(Table 2) Bottom-hole temperature measurements at DSDP Sites 68-501, 69-504, and 69-505

Drilling durin Deep Sea Drilling Project Legs 68, 69, and 70 on the southern limb of the Costa Rica Rift was used to study geothermal processes in the ocean crust. Two areas were drilled. One was a geothermally hot site on 6.2-m.y.-old crust, where topography is smooth, heat flow is close to that predicted by conductive cooling of the lithosphere (200 mWm**-2), and hydrothermal circulation may be sealed within the crust. The other was on 3.9-m.y.-old crust, where rough topography is associated with low heat flow (15 to 50 mWm**-2) and possible open convection of sea water. At both sites, about 250 m of siliceous-calcareous sediments overlies igneous basement. In the hot area, it blankets the topography, whereas in the cold area, basement outcrops still occur. Operations included numerous down-hole experiments in both areas and hydraulic piston coring of a 230-m sediment section in the hot area. Diagenesis of the sediments appears closely related to temperature. At the hot site, chert was found near basement, and the chemistry of pore fluids, sampled from both sediments and basement, is strongly influenced by reactions within the basement. Strong lateral gradients in the composition of pore fluids occur in the sediments. At the cold site, no chert was found, and bacterial processes within the sediment dominated the chemistry of the pore fluids. Basaltic basement in both areas consists mainly of pillow lavas and thin flows, with occasional more massive units. The basalt is relatively magnesian. The degree of alteration is very small in the cold area, but much more extensive in the hot area. Ease of drilling also shows a strong contrast. Basement penetration reached 562 m in the hot area and was halted because of lack of time; at the cold site, 43 m of basement was cored only with difficulty. The most intensive in-hole experiments were conducted in the hot area. Successful runs with the borehole televiewer allowed basement lithology to be determined and showed the presence of more and less fractured zones. Pulse tests using a single borehole packer gave values of basement permeability of about 2 to 40 millidarcies. Numerous temperature logs established a broadly conductive in situ temperature gradient, with temperatures reaching 120°C at 562 m into the basement. However, anomalously low temperatures in the upper part of the hole, which persisted after drilling disturbance had decayed away, showed that cold ocean water was flowing down the hole and into the basement at about 90 m below the base of the sediments, at rates of about 80 to 100 m/hr. The packer records indicate a pressure at this depth of 10 bars below hydrostatic.

Geochemistry at DSDP Sites 69-505, 69-504 and 70-504

Deep basement penetration during Legs 69 and 70 at Hole 504B in the Panama Basin allowed the recovery of a 561.5-meter sequence of basaltic pillows, thin flows, and breccias interspersed with thick massive flows. The lavas, which are aphyric to moderately plagioclase-olivine-clinopyroxene phyric, are petrologically indistinguishable from typical mid-ocean-ridge basalts (MORB). Some units are distinctive in that they carry accessory chrome-spinel microphenocrysts or emerald green clinopyroxene phenocrysts. Major and trace element analyses were carried out on 67 samples using X-ray fluorescence techniques. The basalts resemble normal MORB in terms of major elements. However, the trace element analyses show that most of the basalts are characterized by very strong depletion in the more incompatible elements compared with, for instance, normal (N type) MORB from the Atlantic at 22°N. Interdigitated with these units are one or two units that have distinctly higher incompatible element concentrations similar to those in basalts of the transitional (T) type from the Reykjanes Ridge (63°N in the Mid-Atlantic Ridge). All the basalts appear to have undergone some high-level crystal fractionation, although this has not proceeded to the extent of yielding ferrobasalts as it has at the adjacent Galapagos Spreading Center or along the East Pacific Rise. The magnetic anomalies are of lower amplitude than in the latter two regions, which suggests that the absence of ferrobasalts may be a general feature of the ocean crust generated at the Costa Rica Rift. The presence of two distinct magma types, one strongly depleted and the other moderately enriched in incompatible elements, suggests that magma chambers at the spreading center are discontinuous rather than continuous and that there is some chemical heterogeneity in the underlying mantle source. Observed variations in incompatible element ratios of basalts from the more depleted group could, however, reflect mixing between these two magma types. In general it would appear that the mantle feeding the Costa Rica Rift is significantly more depleted in incompatible trace elements than that feeding the Mid-Atlantic Ridge.

Major- and trace-elements at DSDP Legs 68-70 Holes

The basalts recovered from the Costa Rica Rift by drilling at Deep Sea Drilling Project Sites 501, 504, and 505 during Legs 68, 69 and 70 of the Glomar Challenger are the most depleted in the most-hygromagmaphile elements (Th, Ta, Nb, and La) of all MORB recovered to date by the Glomar Challenger. The invariant ratios Nb/Ta, Zr/Hf, and Y/Tb show "chondritic values" (expected for Nb/Ta because of the very low concentrations in these elements). Four samples from a single unit are exceptions: they present a flat to slightly enriched, extended Coryell-Masuda plot, and at the same time their La/Ta ratio is 9 (normalized ratio = 1) instead of 19 (normalized ratio = 2), the value for all other samples. Only one of these two values of the La/Ta ratio had been found so far within a single hole, and moreover within large areas of the oceanic crust (several holes or dredges). The present result shows that local heterogeneity of the upper mantle with respect to the La/Ta ratio may exist.

Pacific Neogene carbonate accumulation rates

I have compiled CaCO3 mass accumulation rates (MARs) for the period 0-25 Ma for 144 Deep Sea Drilling Project and Ocean Drilling Program drill sites in the Pacific in order to investigate the history of CaCO3 burial in the world's largest ocean basin. This is the first synthesis of data since the beginning of the Ocean Drilling Program. Sedimentation rates, CaCO3 contents, and bulk density were estimated for 0.5 Myr time intervals from 0 to 14 Ma and for 1 Myr time intervals from 14 to 25 Ma using mostly data from Initial Reports volumes. There is surprisingly little coherence between CaCO3 MAR time series from different Pacific regions, although regional patterns exist. A transition from high to low CaCO3 MAR from 23-20 Ma is the only event common to the entire Pacific Ocean. This event is found worldwide. The most likely cause of lowered pelagic carbonate burial is a rising sea-level trend in the early Miocene. The central and eastern equatorial Pacific is the only region with adequate drill site coverage to study carbonate compensation depth (CCD) changes in detail for the entire Neogene. The latitude-dependent decrease in CaCO3 production away from the equator is an important defining factor of the regional CCD, which shallows away from the equatorial region. Examination of latitudinal transects across the equatorial region is a useful way to separate the effects of changes in carbonate production ('productivity') from changes in bottom water chemistry ('dissolution') upon carbonate burial.

Geochemistry and minerals at DSDP Legs 68-70 Holes

The compositions of natural glasses and phenocrysts in basalts from Deep Sea Drilling Project Sites 501, 504, and 505, near the Costa Rica Rift, constitute evidence for the existence of a periodically replenished axial magma chamber that repeatedly erupted lavas of remarkably uniform composition. Magma compositions were affected by three general components: (1) injected magmas carrying (in decreasing order of abundance) Plagioclase, olivine, and chrome-spinel phenocrysts (spinel assemblage); (2) injected magmas carrying Plagioclase, clinopyroxene, and olivine phenocrysts, but no spinel (clinopyroxene assemblage); and (3) moderately evolved hybrids in the magma chamber itself. The compositions of the injected phenocrysts and minerals in glomerocrysts are as follows: Plagioclase - An85-94; olivine - Fo87-89; clinopyroxene - high Cr2O3 (0.7-1.1%), endiopside (Wo42En51Fs7), and aluminous chromian spinel (Cr/Cr + Al = 0.3). These minerals resemble those thought to occur in upper mantle sources (9 kbars and less) of ocean-ridge basalts and to crystallize in magmas near those sources. In the magma chamber, more sodic Plagioclase (An79-85), less magnesian olivine (Fo81-86) and low-Cr2O3 (0.1-0.4%) clinopyroxene formed rims on these crystals, grew as other phenocrysts, and formed cumulus segregations on the walls and floors of the magma chamber. In the spinel-assemblage magmas, magnesiochromite (Cr/Cr + Al = 0.4-0.5) also formed. Some cumulus segregations were later entrained in lavas as xenoliths. The glass compositions define 16 internally homogeneous eruptive units, 13 of which are in stratigraphic order in a single hole, Hole 504B, which was drilled 561.5 meters into the ocean crust. These units are defined as differing from each other by more than analytical uncertainty in one or more oxides. However, many of the glass groups in Hole 504B show virtually no differences in TiO2 contents, Mg/Mg + Fe2+, or normative An/An + Ab, all of which are sensitive indicators of crystallization differentiation. The differences are so small that they are only apparent in the glass compositions; they are almost completely obscured in whole-rock samples by the presence of phenocrysts and the effects of alteration. Moreover, several of the glass units at different depths in Hole 504B are compositionally identical, with all oxides falling within the range of analytical uncertainty, with only small variations in the rest of the suite. The repetition of identical chemical types requires (1) very regular injection of magmas into the magma chamber, (2) extreme similarity of injected magmas, and (3) displacement of very nearly the same proportion of the magmas in the chamber at each injection. Numerical modeling and thermal considerations have led some workers to propose the existence of such conditions at certain types of spreading centers, but the lava and glass compositions at Hole 504B represent the first direct evidence revealed by drilling of the existence of a compositionally nearly steady-state magma chamber, and this chapter examines the processes acting in it in some detail. The glass groups that are most similar are from clinopyroxene-assemblage lavas, which have a range of Mg/Mg + Fe2"1" of 0.59 to 0.65. Spinel-assemblage basalts are less evolved, with Mg/Mg + Fe2+ of 0.65 to 0.69, but both types have nearly identical normative An/An + Ab (0.65-0.66). However, the two lava types contain megacrysts (olivine, Plagioclase, clinopyroxene) that crystallized from melts with Mg/Mg + Fe2+ values of 0.70 to 0.72. Projection of glass compositions into ternary normative systems suggests that spinel-assemblage magmas originated deeper in the mantle than clinopyroxene-assemblage magmas, and mineral data indicate that the two types followed different fractionation paths before reaching the magma chamber. The two magma types therefore represent neither a low- nor a high-pressure fractionation sequence. Some of the spinel-assemblage magmas may have had picritic parents, but were coprecipitating all of the spinel-assemblage phenocrysts before reaching the magma chamber. Clinopyroxene-assemblage magmas did not have picritic parents, but the compositions of phenocrysts suggest that they originated at about 9 kbars, near the transition between plagioclase peridotite and spinel peridotite in the mantle. Two glass groups have higher contents of alkalis, TiO2, and P2O5 than the others, evidently as a result of the compositions of mantle sources. Eruption of these lavas implies that conduits and chambers containing magmas from dissimilar sources were not completely interconnected on the Costa Rica Rift. The data are used to draw comparisons with the East Pacific Rise and to consider the mechanisms that may have prevented the eruption of ferrobasalts at these sites.