Seasonal cycles of monthly means of ground truth wind speed of METAR station GVAC and of area-averaged TMI wind speed at 37 GHz for the Cape Verde Island Sal

In the present paper ground truth and remotely sensed datasets were used for the investigation and quantification of the impact of Saharan dust on microwave propagation, the verification of theoretical results, and the validation of wind speeds determined by satellite microwave sensors. The influence of atmospheric dust was verified in two different study areas by investigations of single dust storms, wind statistics, wind speed scatter plots divided by the strength of Saharan dust storms, and wind speed differences in dependence of microwave frequencies and dust component of aerosol optical depth. An increase of the deviations of satellite wind speeds to ground truth wind speeds with higher microwave frequencies, with stronger dust storms, and with higher amount of coarse dust aerosols in coastal regions was obtained. Strong Saharan dust storms in coastal areas caused mean relative errors in the determination of wind speed by satellite microwave sensors of 16.3% at 10.7 GHz and of 20.3% at 37 GHz. The mean relative errors were smaller in the open sea area with 3.7% at 10.7 GHz and with 11.9% at 37 GHz.

Horizontal profiles of longwave and shortwave radiation components over sea ice near Barrow, Alaska during the 2011 melt

An integrated instrument package for measuring and understanding the surface radiation budget of sea ice is presented, along with results from its first deployment. The setup simultaneously measures broadband fluxes of upwelling and downwelling terrestrial and solar radiation (four components separately), spectral fluxes of incident and reflected solar radiation, and supporting data such as air temperature and humidity, surface temperature, and location (GPS), in addition to photographing the sky and observed surface during each measurement. The instruments are mounted on a small sled, allowing measurements of the radiation budget to be made at many locations in the study area to see the effect of small-scale surface processes on the large-scale radiation budget. Such observations have many applications, from calibration and validation of remote sensing products to improving our understanding of surface processes that affect atmosphere-snow-ice interactions and drive feedbacks, ultimately leading to the potential to improve climate modelling of ice-covered regions of the ocean. The photographs, spectral data, and other observations allow for improved analysis of the broadband data. An example of this is shown by using the observations made during a partly cloudy day, which show erratic variations due to passing clouds, and creating a careful estimate of what the radiation budget along the observed line would have been under uniform sky conditions, clear or overcast. Other data from the setup's first deployment, in June 2011 on fast ice near Point Barrow, Alaska, are also shown; these illustrate the rapid changes of the radiation budget during a cold period that led to refreezing and new snow well into the melt season.

Diatom events and Neogene nannofossils of ODP Hole 201-1225A

Shipboard investigation of magnetostratigraphy and shore-based investigation of diatoms and calcareous nannofossils were used to identify datum events in sedimentary successions collected at Ocean Drilling Program (ODP) Leg 201 Site 1225. The goal was to extend the magnetic record previously studied at the same site, ODP Leg 138 Site 851, and provide a comprehensive age model for Site 1225. Two high-magnetic intensity zones at 0-70 and 200-255 meters below seafloor (mbsf) were correlated with lithologic Subunits IA and IC in Hole 1225A. Subunit IA (0-70 mbsf) contains the magnetic reversal record until the Cochiti Subchronozone (3.8 Ma) and has a sedimentation rate of 1.7 cm/k.y. This agrees with previous work done at Site 851. Subunit IC (200-255 mbsf) was not sampled at Site 851. Diatom and nannofossil biostratigraphy constrained this subunit, and we found it to contain the magnetic reversal record between Subchrons C4n.2r and C5n.2n (8.6-9.7 Ma), yielding a sedimentation rate of 2.7 cm/k.y. Biostratigraphy was used to establish the sedimentation rates within Subunits IB and ID (70-200 mbsf and 255-300 mbsf, respectively). These subunits had higher sedimentation rates (~3.4 cm/k.y.) and coincide with the late Miocene-early Pliocene biogenic bloom event (4.5-7 Ma) and the Miocene global cooling trend (10-15 Ma). High biogenic productivity associated with these subunits resulted in the pyritization of the magnetic signal. In lithologic Subunit ID, basement flow is another factor that may be altering the magnetic signal; however, the good correlation between the biostratigraphy and magnetostratigraphy indicates that the magnetic record was locked-in near the seafloor and suggests the age model is robust.

(Table DR1) Biogenic silica and chert in the Pacific Ocean, DSDP and ODP data

Evidence for the dissolution of biogenic silica at the base of pelagic sections supports the hypothesis that much of the chert formed in the Pacific derives from the dissolution and reprecipitation of this silica by hydrothermal waters. As ocean bottom waters flow into and through the crust, they become warmer. Initially they remain less saturated with respect to dissolved silica than pore water in the overlying sediments. With the diffusion of heat, dissolved ions, and to some extent the advection of water itself, biogenic silica in the basal part of the sedimentary section is dissolved. Upon conductively cooling, these pore waters precipitate chert layers. The most common thickness for the basal silica-free zone (20 m) lies below the most common height of the top of the chert interval above basement (50 m). This mode of chert formation explains the frequent occurrence of chert layers at very shallow subbottom depths in pelagic sections of the Pacific. It is also consistent with the common occurrence of cherts

(Table T2) Sulfur isotopes of pore water from ODP Leg 201 sites

Fifty-seven interstitial water samples from six sites (Ocean Drilling Program Sites 1225-1229 and 1231) in the eastern equatorial Pacific Ocean and the Peru margin were analyzed for the stable sulfur isotopic composition (34S/32S) of dissolved sulfate along with major and minor ions. With the exception of Site 1231, sulfate from the interstitial fluids (d34S values as much as 89 per mil vs. the SF6-based Vienna-Canyon Diablo troilite standard) is found at depth to be enriched in 34S with respect to modern seawater sulfate (d34S = ~21 per mil), indicating that microbial sulfate reduction (MSR) took place to different extents at all investigated sites. Deeper sediments at Sites 1228 and 1229 are additionally influenced by diffusion of a sulfate-rich brine that has already undergone sulfate reduction. The intensity of MSR depends on the availability of substrate (organic matter), sedimentation conditions, and the active bacterial community structure. Formation of isotopically heavy diagenetic barite at the sulfate-methane transition zone is expected at Sites 1227 (one front), 1229 (two fronts), and probably Site 1228. At Site 1231, the constant sulfur isotopic composition of sulfate and concentrations of minor pore water ions indicate that suboxic (essentially iron and manganese oxide based) diagenesis dominates and no net MSR occurs.

Composition of ferromanganese crusts from the Atlantic, Pacific and Indian Oceans

A collection of layered ferromanganese ores (27 samples) from the Atlantic and Pacific oceans was studied. Trace element and PGE contents were determined layer-by-layer (up to 10 microlayers) in 13 of these samples. The trace, rare earth, and platinum group element distributions, including their layer-to-layer variations, were compared in hydrogenic and hydrothermal crusts from different regions. It was found that the main PGE variations (by a factor of 10-50) are related to their layer-to-layer variations within a given ore field. The distributions of PGE and trace elements are strongly heterogeneous, which is related, first, to different contents of the elements in the layers of different age in ferromanganese crusts (FMC) and, second, to the observed regional heterogeneity and influence of hydrothermal fluids. Geochemical data indicate that CFC formation was mainly caused by the hydrochemical precipitation of material from seawater. This process was accompanied by diagenetic phenomena, water-rock interaction, and influence of volcanic and hydrothermal sources.