(Table 1) Stable nitrogen isotopes of ammonium in interstitial waters from ODP Site 164-997

Ammonium (NH4+) concentration profiles in piston-core sediments of the Carolina Rise and Blake Ridge generally have linear concentration profiles within the sulfate reduction zone (Borowski, 1998). Deep Sea Drilling Project (DSDP) Site 533, located on the Blake Ridge, also displayed a linear ammonium concentration profile through the sulfate reduction zone and the profile linearity continues into the upper methanogenic zone to a depth of ~200 meters below seafloor (mbsf), where the first methane gas hydrates probably occur (Jenden and Gieskes, 1983, doi:10.2973/dsdp.proc.76.114.1983; Kvenvolden and Barnard, 1983, doi:10.2973/dsdp.proc.76.106.1983). Sediments from the Ocean Drilling Program (ODP) Leg 164 deep holes (Sites 994, 995, and 997) also exhibit linear ammonium profiles above the top of the gas hydrate zone (~200 mbsf) (Paull, Matsumoto, Wallace, et al., 1996, doi:10.2973/odp.proc.ir.164.1996). We hypothesized that a possible cause of linear ammonium profiles was diffusion of ammonium from a concentrated ammonium source at depth. We further reasoned that if this ammonium were produced by microbial fermentation reactions at depth, that a comparison of the nitrogen isotopic composition of sedimentary organic nitrogen and the nitrogen with pore-water ammonium would test this hypothesis. Convergence with depth of d15N values of the nitrogen source (sedimentary organic matter) and the nitrogen product (dissolved NH4+) would strongly suggest that ammonium was produced within a particular depth zone by microbial fermentation reactions. Here, we report d15N values of pore-water ammonium from selected interstitial water (IW) samples from Site 997, sampled during ODP Leg 164.

Gas, water and volume characteristics during controlled degassing experiments on ODP Leg 164 PCS cores

A pressurized core with CH4 hydrate or dissolved CH4 should evolve gas volumes in a predictable manner as pressure is released over time at isothermal conditions. Incremental gas volumes were collected as pressure was released over time from 29 pressure core sampler (PCS) cores from Sites 994, 995, 996, and 997 on the Blake Ridge. Most of these cores were kept at or near 0ºC with an ice bath, and many of these cores yielded substantial quantities of CH4. Volume-pressure plots were constructed for 20 of these cores. Only five plots conform to expected volume and pressure changes for sediment cores with CH4 hydrate under initial pressure and temperature conditions. However, other evidence suggests that sediment in these five and at least five other PCS cores contained CH4 hydrate before core recovery and gas release. Detection of CH4 hydrate in a pressurized sediment core through volume-pressure relationships is complicated by two factors. First, significant quantities of CH4-poor borehole water fill the PCS and come into contact with the core. This leads to dilution of CH4 concentration in interstitial water and, in many cases, decomposition of CH4 hydrate before a degassing experiment begins. Second, degassing experiments were conducted after the PCS had equilibrated in an ice-water bath (0ºC). This temperature is significantly lower than in situ values in the sediment formation before core recovery. Our results and interpretations for PCS cores collected on Leg 164 imply that pressurized containers formerly used by the Deep Sea Drilling Project (DSDP) and currently used by ODP are not appropriately designed for direct detection of gas hydrate in sediment at in situ conditions through volume-pressure relationships.