1998). Interpretation of the analyses presented here takes into account the likely setting of the site in Quaternary times as it is today, with CRP-1 high on the landward flank of a well-defined submarine ridge rising several hundred metres above basins on either side. In contrast, seismic geometries for strata deposited in early Miocene times indicate a generally planar sea floor dipping gently seaward. Fossils from these strata indicate shallow water depths (< 100 m), indicating the possibility that waves and tidal currents may have influenced sea floor sediments. The sediments analysed here are considered in terms of 3 textural facies: diamict, mud (silt and clay) and sand. Most of the Quaternary section but only 30% of the early Miocene section is diamict, a poorly sorted mixture of sand and mud with scattered clasts, indicating little wave or current influence on its texture. Although not definitive, diamict textures and other features suggest that the sediment originated as basal glacial debris but has been subsequently modified by minor winnowing, consistent with the field interpretation of this facies as ice-proximal and distal glaciomarine sediment. Sediments deposited directly from glacier ice appear to be lacking. Mud facies sediments, which comprise only 10% of the Quaternary section but a third of the early Miocene section, were deposited below wave base and largely from suspension, and show features (described elsewhere in this volume) indicative of the influence of both glacial and sediment gravity flow processes. Sand facies sediments have a considerable proportion of mud, normally more than 20%, but a well-sorted fine-very fine sand fraction. In the context of the early Miocene coastal setting we interpret these sediments as shoreface sands close to wave base.

(Table 1) Summary of maximum clast size and bed thickness of ODP Leg 126 samples

Subaerial debris flows, with water contents ranging from as little as 10 wt% up to no more than about 25 wt% (Pierson, 1986; Pierson and Costa, 1987), are non-Newtonian fluids that move as fairly coherent masses with yield strength (owing to bulk densities and viscosity that are much greater than those of clear water), which enables them to suspend and transport large clasts. Their flow behavior is thought to be predominantly laminar, although the relative importance of laminar and turbulent flow has not been established and is debatable. They leave deposits (debrites) that are characteristically poorly sorted with large clasts in their middle portions and commonly protruding from their tops. Although generally ungraded or normally graded in their upper portions, many have centimeter- to decimeter-thick inversely graded basal zones (Arguden and Rodolfo, 1990, doi:10.1130/0016-7606(1990)102<0865:SADDBH>2.3.CO;2).