Messinian and pre-Messinian sediments of ODP Holes 107-652A and 107-654A

Sedimentology, mineralogy, and petrology of the pre-Pliocene sediments drilled at ODP Sites 652 and 654 in the Tyrrhenian Sea (Leg 107) have been studied with emphasis on the lower Messinian to pre-Messinian intervals. Messinian at Site 652 is essentially turbiditic and basinal in character; it was deposited during the syn-rift phase in a strongly subsiding half-graben and is correlatable with emerged coeval sequences; in part with the Laga Formation of the foredeep of Apennines, and in part with the filling of grabens dissecting that chain in the Tyrrhenian portion of Tuscany. The sequence found in Site 654 indicates an upper Tortonian to Messinian transgression accompanying crustal stretching in the western Tyrrhenian Sea and is perfectly correlatable with the so-called "Sahelian cycle" and with "postorogenic" cycles recognized in peninsular Italy and in Sicily.

Sulfide petrology of basalts at DSDP Holes 69-504B and 69-505B

Primary sulfide mineralization in basalts of the Costa Rica Rift occurs mainly in chrome-spinel-bearing olivine tholeiites. Primary sulfides form both globules, consisting of quenched single-phase solid solutions, and irregular polymineralic segregations of pyrrhotite, chalcopyrite, cubanite, and pentlandite. Two types of sulfide solid solutions - iron-nickel (Mss) and iron-copper (Iss) - were found among sulfide globules. These types appear to have formed because of sulfide-sulfide liquid immiscibility in the host magmas; as proved by the presence of globules with a distinct phase boundary between Mss and Iss. Such two-phase globules are associated with large olivine phenocrysts. Inhomogeneties among the globule composition likewise are caused by sulfide-sulfide immiscibility. Secondary sulfides form irregular segregations and veins consisting of pyrite, marcasite, and chalcopyrite.

Composition and age of volcanic rocks from the Sinii Utes Depression, Southern Primoye

New data are reported on structure of sections, chemical composition, and age of volcano-sedimentary and volcanic rocks from the Sinii Utes Depression in the Southern Primorye region. The Sinii Utes Depression is filled with two sequences: the lower sequence composed of sedimentary-volcanogenic coaliferous rocks (the stratotype of the Sinii Utes Formation) and the upper sequence consisting of tephroid with overlying basalts. This work considers chemical composition and problems of K-Ar dating of basalts. The uppermost basaltic flow has K-Ar age 22.0±1.0 Ma. The dates obtained for the middle and upper parts of lava flows are underestimated. It is explained by their heating due to combustion of brown coals of the Sinii Utes Formation underlying the lava flow. Calculations show that argon could only partly have been removed from the basalts owing to conductive heat transfer and was lost largely due to infiltration of hot gases in heterogeneous fissured medium. Basaltic volcanism on continental margins of the southern Primorye region and the adjacent Korean and Chinese areas at the Oligocene-Miocene boundary preceded Early-Middle Miocene spreading and formation of the Sea of Japan basin. Undifferentiated moderately alkaline basalts of intraplate affinity developed in the Amba Depression and some other structures of the southern Primorye region and intraplate alkali basalts of the Phohang Graben in the Korean Peninsula serve as indicators of incipient spreading regime in the Sea of Japan. Potassic basalt-trachybasalt eruptions occurred locally in riftogenic depressions and shield volcanoes. In some structures this volcanism was terminated by eruptions of intermediate and acid lavas. Such evolution of volcanism is explained by selective contamination of basaltic melts during their interaction with crustal acid material and generation of acid anatectic melts.

Composition of sediment pore water and isotopes in carbonate and benthic foraminifera at DSDP Holes 68-501, 69-505 and Site 69-504

Two sites on the southern flank of the Costa Rica Rift were drilled on DSDP Legs 68 and 69, one on crust 3.9 m.y. old and the other on crust 5.9 m.y. old. The basement of the younger site is effectively cooled by the circulation of seawater. The basement of the older site has been sealed by sediment, and an interval in the uppermost 560 meters of basement recently reheated to temperatures of 60 to 120°C. Although the thickness of the sediments at the two sites is similar (150-240 m versus 270 m), the much rougher basement topography at the younger Site 505 produces occasional basement outcrops, through which 80 to 90% of the total heat loss apparently occurs by advection of warm seawater. This seawater has been heated only slightly, however; the temperature at the base of the sediments is only 9°C. Changes in its composition due to reaction with the basement basalts are negligible, as indicated by profiles of sediment pore water chemistry. Bacterial sulfate reduction in the sediments produces a decrease in SO4 (and Ca) and an increase in alkalinity (and Sr and NH3) as depth increases to an intermediate level, but at deeper levels these trends reverse, and all of these species plus Mg, K, Na, and chlorinity approach seawater values near basement. Si, however, is higher, and Li may be lower. At the older site, Site 501/504, where heat loss is entirely by conduction, the temperature at the sediment/basement contact is 59°C. Sediment pore water chemistry is heavily affected by reaction with the basaltic basement, as indicated by large decreases in d18O, Mg, alkalinity, Na, and K and an increase in Ca with increasing depth. The size of the changes in d18O, Mg, alkalinity, Ca, Sr, and SO4 varies laterally over 500 meters, indicating lateral gradients in pore water chemistry that are nearly as large as the vertical gradients. The lateral gradients are believed to result from similar lateral gradients in the composition of the basement formation water, which propagate upward through the sediments by diffusion. A model of the d18O profile suggests that the basement at Site 501/504 was sealed off from advection about 1 m.y. ago, so that reaction rates began to dominate the basement pore water chemistry. A limestone-chert diagenetic front began to move upward through the lower sediments less than 200,000 yr. ago.

(Table 1) Physical properties of basalts from DSDP Legs 69 and 70

Physical properties of basalts from Deep Sea Drilling Project Sites 504 and 505, south of the Costa Rica Rift, including wet-bulk density, water content, sonic velocity, and thermal conductivity, were measured on board D/V Glomar Challenger during Legs 69 and 70. The mean wet-bulk density is 2.90±0.06 g/cm**3, porosity 5.0±2.2%, sonic velocity 5.75±0.30 km/s, and thermal conductivity 1.67±0.09 W/m°K. Basalts from this young ocean crust (5.9 m.y.) have relatively low porosity and consequently high density and sonic velocity, as compared to average DSDP basalts. Some systematic trends in depth variation of physical properties were found: down to Core 40 in Hole 504B, grain densities were lower than those deeper in the hole, whereas porosity in the upper section was higher. This can be attributed either to differences in the flow type or in the nature of alteration of basalts at the different levels in the hole.

(Table 1) Geochemistry of ODP Hole 130-807C carbonates across the K/T boundary

Paleontological, stable isotopic, trace elemental abundance, and magnetostratigraphic studies have been performed on limestones spanning the Cretaceous/Tertiary boundary transition at Ocean Drilling Program (ODP) Hole 807C. Paleontological evidence exists for considerable resedimentation, which we attribute to the fact that Hole 807C is located in a basement graben. Age estimates based on planktonic foraminiferal biostratigraphy, as well as magnetostratigraphy, indicate that sedimentation rates could have been on the order of 12-14 m/m.y. This is significantly higher than those documented in other important Deep Sea Drilling Project (DSDP) and ODP Cretaceous/Tertiary boundary sections using the same age control points (e.g., DSDP Hole 577 and ODP Hole 690B), although not as high as those documented from DSDP Hole 524. The expanded nature of this succession has resulted in the Cretaceous/Tertiary boundary d13C decrease occurring over approximately a 9-m interval. Ir analysis of these sediments do not show a single large anomaly, as has been found in other Cretaceous/Tertiary boundary sections, but trivial background levels instead. Ce data support the hypothesis that this section has been expanded by secondary sedimentological processes.

Mineral and chemical composititon of sediments from ODP Hole 119-740A

ODP Hole 740A is located on the inner part of the East Antarctic continental shelf in Prydz Bay, at the seaward end of a major onshore rift structure known as the Lambert Graben. Drilling at this site led to the recovery of some 65 m of continental sediments (Prydz Bay red beds) that form part of a much thicker (2-3 km) pre-continental breakup sequence, the development of which may be related to the initiation and rifting of the Lambert Graben. Palynological and paleomagnetic studies have not been able to determine the age of the sediments; they may be equivalent to the onshore late Permian Amery Group or younger. The succession consists predominantly of sandstone, siltstone, and claystone arranged in erosively based, pedogenically influenced fining-upward sequences up to 5 m thick. These were deposited by shallow, braided streams draining an extensively vegetated alluvial plain, with sufficient topographic relief to trap fine-grained sediment and inhibit rapid channel shifting. Pedogenic processes were initiated on the alluvial plain, but climatic conditions were generally unsuitable for extensive pedogenic carbonate formation and the development of mature soil profiles. The sediments were probably derived from a rapidly uplifted fault block terrain composed of upper Proterozoic and Archaean gneisses lying to the southeast of the depositional site. Uplift may have taken place along the tectonically active seaward extension of the eastern faulted margin of the Lambert Graben, which passes immediately southeast of Hole 740A. Differences in mineralogical composition between the Amery Group and the Prydz Bay red beds probably reflect differences in rock composition in the source area. The age of the Prydz Bay red beds has still to be resolved.

(Table 1) Compressional-wave and shear-wave velocities and elastic constants from DSDP Legs 69 and 70

Shear-wave and compressional-wave velocities of 26 basalt samples collected at Site 504 during Deep Sea Drilling Project Legs 69 and 70 were measured at elevated confining pressures. The young basalts have higher velocities than average DSDP basalts, because of their lack of alteration. Measurements of sample porosity are combined with laboratory and in situ velocity measurements to yield estimates of total crustal porosity: 13% at the top of Layer 2, and very low porosity below a depth of 2.0 km.

Composition of surface layer bottom sediments from the Chukchi Sea

Abundance of noble metals and bulk chemical composition have been studied in bottom sediments of the Chukchi Sea. Distribution of noble metals and their correlation with major and trace elements in the sediments have been analyzed using multicomponent statistics. It was established that average contents of noble metals in the bottom sediments of the Chukchi Sea significantly exceed those both in shelf terrigenous sediments and stratisphere. Osmium and iridium enrich mixed and pelitic sediments relative to shallow-water sediments and their influx is presumably determined by erosion of coastal and bottom unconsolidated deposits. High Ag, Ru, Au, and Pt contents were identified in clayey sediments enriched in biogenic elements in the some areas of the Southern Chukchi plain (Chukchi Sea) confined to intersection zones of submeridional and sublatitudinal structures of the graben-rift system, which formed in Mesozoic and activated in Late Cenozoic.

Chemical composition of surficial bottom sediments from the Chukchi Sea and adjacent part of the Arctic Ocean

This paper presents data on chemical composition of bottom sediments from the Chukchi Sea and the adjacent Arctic Ocean. Multivariate statistical techniques were used for analysis of the data set and revealed that grain size fractionation of the original terrigenous component during sedimentation was the major factor of clustering of the samples in study. Secondary factors include accumulation of biogenic siliceous and carbonate material and chemogenic or biochemical accumulation of iron, manganese, and some trace elements. The latter factor was significant in areas of tectonic activity within the graben-rift system of the Chukchi Sea.