Dinoflagellates of multicorer surface sediments

Only very few studies focus on recent calcareous dinoflagellate cyst diversity, geographic distribution and ecology, so that information on the distribution patterns and environmental affinities of individual cyst species is extremely limited. This information is, however, essential if we want to use calcareous dinoflagellate cysts for palaeoenvironmental reconstruction. Surface sediment samples from the generally oligotrophic western equatorial Atlantic Ocean, offshore northeast Brazil, were therefore quantitatively analysed for their calcareous dinoflagellate cyst content, including the calcareous vegetative coccoid Thoracosphaera heimii. Seven calcareous dinoflagellate cyst species/morphotypes and T. heimii were encountered in high concentrations throughout the area. Substantial differences in the distribution patterns were observed. The highest concentrations of cysts are found in sediments of the more oligotrophic, oceanic regions, beyond the influence of Amazon River discharge waters. Dinoflagellates producing calcareous cysts thus appear to be capable of surviving low nutrient concentrations and produce large numbers of cysts in relatively stable and predictable environments affected by minimal seasonality. To test for the environmental affinities of individual species, distribution patterns in surface sediments were compared with temperature, salinity, density and stratification gradients within the upper water column (0-100 m) over different times of the year, using principal components analysis and redundancy analysis. T. heimii and four of the seven encountered cyst species (Sphaerodinella? albatrosiana, two morphotypes of Sphaerodinella? tuberosa and Scrippsiella regalis) relate to these parameters significantly and the variations in the cyst associations appear to be associated with the different surface water currents characterising the area. The results imply that calcareous dinoflagellate cyst distributions can potentially be used to distinguish between different open oceanic environments and they could, therefore, be useful in tracing water mass movements throughout the late Quaternary.

Sulfate and methane concentrations measured in pore water of sediment core GeoB13809-1 and GeoB13849-1

Several previous studies have shown that submarine mass-movements can profoundly impact the shape of pore water profiles. Therefore, pore water geochemistry and diffusion models were proposed as tools for identifying and dating recent (max. several thousands of years old) mass-transport deposits (MTDs). In particular, sulfate profiles evidentially indicate transient pore water conditions generated by submarine landslides. After mass-movements that result in the deposition of sediment packages with distinct pore water signatures, the sulfate profiles can be kink-shaped and evolve into the concave and linear shape with time due to molecular diffusion. Here we present data from the RV METEOR cruise M78/3 along the continental margin off Uruguay and Argentina. Sulfate profiles of 15 gravity cores are compared with the respective acoustic facies recorded by a sediment echosounder system. Our results show that in this very dynamic depositional setting, non-steady state profiles occur often, but are not exclusively associated with mass-movements. Three sites that show acoustic indications for recent MTDs are presented in detail. Where recent MTDs are identified, a geochemical transport/reaction model is used to estimate the time that has elapsed since the perturbation of the pore water system and, thus, the timing of the MTD emplacement. We conclude that geochemical analyses are a powerful complementary tool in the identification of recent MTDs and provide a simple and accurate way of dating such deposits.

(Table 1) Experimental details and results

Factor-of-safety analyses of submarine slope failure depend critically on the shear strength of the slope material, which is often evaluated with residual strength values and for normally consolidated sediments. Here, we report on direct measurements of both shear strength and cohesion for a quartz-clay mixture over a wide range of overconsolidation ratios (OCRs). For normally consolidated sediment at low stresses, cohesion is the dominant source of shear strength compared to friction. Significant increases in peak shear strength occur for OCR > 4, and the primary source of this strength increase is due to increased cohesion, rather than friction. The proportion of added shear strength due to cohesion depends log-linearly on the OCR. We show that at shallow depths where OCR values can be high, overconsolidated clays can be stronger than pure or nearly pure quartz sediments, which are cohesionless under near-surface conditions. Our data also suggest that areas which have experienced significant unroofing due to previous mass movements are less likely to experience subsequent failure at shallow depths due to increased peak strength, and if failure occurs it is expected to be deeper where the OCR is lower. In seismically active areas, this is one potential explanation for the general observation of lower slope failure recurrence compared to rates expected from triggering due to local earthquakes.

Ground ice hydrochemical composition of permafrost core ICDP5011-3

The continuous sediment record from Lake El'gygytgyn in the northeastern Eurasian Arctic spans the last 3.6 Ma and for much of this time permafrost dynamics and lake level changes have likely played a crucial role for sediment delivery to the lake. Changes in the ground-ice hydrochemical composition (d18O, dD, pH, electrical conductivity, Na+, Mg2+, Ca2+, K+, HCO3-, Cl-, SO4-) of a 141 m long permafrost record from the western crater plain are examined to reconstruct repeated periods of freeze and thaw at the lake edge. Stable water isotope and major ion records of ground ice in the permafrost reflect both a synsedimentary palaeo-precipitation signal preserved in the near-surface permafrost (0.0-9.1 m core depth) and a post-depositional record of thawing and refreezing in deeper layers of the core (9.1-141.0 m core depth). These lake marginal permafrost dynamics were controlled by lake level changes that episodically flooded the surfaces and induced thaw in the underlying frozen ground. During times of lake level fall these layers froze over again. At least three cycles of freeze and thaw are identified and the hydrochemical data point to a vertical and horizontal talik refreezing through time. Past permafrost thaw and freeze may have destabilised the basin slopes of Lake El'gygytgyn and this has probably promoted the release of mass movements from the lake edge to the deeper basin as known from frequently occurring turbidite layers in the lake sediment column.

Photographs of the Mount Meager, southwestern British Columbia

On August 6, 2010, a large (~50 Mm**3) debris avalanche occurred on the flank of Mount Meager in the southern Coast Mountains of British Columbia, Canada. We studied the deposits to infer the morphodynamics of the landslide from initiation to emplacement. Structure from motion (SfM) photogrammetry, based on oblique photos taken with a standard SLR camera during a low helicopter traverse, was used to create high-resolution orthophotos and base maps. Interpretation of the images and maps allowed us to recognize two main rheological phases in the debris avalanche. Just below the source area, in the valley of Capricorn Creek, the landslide separated into two phases, one water-rich and more mobile, and the other water-poor and less mobile. The water-rich phase spread quickly, achieved high superelevation on the valley sides, and left distal scattered deposits. The main water-poor phase moved more slowly, did not superelevate, and formed a thick continuous deposit (up to ~30 m) on the valley floor. The water-poor flow deposit has structural features such as hummocks, brittle-ductile faults, and shear zones. Our study, based on a freshly emplaced deposit, advances understanding of large mass movements by showing that a single landslide can develop multiple rheology phases with different behaviours. Rheological evolution and separation of phases should always be taken into account to provide better risk assessment scenarios.