Carbonate cements and fluid circulation of ODP Leg 116 samples

The carbonate cements found in Sites 717-719 of ODP Leg 116 correspond to the precipitation of inorganic calcite due to circulation of hot fluid associated with intraplate deformation in the central Indian Ocean. A first burst of hydrothermal activity may have occurred 7.5-9 Ma and a second burst less than 0.5 Ma. These fluids were probably derived from the basaltic basement and the immediately overlying sediments.

Analysis of spatial microbial properties from experimental plots of the Jena experiment (September 2010)

The study was carried out on the main plots (Main Experiment) of a large grassland biodiversity experiment, the Jena Experiment. In the main experiment, 82 grassland plots of 20 x 20 m were established from a pool of 60 species belonging to four functional groups (grasses, legumes, tall and small herbs). In May 2002, varying numbers of plant species from this species pool were sown into the plots to create a gradient of plant species richness (1, 2, 4, 8, 16 and 60 species) and functional richness (1, 2, 3, 4 functional groups). Plots were maintained by bi-annual weeding and mowing. This data set consists of standard deviation (SD), mean and stability (stab) of soil microbial basal respiration (µl O2/h/g dry soil) and microbial biomass carbon (µg C/g dry soil). Data were derived by taking soil samples and measuring basal and substrate-induced microbial respiration with an oxygen-consumption apparatus. Samples for calculating the spatial stability of soil microbial properties were taken on the 20th of September in 2010. Oxygen consumption of soil microorganisms in fresh soil equivalent to 3.5 g dry weight was measured at 22°C over a period of 24 h. Basal respiration (µlO2/g dry soil/h) was calculated as mean of the oxygen consumption rates of hours 14 to 24 after the start of measurements. Substrate- induced respiration was determined by adding D-glucose to saturate catabolic enzymes of microorganisms according to preliminary studies (4 mg g-1 dry soil solved in 400 µl deionized water). Maximum initial respiratory response (µl O2/g dry soil/ h) was calculated as mean of the lowest three oxygen consumption values within the first 10 h after glucose addition. Microbial biomass carbon (µg C/g dry soil) was calculated as 38 × Maximum initial respiratory response according to prelimiray studies.

Analysis of temporal microbial properties from experimental plots of the Jena experiment (2003-2014)

The study was carried out on the main plots (Main Experiment) of a large grassland biodiversity experiment, the Jena Experiment. In the main experiment, 82 grassland plots of 20 x 20 m were established from a pool of 60 species belonging to four functional groups (grasses, legumes, tall and small herbs). In May 2002, varying numbers of plant species from this species pool were sown into the plots to create a gradient of plant species richness (1, 2, 4, 8, 16 and 60 species) and functional richness (1, 2, 3, 4 functional groups). Plots were maintained by bi-annual weeding and mowing. This data set consists of standard deviation (SD), mean and stability (stab) of soil microbial basal respiration (µl O2/h/g dry soil) and microbial biomass carbon (µg C/g dry soil). Data were derived by taking soil samples and measuring basal and substrate-induced microbial respiration with an oxygen-consumption apparatus. Samples for calculating the temporal stability were taken every year in May/June from 2003 to 2014, except in 2005. Oxygen consumption of soil microorganisms in fresh soil equivalent to 3.5 g dry weight was measured at 22°C over a period of 24 h. Basal respiration (µlO2/g dry soil/h) was calculated as mean of the oxygen consumption rates of hours 14 to 24 after the start of measurements. Substrate- induced respiration was determined by adding D-glucose to saturate catabolic enzymes of microorganisms according to preliminary studies (4 mg g-1 dry soil solved in 400 µl deionized water). Maximum initial respiratory response (µl O2/g dry soil/h) was calculated as mean of the lowest three oxygen consumption values within the first 10 h after glucose addition. Microbial biomass carbon (µg C/g dry soil) was calculated as 38 × Maximum initial respiratory response according to prelimiray studies.

(Table 1) Summary of basalt unit thickness, vesicularity, number of flow units, and average porosity at ODP Site 135-839

An inflatable drill-string packer was used at Site 839 to measure the bulk in-situ permeability within basalts cored in Hole 839B. The packer was inflated at two depths, 398.2 and 326.9 mbsf; all on-board information indicated that the packer mechanically closed off the borehole, although apparently the packer hydraulically sealed the borehole only at 398.2 mbsf. Two pulse tests were run at each depth, two constant-rate injection tests were run at the first set, and four were run at the second. Of these, only the constant-rate injection tests at the first set yielded a permeability, calculated as ranging from 1 to 5 * 10**-12 m**2. Pulse tests and constant-rate injection tests for the second set did not yield valid data. The measured permeability is an upper limit; if the packer leaked during the experiments, the basalt would be less permeable. In comparison, permeabilities measured at other Deep Sea Drilling Project and Ocean Drilling Program sites in pillow basalts and flows similar to those measured in Hole 839B are mainly about 10**-13 to 10**-14 m**2. Thus, if our results are valid, the basalts at Site 839 are more permeable than ocean-floor basalts investigated elsewhere. Based on other supporting evidence, we consider these results to be a valid measure of the permeability of the basalts. Temperature data and the geochemical and geotechnical properties of the drilled sediments all indicate that the site is strongly affected by fluid flow. The heat flow is very much less than expected in young oceanic basalts, probably a result of rapid fluid circulation through the crust. The geochemistry of pore fluids is similar to that of seawater, indicating seawater flow through the sediments, and sediments are uniformly underconsolidated for their burial depth, again indicating probable fluid flow. The basalts are highly vesicular. However, the vesicularity can only account for part of the average porosity measured on the neutron porosity well log; the remainder of the measured porosity is likely present as voids and fractures within and between thin-bedded basalts. Core samples, together with porosity, density, and resistivity well-log data show locations where the basalt section is thin bedded and probably has from 15% to 35% void and fracture porosity. Thus, the measured permeability seems reasonable with respect to the high measured porosity. Much of the fluid flow at Site 839 could be directed through highly porous and permeable zones within and between the basalt flows and in the sediment layer just above the basalt. Thus, the permeability measurements give an indication of where and how fluid flow may occur within the oceanic crust of the Lau Basin.

Concentrations and isotopic compositions of low molecular weight hydrocarbons in hydrothermal fluids from ODP Field, Middle Valley, northern Juan de Fuca Ridge

The presence of sedimentary organic matter blanketing midocean ridge crests has a potentially strong impact on metal transport in hydrothermal vent fluids. To constrain the role of organic matter in metal mobility during hydrothermal sediment alteration, we reacted organic-rich diatomaceous ooze from Guaymas Basin, Gulf of California, and organic-poor hemipelagic mud from Middle Valley, northern Juan de Fuca Ridge, with seawater and a Na-Ca-K-Cl fluid of seawater chlorinity, at 275° to 400°C, 350 to 500 bars, and initial fluid: sediment mass ratios ranging from 1.6 to 9.8. Reaction of these fluids with both sediment types released CO2 and high concentrations of ore-forming metals (Fe, Mn, Zn, Pb) to solution. Relatively low concentrations of Cu were observed in solution and likely reflect the reducing conditions that resulted from the presence of sedimentary organic matter. Both the concentrations of CO2 and dissolved metals were lower in fluids reacted with Middle Valley sediment compared with aqueous concentrations in fluids reacted with Guaymas Basin sediment. During alteration of both sediment types, metal concentrations varied strongly as a function of temperature, increasing by up to an order of magnitude over the 75°C range of each experiment. Major element fluid chemistry and observed alteration assemblages suggest that during hydrothermal alteration of organic-lean sediment from Middle Valley a feldspar-quartz-illite mineral assemblage buffered in situ pH. In contrast, data from the experimental alteration of organic-rich Guaymas Basin sediment suggest that a calcite-plagioclase-quartz assemblage regulated in situ pH. Fluid speciation calculations suggest that in situ pH during Guaymas Basin sediment alteration was lower than during alteration of Middle Valley sediment and accounts for the substantially greater metal mobility at a given temperature and pressure during the former experiment. Comparison of our results with the results of basalt alteration experiments indicate that except for Cu, hydrothermal sediment alteration results in equal or greater concentrations of ore-forming metals at a given temperature and pressure. Accordingly, the presence of ore-forming metals in fluids currently venting from sediment-covered hydrothermal systems at concentrations substantially lower than in fluids from bare-rock systems may reflect chemical reequilibration during subsurface cooling within the sediment pile.