Fig. S1. Loci of possible event locations based on differential ts - tp arrival times at the single functioning geophone

Geological storage of CO2 that has been captured at large, point source emitters represents a key potential method for reduction of anthropogenic greenhouse gas emissions. However, this technology will only be viable if it can be guaranteed that injected CO2 will remain trapped in the subsurface for thousands of years or more. A signi?cant issue for storage security is the geomechanical response of the reservoir. Concerns have been raised that geomechanical deformation induced by CO2 injection will create or reactivate fracture networks in the sealing caprocks, providing a pathway for CO2 leakage. In this paper, we examine three large-scale sites where CO2 is injected at rates of ab. 1 megatonne/y or more: Sleipner, Weyburn, and In Salah. We compare and contrast the observed geomechanical behavior of each site, with particular focus on the risks to storage security posed by geomechanical deformation. At Sleipner, the large, high-permeability storage aquifer has experienced little pore pressure increase over 15 y of injection, implying little possibility of geomechanical deformation. At Weyburn, 45 y of oil production has depleted pore pressures before increases associated with CO2 injection. The long history of the ?eld has led to complicated, sometimes nonintuitive geomechanical deformation. At In Salah, injection into the water leg of a gas reservoir has increased pore pressures, leading to uplift and substantial microseismic activity. The differences in the geomechanical responses of these sites emphasize the need for systematic geomechanical appraisal before injection in any potential storage site.

Locations of geochemical samples and tephra from ODP Site 181-1123

Approximately one thousand sediment samples from ODP Site 1123 on the Chatham Rise, east of New Zealand, have been examined for inorganic elemental concentrations. ODP 1123 provides a record of sediment drift deposition under the Deep Western Boundary Current, the main inflow of deep water to the Pacific Ocean since the Early Oligocene, though a major hiatus spans the late Early Oligocene to the Early Miocene. Normalisation of the elemental concentrations by aluminium was used to allow for the effects of variable carbonate dilution. The elemental ratios were used as proxies for sediment composition and as palaeoceanographic indices. The samples were collected at a resolution designed to sample adequately any variation in elemental ratios at the scale of the Milankovitch orbital cycles. The sampled intervals span the Early Oligocene, Early Miocene, mid-Miocene and Late Pleistocene to Recent. Anomalous Si/Al, K/Al, Ti/Al values in the upper Pleistocene section, often associated with horizons of low carbonate, are attributed to tephras derived from North Island. Not all of the tephras detected geochemically had been detected visually in the cores. A total of 37 tephra events between 1.17 Ma BP and the present are recognised based on this and the shipboard investigations. The tephra events cluster at intervals of approximately 326 000 years (326 ka) perhaps due to variations in eruption frequency on North Island and/or to variations in the regional palaeowind intensity and direction. In the Late Pleistocene to Recent P/Al (inferred nutrient availability), percent calcium carbonate (%CaCO3) and Ba/Al (inferred productivity) varied regularly at a period of 40 000 years with these factors lagging minimum global ice volumes (interglacials). During the mid-Miocene CaCO3, Ba/Al, P/Al and Si/Al all gradually increased with %CaCO3 and P/Al showing regular 138 000-yr cyclicity and Ba/Al showing 44-ka cyclicity. Inferred productivity (Ba/Al) may have been rising in association with increasing nutrient availability (P/Al) at the same time as increased vigour of the Deep Western Boundary Current that was connected to a period of rapid ice-sheet growth in Antarctica. In the Early Miocene P/Al and Si/Al were much higher than subsequently and both %CaCO3 and P/Al exhibited 131 000-yr cycles. By far the highest nutrient levels and inferred productivity at this site apparently occurred during the Early Oligocene as revealed by long-term changes in P/Al and Si/Al. A progressive rise in K/Al, but stable Ti/Al from the Early Oligocene to the Recent probably indicates increased proportions of illite in the clay mineral fraction of the drift sediments caused by increased flux of debris from the Southern Alps.

Sequential variation of carbonate cycles in South Atlantic DSDP locations

We report well-dated Late Cretaceous and Early Tertiary precessional climatic cycles, recorded by rhythmic carbonate maxima and minima in South Atlantic deep sea sites. Spectral analyses of digitized sediment color, a suitable carbonate proxy, show prominent regularities in the spacing marl-carbonate beds. Magnetostratigraphic dating over a number of magnetic chrons constrains the duration of the cycles, which can be detected over at least 20 Myr of sedimentation at 7 coring locations. Their mean absolute period of 23.5 +/- 4.4kyr agrees closely with the predicted late Cretaceous precessional period of 20.8 kyr. Because they can be matched to a physical forcing mechanism with a known repeat time, the cycles offer a new high-resolution tool to measure rates of climate change before and after the Cretaceous-Tertiary (K/T) boundary. From counts of carbonate cycles, we derive the position of the K/T boundary within C29R at 350 kyr after the base of the reversal. The constancy of cycle thickness (linearly related to sedimentation rate) and amplitude up to the "boundary clay" does not give evidence for climate instability preceding the boundary. Orbital chronometry records a step-function decrease in sediment accumulation rate at the Cretaceous-Tertiary boundary that is consistent with a geologically instantaneous event.

Monthly and yearly mean air temperature from 1829 to 2005 calculated from meteorological observations at different locations in Bremen, northern Germany

The secular record of annual mean temperatures of Bremen shows that inhomogeneities - especially caused by station transfers - lead to serious problems concerning the interpretation of climatic trends or fluctuations. Especially two transfers of the meteorological observing station in Bremen within our century - 1935/36 and 1978 - caused significant inhomogeneities, well documented by parallel measurements for several years. Obviously the stagnation of the temperature level of the original data set is a result of these transfers. The homogenized record version reveals a significant warming trend of about 1 Kelvin within the last century.