Noble metal abundances in ODP Leg 115 basalts (Table 1)

A comparison of 50 basalts recovered at Sites 706, 707, 713, and 715 along the Reunion hotspot trace during Ocean Drilling Program Leg 115 in the Indian Ocean shows that seafloor alteration had little effect on noble metal concentrations (Au, Pd, Pt, Rh, Ru, and Ir), determined by inductively coupled plasma-mass spectrometry (ICP-MS), which generally tend to decrease with magma evolution. Their compatible-element behavior may be related to the precipitation of Ir-Os-based alloys, chromite, sulfides, and/or olivine and clinopyroxene in some combination. The simplest explanation indicates silicate control of concentrations during differentiation. Basalts from the different sites show varying degrees of alkalinity. Noble metal abundances tend to increase with decreasing basalt alkalinity (i.e., with increasing percentages of mantle melting), indicating that the metals behave as compatible elements during mantle melting. The retention of low-melting-point Au, Pd, and Rh in mantle sulfides, which mostly dissolve before significant proportions of Ir-Os-based alloys melt, explains increasing Pd/Ir ratios with decreasing alkalinity (increasing melting percentages) in oceanic basalts. High noble metal concentrations in Indian Ocean basalts (weighted averages of Au, Pd, Rh, Pt, Ru, and Ir in Leg 115 basalts are 3.2, 8.1, 0.31, 7.3, 0.22, and 0.11 ppb, respectively), compared with basalts from some other ocean basins, may reflect fundamental primary variations in upper- mantle noble metal abundances

Geochemistry of DSDP Hole 83-504B minerals

Leg 83 of the Deep Sea Drilling Project has deepened Hole 504B to over 1 km into basement, 1350 m below the seafloor (BSF). The hole previously extended through 274.5 m of sediment and 561.5 m of pillow basalts altered at low temperature (< 100°C), to 836 m BSF. Leg 83 drilling penetrated an additional 10 m of pillows, a 209-m transition zone, and 295 m into a sheeted dike complex. Leg 83 basalts (836-1350 m BSF) generally contain superimposed greenschist and zeolite-facies mineral parageneses. Alteration of pillows and dikes from 836 to 898 m BSF occurred under reducing conditions at low water/rock ratios, and at temperatures probably greater than 100°C. Evolution of fluid composition resulted in the formation of (1) clay minerals, followed by (2) zeolites, anhydrite, and calcite. Alteration of basalts in the transition zone and dike sections (898-1350 m BSF) occurred in three basic stages, defined by the opening of fractures and the formation of characteristic secondary minerals. (1) Chlorite, actinolite, pyrite, albite, sphene, and minor quartz formed in veins and host basalts from partially reacted seawater (Mg-bearing, locally metal-and Si-enriched) at temperatures of at least 200-250°C. (2) Quartz, epidote, and sulfides formed in veins at temperatures of up to 380°C, from more evolved (Mg-depleted, metal-, Si-, and 18O-enriched) fluids. (3) The last stage is characterized by zeolite formation: (a) analcite and stilbite formed locally, possibly at temperatures less than 200°C followed by (b) formation of laumontite, heulàndite, scolecite, calcite, and prehnite from solutions depleted in Mg and enriched in Ca and 18O, at temperatures of up to 250°C. The presence of small amounts of anhydrite locally may be due to ingress of relatively unaltered seawater into the system during Stage 3. Alteration was controlled by the permeability of the crust and is characterized by generally incomplete recrystallization and replacement reactions among secondary minerals. Secondary mineralogy in the host basalts is strongly controlled by primary mineralogy. The alteration of Leg 83 basalts can be interpreted in terms of an evolving hydrothermal system, with (a) changes in solution composition because of reaction of seawater fluids with basalts at high temperatures; (b) variations in permeability caused by several stages of sealing and reopening of cracks; and (c) a general cooling of the system, caused either by the cooling of a magma chamber beneath the spreading center and/or the movement of the crust away from the heat source. The relationship of the high-temperature alteration in the transition zone and dike sections to the low-temperature alteration in the overlying pillow section remains uncertain.

Geochemistry, isotopes, trace elements and fluid inclusion geothermometry at DSDP Hole 83-504B

Stockwork-like metal sulfide mineralizations were found at 910-928 m below seafloor (BSF) in the pillow/dike transition zone of Hole 504B. This is the same interval where most physical properties of the 5.9-m.y.-old crust of the Costa Rica Rift change from those characteristic of Layer 2B to those of Layer 2C. The pillow lavas, breccias, and veins of the stockwork-like zone were studied by transmitted and reflected light microscopy, X-ray diffraction, and electron microprobe analysis. Bulk rock oxygen isotopic analyses as well as isolated mineral oxygen and sulfur isotopic analyses and fluid inclusion measurements were carried out. A complex alteration history was reconstructed that includes three generations of fissures, each followed by precipitation of characteristic hydrothermal mineral parageneses: (1) Minor and local deposition of quartz occurred on fissure walls; adjacent wall rocks were silicified, followed by formation of chlorite and minor pyrite I in the veins, whereas albite, sphene, chlorite and chlorite-expandable clay mixtures, actinolite, and pyrite replaced igneous phases in the host rocks. The hydrothermal fluids responsible for this first stage were probably partially reacted seawater, and their temperatures were at least 200-250° C. (2) Fissures filled during the first stage were reopened and new cracks formed. They were filled with quartz, minor chlorite and chlorite-expandable clay mixtures, traces of epidote, common pyrite, sphalerite, chalcopyrite, and minor galena. During the second stage, hydrothermal fluids were relatively evolved metal- and Si-rich solutions whose temperatures ranged from 230 to 340° C. The fluctuating chemical composition and temperature of the solutions produced a complex depositional sequence of sulfides in the veins: chalcopyrite I, ± Fe-rich sphalerite, chalcopyrite II ("disease"), Fe-poor sphalerite, chalcopyrite III, galena, and pyrite II. (3) During the last stage, zeolites and Mg-poor calcite filled up the remaining spaces and newly formed cracks and replaced the host rock plagioclase. Analcite and stilbite were first to form in veins, possibly at temperatures below 200°C; analcite and earlier quartz were replaced by laumontite at 250°C, whereas calcite formation temperature ranged from 135 to 220°C. The last stage hydrothermal fluids were depleted in Mg and enriched in Ca and 18O compared to seawater and contained a mantle carbon component. This complex alteration history paralleling a complex mineral paragenesis can be interpreted as the result of a relatively long-term evolution of a hydrothermal system with superimposed shorter term fluctuations in solution temperature and composition. Hydrothermal activity probably began close to the axis of the Costa Rica Rift with the overall cooling of the system and multiple fracturing stages due to movement of the crust away from the axis and/or cooling of a magmatic heat source.

Composition of bottom sediments and their exchange with seawater in the Amur and Zolotoy Rog bays, Sea of Japan

Transition of Zn, Cu, Cd, and Pb into solution is studied for experimental suspensions of coastal marine sediments with different degrees of pollution from the Amur Bay (Sea of Japan) over 30-70 days. Concentrations of dissolved metals were measured by a voltammetry method. Transition of Zn and Cd into solution was shown to be linearly dependent on initial pollution of sediments with these metals. Cadmium mobilization is due to gradual degradation of organic matter from sediments. Under degradation processes Zn quickly goes into solution during sedimentation and from silts, while in case of polluted sediments it is slowly mobilized during oxidation of sulfides. Behavior of Cu is complex because of binding of mobilized metal by dissolved organic compounds. Transition of lead into solution is negligible. Calculation of potential transition of metals from sediments into water on the basis of experimental data and its comparison with downward sedimentary flux showed that in the studied area secondary pollution of water by aerobic degradation of sediments is possible only for Cd.

Noble metals and associated trace elements in sulfides from the active TAG mound, ODP Site 158-957

Primary sulfides from cores of ODP Holes 158-957M, 158-957C, and 158-957H on the active TAG hydrothermal mound (Mid-Atlantic Ridge, 26°08'N) have been studied for concentrations of several chemical elements. Based on 262 microprobe analyses it has been found that the sulfides have extremely heterogeneous distribution of noble metals (Au, Ag, Pt, and Pd) and several associated elements (Hg, Co, and Se). Noble metals are arranged in the following order in terms of decreasing abundance, i.e. concentration level above detection limits (the number of analyses containing a specific element is given in parentheses): Au (65), Ag (46), Pt (21), and Pd (traces). The associated trace elements have the following series: Co (202), Hg (132), and Se (49). The main carriers of "invisible" portion of the noble metals are represented by pyrite (Au, Hg), marcasite and pyrite (Ag, Co), sphalerite and chalcopyrite (Pt, Pd), and chalcopyrite (Se). Noble metal distribution in sulfides reveals a lateral zonality: maximal concentrations and abundance of Au in chalcopyrite (or Pt and Ag in chalcopyrite and pyrite) increase from the periphery (Hole 957H) to the center (holes 957C and 957M) of the hydrothermal mound, while Au distribution in pyrite displays a reversed pattern. Co concentration increases with depth. Vertical zonality in distribution of the elements mentioned above and their response to evolution of ore genesis are under discussion in the paper.

Description, geochemistry, mineralogy and isotopes of sulfides from ODP Site 193-1189, PACMANUS field

Chemical and isotopic data for rare massive and semimassive sulfide samples cored at Site 1189 (Roman Ruins, PACMANUS) suggest their genetic relationship with sulfide chimneys at the seafloor. Sand collected from the hammer drill after commencement of Hole 1189B indicates that at least the lower section of the cased interval was occupied by material similar to the stockwork zone cored from 31 to ~100 meters below seafloor (mbsf) in this hole, but with increased content of barite, sphalerite, and lead-bearing minerals. Fractional crystallization of ascending hydrothermal fluid involving early precipitation of pyrite may explain vertical mineralogical and chemical zoning within the stockwork conduit and the high base and precious metal contents of Roman Ruins chimneys. A mineralized volcaniclastic unit cored deep in Hole 1189A possibly represents the lateral fringe of the conduit system. Lead isotope ratios in the sulfides differ slightly but significantly from those of fresh lavas from Pual Ridge, implying that at least some of the Pb within the Roman Ruins hydrothermal system derived from a deeper, more radiogenic source than the enclosing altered volcanic rocks.

(Table 2) Trace metal concentrations in ODP Hole 169-1033B

We measured the concentrations of redox-sensitive trace metals (Mn, V, Mo, U, Cd and Re) in sediments from ODP Leg 169S Hole 1033B in Saanich Inlet, British Columbia, to determine changes in redox conditions associated with the onset of laminated sediments at ~12.5 kyr. The most striking result is a large peak in authigenic Re along with detrital levels of Mo at the glacial terrigenous clay-diatomaceous sediment transition. In contrast, the underlying glacial terrigenous clay, which extends throughout the bottom section of the core, is chemically similar to detrital concentrations, either Cowichan River particulates or average shale values. These data suggest a period of oxic bottom waters but reducing pore-waters. This could be due to the dramatic transformation of Saanich Inlet during the late deglaciation from an open bay to an inlet, which restricted circulation and slowed bottom water oxygen renewal. A peak and gradual increase in authigenic Mn in younger sediments subsequent to the Re peak suggests that increasingly oxic conditions followed the authigenic enrichment in Re. These conditions could be connected to the Younger Dryas cooling period, which was coincident with an increase in well oxygenated upwelled waters on the west coast of North America that form the bottom waters of Saanich Inlet. Metal concentrations in a gray clay bed (~11 kyr) are similar to their concentrations in the glacial terrigenous clay, implying that they have a common source. Authigenic enrichments of Re with little authigenic Mo and Cd suggest that before the deposition of this bed, bottom waters were oxic and pore-water oxygen was consumed in the top centimeter or less. Laminations above the clay layer suggest anoxic conditions, which are also indicated by higher authigenic Mo and Cd and slightly lower Re/Mo ratios in these sediments. The basin remained mostly anoxic after the gray clay was emplaced, as seen by continuous authigenic enrichment of the redox-sensitive trace metals. These results are consistent with increased stratification of the water column, brought about by an influx of fresh water to the basin by a large flood.

Total organic carbon, metal concentrations and metal and aluminium ratios in bulk sediment from the ODP sample 169-1033B-4H-4,54-74

Holocene laminated sediments in Saanich Inlet, British Columbia, are interrupted by frequent, non-laminated, massive layers. These layers may be debris flows released by earthquakes or bioturbated sediments deposited during periods of relatively high bottom water oxygen concentration and/or low surface productivity, or both. We determined the organic carbon content and the concentration of a suite of redox-sensitive metals in bulk sediments at approximately 1-cm resolution across a laminated-massive-laminated interval (ODP Leg 169S Sample 1033B-4H-4,54-74), to determine the redox conditions under which the massive layer was deposited. Our results indicate that this massive interval was deposited under anoxic bottom waters. Manganese/Al ratios are consistently low throughout the massive section, while Mo/Al, Cd/Al, Re/Al, and U/Al ratios are enriched relative to their metal/Al ratios in detrital material (represented by Cowichan River suspended sediments). The concentration of organic carbon in the lower portion of the massive layer is higher than in the upper portion, which has a concentration similar to that in the overlying and underlying laminated sediments. Well-defined peaks in Mo/Al, Cd/Al, and Re/Al and a broad peak in U/Al occur in the lower portion of the massive layer. The positions of the Cd/Al, Re/Al, and Mo/Al peaks, as well as the increase in organic carbon content with depth in the massive layer, are best explained by a process of diagenetic redistribution of metals that occurred after the massive layer was emplaced.