Strontium and Oxygen isotope compositions from DSDP Holes 54-424A, 54-424B and 70-509B

Strontium and O isotope compositions of green clay minerals from sediment cores of three boreholes drilled into (sites 424A and 509B) and close to a hydrothermal mound (site 424B) near the Galapagos Spreading Center (DSDP Legs 54 and 70) were determined. The green clays consist mostly of a transition from Fesmectite (nontronite) to glauconite. 87Sr/86Sr ratios were measured on clay size-fractions after gentle acid leaching and on the recovered leachates from different samples. The 87Sr/86Sr ratios of the clay residues from both the 424A and B sites are well below the modern seawater value, which points consistently to precipitation from hydrothermal fluids that contained variable amounts of seawater, even away from mound. However, most of the clay residues from mound site 509B have 87Sr/86Sr ratios significantly above the seawater value, suggesting the occurrence of a detrital component together with the new authigenic particles. The clay minerals of the hydrothermal mound are mixed with detrital components, and that of the sample taken outside but near the mound as a reference for the surrounding oceanic environment, yields a hydrothermal signature. Crystallization temperatures of the clays range from 32 to 63 °C assuming a d18O value of +2.2 per mil for the mineralizing fluids. Hydrothermal fluids generated in the underlying oceanic crust, mixed in varied proportions with ambient seawater and migrated into beds of the mound in a sequence of recurrent processes that ultimately resulted in the formation of the observed clay minerals. No significant temperature differences were detected for crystallization of the K-rich glauconite and K-depleted nontronite. The 87Sr/86Sr ratios of the Sr leached off the clay particles are near the value of modern seawater, inferring a progressive replacement of the hydrothermal fluids by seawater in the pore space of the mound sediments.

Mechanical properties and comparisons of dynamic and static Young's moduli at DSDP Holes 69-504B, 70-504B and 83-504B

From laboratory tests under simulated downhole conditions we tentatively conclude that the higher the triaxial-compressive strength, the lower the drilling rate of basalts from DSDP Hole 504B. Because strength is roughly proportional to Young's modulus of elasticity, which is related in turn to seismic-wave velocities, one may be able to estimate drilling rates from routine shipboard measurements. However, further research is needed to verify that P-wave velocity is a generally useful predictor of relative drilling rate.

Elemental and stable isotopic composition of some metalliferous and pelagic sediments at DSDP Leg 70 Holes

Nontronite, the main metalliferous phase of the Galapagos mounds, occurs at subsurface depths of about 2 to 20 meters; Mn-oxide material is limited to the upper 2 meters of the mounds. The nontronite forms intervals of up to a few meters' thickness, consisting essentially of 100% nontronite granules, which alternate with intervals of normal pelagic sediment. Electron microprobe analyses of nontronite granules from different core samples indicate that: (1) there is little difference in major element composition between nontronites from varying locations within the mounds, with adjacent granules from a given sample having very similar compositions; (2) individual granules show little internal variation in composition. This indicates that the granules are composed of a single mineral of essentially constant composition, consistent with relatively uniform conditions of Eh and composition during nontronite formation. Mn-oxide crusts have very low Fe contents, a feature characteristic of rapidly deposited Mn-oxide crusts formed under hydrothermal influences. The rare-earth element (REE) abundances of the nontronites are generally extremely low, totalling less than several ppm. Two samples have the negatively Ce anomaly typical of authigenic precipitates formed relatively rapidly from seawater. A Mn-oxide crust sample has low REE contents, typical of Mn-oxide crusts formed under hydrothermal influences, but no negative Ce anomaly. A sample of unusual Mn-Fe-oxide mud has relatively high REE concentrations and a seawater-type pattern; both of these features are also found for metalliferous sediments from the East Pacific Rise. The oxygen and hydrogen isotopic composition of the nontronites define a restricted field within a d18O-dD plot. In manganiferous sediments, d18O and dD appear to decrease with increase in the Mn-oxide content of the sediment. From the d18O values of the nontronites, formation temperatures in the range of about 20-30°C have been estimated. By comparison, temperatures of up to 11.5 °C at a 9-meter depth have been directly measured within the mounds (Corliss et al., 1979), and heat-flow data suggest present basement/sediment interface temperatures of 15-25°C. In a plot of Fe + Mn vs. d18O, the Mn-oxide crust and Mn-Fe-ooze plot near the tie-lines for authigenic Mn nodules and silicate phases, implying that they have formed in isotopic equilibrium with seawater at or close to bottom-water temperatures.

(Table 2) Dissolution rate of sediments at DSDP Site 70-506

Dissolution rates of calcareous ooze were measured for samples from Deep Sea Drilling Project (DSDP) Site 506, which is in the area of the Galapagos Spreading Center. Using the free-drift method, measurements were carried out at 25 °C and atmospheric pressure. No significant difference in dissolution rates was found among the samples from three holes. However, in the present samples, the concentration of carbonate ion in seawater that is in equilibrium with calcite is 20 to 30% greater than is the case with synthetic calcite. That is, the dissolution rate of calcite under nearequilibrium conditions is greater than that of either synthetic calcite or sediments from the central Pacific (Morse, 1978). These results are consistent with field evidence indicating that the calcium carbonate compensation depth in the Galapagos region is shallower than in most other Pacific regions (Berger et al., 1976).

Two-way traveltimes of internal layers and ice thickness between Dome C - Vostok - Dome A

Chinese scientists will start to drill a deep ice core at Kunlun station near Dome A in the near future. Recent work has predicted that Dome A is a location where ice older than 1 million years can be found. We model flow, temperature and the age of the ice by applying a three-dimensional, thermomechanically coupled full-Stokes model to a 70 × 70 km**2 domain around Kunlun station, using isotropic non-linear rheology and different prescribed anisotropic ice fabrics that vary the evolution from isotropic to single maximum at 1/3 or 2/3 depths. The variation in fabric is about as important as the uncertainties in geothermal heat flux in determining the vertical advection which in consequence controls both the basal temperature and the age profile. We find strongly variable basal ages across the domain since the ice varies greatly in thickness, and any basal melting effectively removes very old ice in the deepest parts of the subglacial valleys. Comparison with dated radar isochrones in the upper one third of the ice sheet cannot sufficiently constrain the age of the deeper ice, with uncertainties as large as 500 000 years in the basal age. We also assess basal age and thermal state sensitivities to geothermal heat flux and surface conditions. Despite expectations of modest changes in surface height over a glacial cycle at Dome A, even small variations in the evolution of surface conditions cause large variation in basal conditions, which is consistent with basal accretion features seen in radar surveys.