(Table 2) Bottom-hole temperature measurements at DSDP Sites 68-501, 69-504, and 69-505

Drilling durin Deep Sea Drilling Project Legs 68, 69, and 70 on the southern limb of the Costa Rica Rift was used to study geothermal processes in the ocean crust. Two areas were drilled. One was a geothermally hot site on 6.2-m.y.-old crust, where topography is smooth, heat flow is close to that predicted by conductive cooling of the lithosphere (200 mWm**-2), and hydrothermal circulation may be sealed within the crust. The other was on 3.9-m.y.-old crust, where rough topography is associated with low heat flow (15 to 50 mWm**-2) and possible open convection of sea water. At both sites, about 250 m of siliceous-calcareous sediments overlies igneous basement. In the hot area, it blankets the topography, whereas in the cold area, basement outcrops still occur. Operations included numerous down-hole experiments in both areas and hydraulic piston coring of a 230-m sediment section in the hot area. Diagenesis of the sediments appears closely related to temperature. At the hot site, chert was found near basement, and the chemistry of pore fluids, sampled from both sediments and basement, is strongly influenced by reactions within the basement. Strong lateral gradients in the composition of pore fluids occur in the sediments. At the cold site, no chert was found, and bacterial processes within the sediment dominated the chemistry of the pore fluids. Basaltic basement in both areas consists mainly of pillow lavas and thin flows, with occasional more massive units. The basalt is relatively magnesian. The degree of alteration is very small in the cold area, but much more extensive in the hot area. Ease of drilling also shows a strong contrast. Basement penetration reached 562 m in the hot area and was halted because of lack of time; at the cold site, 43 m of basement was cored only with difficulty. The most intensive in-hole experiments were conducted in the hot area. Successful runs with the borehole televiewer allowed basement lithology to be determined and showed the presence of more and less fractured zones. Pulse tests using a single borehole packer gave values of basement permeability of about 2 to 40 millidarcies. Numerous temperature logs established a broadly conductive in situ temperature gradient, with temperatures reaching 120°C at 562 m into the basement. However, anomalously low temperatures in the upper part of the hole, which persisted after drilling disturbance had decayed away, showed that cold ocean water was flowing down the hole and into the basement at about 90 m below the base of the sediments, at rates of about 80 to 100 m/hr. The packer records indicate a pressure at this depth of 10 bars below hydrostatic.

Geochemistry at DSDP Sites 69-505, 69-504 and 70-504

Deep basement penetration during Legs 69 and 70 at Hole 504B in the Panama Basin allowed the recovery of a 561.5-meter sequence of basaltic pillows, thin flows, and breccias interspersed with thick massive flows. The lavas, which are aphyric to moderately plagioclase-olivine-clinopyroxene phyric, are petrologically indistinguishable from typical mid-ocean-ridge basalts (MORB). Some units are distinctive in that they carry accessory chrome-spinel microphenocrysts or emerald green clinopyroxene phenocrysts. Major and trace element analyses were carried out on 67 samples using X-ray fluorescence techniques. The basalts resemble normal MORB in terms of major elements. However, the trace element analyses show that most of the basalts are characterized by very strong depletion in the more incompatible elements compared with, for instance, normal (N type) MORB from the Atlantic at 22°N. Interdigitated with these units are one or two units that have distinctly higher incompatible element concentrations similar to those in basalts of the transitional (T) type from the Reykjanes Ridge (63°N in the Mid-Atlantic Ridge). All the basalts appear to have undergone some high-level crystal fractionation, although this has not proceeded to the extent of yielding ferrobasalts as it has at the adjacent Galapagos Spreading Center or along the East Pacific Rise. The magnetic anomalies are of lower amplitude than in the latter two regions, which suggests that the absence of ferrobasalts may be a general feature of the ocean crust generated at the Costa Rica Rift. The presence of two distinct magma types, one strongly depleted and the other moderately enriched in incompatible elements, suggests that magma chambers at the spreading center are discontinuous rather than continuous and that there is some chemical heterogeneity in the underlying mantle source. Observed variations in incompatible element ratios of basalts from the more depleted group could, however, reflect mixing between these two magma types. In general it would appear that the mantle feeding the Costa Rica Rift is significantly more depleted in incompatible trace elements than that feeding the Mid-Atlantic Ridge.

Composition of sedimentary material from the bottom and the area surrounding the Lake Untersee, East Antarctica

This paper presents data on geographic and geologic conditions of modern sedimentation in the Lake Untersee, the largest lake in the East Antarctica. Geochemical and sedimentation data indicate that the leading mechanism supplying aluminosilicate sedimentary material to the surface layer of bottom sediments is seasonal melting of the Anuchin glacier and the mountain glacier on the southeastern part of the valley hosting the lake. Strongly reduced conditions in the lowermost 25 m of the water column in the smaller of two depressions of the lake bottom were favorable for enrichment of the bottom sediments in bacteriogenic organic matter, Mo, Au, and Pd. H2S-contaminated water results to significant enrichment of the sediments only in redox-sensitive elements that are able to migrate in anionic complexes and precipitate (co-precipitate) as sulfides.