Chemical and isotope compositions of main phases of metalliferous sediments from holes of DSDP Leg 92

The carbonate-free metalliferous fraction of thirty-nine sediment samples from four DSDP Leg 92 sites has been analyzed for 12 elements, and a subset of 16 samples analyzed for Pb isotopic composition. The main geochemical features of this component are as follows: i) very high concentrations of Fe and Mn, typically 25-39% and 5-14%, respectively; ii) Al and Ca contents generally less than 2% and 5%, respectively; iii) high Cu (1000-2000 ppm), and Zn and Ni (500-1000 ppm) values; and iv) Co and Pb concentrations of 100-250 ppm. In terms of element partitioning within the metalliferous fraction, amorphous to poorly crystallized oxide-oxyhydroxides removed by the second leach carry virtually all of the Mn, and about 90% of the Ca, Sr and Ni. The well-crystallized goethite-rich material removed by the third leach carries the majority of Fe, Cu, and Pb. These relations hold for sediments as young as ~1-2 Ma, indicating early partitioning of hydrothermal Fe and Mn into separate phases. Calculated mass accumulation rates (MAR) for Fe, Mn, Cu, Pb, Zn and Ni in the bulk sediment show the same overall trends at three of the sites, with greatest MAR values near the basement, and a general decrease in MAR values towards the tops of the holes (for sediments deposited above the lysocline). These relations strongly support the concept of a declining hydrothermal contribution of these elements away from a ridge axis. Nevertheless, MAR values for these metals up to ~200 km from the ridge axis are orders of magnitude higher than on abyssal seafloor plains where there is no hydrothermal influence. Mn/Fe ratios throughout the sediment column at two sites indicate that the composition of the hydrothermal precipitates changed during transport through seawater, becoming significantly depleted in Mn beyond ~200-300 km from the axis, but maintaining roughly the same proportion of Fe. Most of the Pb isotope data for the Leg 92 metalliferous sediments form approximately linear arrays in the conventional isotopic plots, extending from the middle of the field for mid-ocean ridge basalts toward the field for Mn nodules. The array of data lying between these two end-members is most readily interpreted in terms of simple linear mixing of Pb derived from basaltic and seawater end-member sources. The least radiogenic sediments reflect the average Pb isotope composition of discharging hydrothermal solutions and ocean-ridge basalt at the EPR over the ~4-8 Ma B.P. interval. Pb in sediments deposited up to 250 km from the axis can be almost entirely of basaltic-hydrothermal origin. Lateral transport of some basaltic Pb by ocean currents appears to extend to distances of at least 1000 km west of the East Pacific Rise.

3He/4He and 4He/20Ne ratios in pore water and gas in Pacific deep-sea sediments

We have measured the 3He/3He and 3He/20 Ne ratios of thirty-nine pore water and gas samples in deep-sea sediments collected at twelve sites on the Pacific Ocean bottom during the cruises of Deep Sea Drilling Project Legs 87, 89, 90 and 92. The 3He/4He and 4He/20Ne ratios vary from 0.000000215 to 0.00000165 and from 0.29 to 20, respectively. He in the sample is composed of four components: (1) atmospheric He dissolved in seawater; (2) atmospheric He with mantle-derived He in Pacific bottom water; (3) in situ radiogenic He in the sediment; and (4) crustal He in the basement rock. Assuming that the 20Ne contents are constant with the value of seawater, the depth variations in the 4He/20Ne ratios at five Sites, 583D, 594, 597A, 598A and 504B, may provide useful information on 4He flux at the ocean bottom. The estimated 4He fluxes vary from 2000 to 40000 atoms cm**-2 s**-1 and are one to three orders of magnitude less than those calculated from the excess He in deep ocean water. An overall similarity between the geographical distribution of the 3He/4He ratios and heat flow data is found in the study area, between the East Pacific Rise across the Pacific Ocean and the Japanese Islands. The tendency is well explained by a conventional sea-floor spreading model.

Geochemistry and petrogenesis of basalts from DSDP Leg 92 holes

Basalts recovered on DSDP Leg 92 include all the major basalt types so far recovered from the ocean crust of the eastern Pacific. Basalts from Holes 597, 597A, 597B, 597C, and 599B are tholeiites exhibiting all the mineralogical and geochemical characteristics of N-type mid-ocean ridge basalts (MORB). Fragments of ferrobasalts and alkali basalts were also obtained, however, from Holes 60IB and 602B, respectively. Hole 597C, which penetrated 91 m into basement and is the deepest hole so far drilled in fast-spreading crust, yielded basalts that can be divided into three major lithologic units. The lowest unit, Unit III, contains modal olivine and comprises basalts which, at about 8 to 10% MgO, are as basic as any sampled from fast-spreading crust. The middle unit, Unit II, is the most evolved; its basalts are olivine free and contain between 6 and 7.5% MgO. The upper unit, Unit I, is intermediate in composition between Units II and III; it is characterized by both modal olivine and glomerocrysts made up of plagioclase and rare olivine. Unit I is probably a massive flow, whereas Units II and III may be massive flows or sills. The basalts appear to have undergone three stages of alteration ("deuteric," "relatively reducing," and "oxidizing"), the intensity of alteration decreasing markedly downcore. Hole 597B, at 26.4 m of basement penetration the only other "deep" hole, contains just one lithologic unit, which closely resembles Unit I of Hole 597C. Petrogenetic modeling reveals that the three lithologic units in Hole 597C are cogenetic and that they were derived from a depleted mantle source similar to the source of the tholeiites and ferrobasalts sampled in other holes; the alkali basalts are the only rocks derived from enriched mantle. Lavas of Unit III probably lay on the olivine-plagioclase cotectic, whereas the other lavas lay on an olivine-plagioclase-clinopyroxene peritectic. Some 60% of closed-system crystallization is needed to generate the most-evolved from the last-fractionated tholeiite, and a further 50% crystallization (80% overall) is needed to generate the ferrobasalts. Xenocrysts of calcic plagioclase and pseudomorphosed olivine in tholeiites from Hole 597B and Unit I of Hole 597C, and in the ferrobasalts from Hole 601B, provide evidence, however, that some magma mixing may have taken place.