Pore-water chemistry of ODP Leg 115 samples

Analyses of the Sr2+ concentrations of interstitial fluids obtained from sediments squeezed during Leg 115 were used to estimate the rates and total amount of recrystallization of biogenic carbonates. The total amount of recrystallization calculated using this method varies from less than 1 % in sediments at Site 706 to more than 40% at Site 709 in sediments of 47 Ma. Five of the sites drilled during Leg 115 (Sites 707 through 711) were drilled in a depth transect within a restricted geographic area so that theoretically they received similar amounts of sediment input. Of these, the maximum rate of recrystallization occurred in the upper 50 m of Site 710 (3812 m). The amount of recrystallization decreased with increasing water depth at Sites 708 (4096 m) and 711 (4428 m), presumably as a result of the fact that most of the reactive calcium carbonate was dissolved before burial. We also observed significant alkalinity deficits at many of these sites, a condition which most likely resulted from the precipitation of calcium carbonate either in the sedimentary column, or during retrieval of the core. Precipitation of CaCO3 as a result of pressure changes during core retrieval was confirmed by the comparison of Ca2+ and alkalinity from water samples obtained using the in-situ sampler and squeezed from the sediments. At Sites 707 and 716, the shallowest sites, no calcium or alkalinity deficits were present. In spite of our estimations of as much as 45% recrystallization at Site 709, all the carbonate sites exhibited what would be previously considered conservative Ca2+/Mg2+ profiles, which varied from -1 to -0.5. By virtue of the position of these sites relative to known basaltic basement or through the actual penetration of basalt (i.e., Sites 706, 707 and 712), these sites are all known to be underlain by basalt. Our results suggest, therefore, that more positive Ca2 + /Mg2+ gradients cannot necessarily be used as indicators of the nature of basement material.

Petrography, chemistry and magnetic properties of ODP Leg 115 basalts

A detailed study of the Fe-Ti oxides in four basalt samples-one from each of the four holes drilled into basement on Ocean Drilling Program Leg 115 (Sites 706, 707, 713, and 715) has been performed. Ilmenite is present only in samples from Sites 706 and 715. In the sample from Site 715, Ti-magnetite intergrowths are characteristic of subaerial (?) high-temperature oxy-exsolution; Ti-magnetite in the other three samples has experienced pervasive low-temperature oxidation to Ti-maghemite, as evidenced by the double-humped, irreversible, saturation magnetization vs. temperature (Js/T) curves. The bulk susceptibility of these samples, which are similar in terms of major element chemistry, varies by a factor of ~20 and correlates semiquantitatively with the modal abundance of Fe-Ti spinel, as determined by image analysis with an electron microprobe. The variation in Fe-Ti oxide abundance correlates with average grain size: fine-grained samples contain less Fe-Ti oxide. This prompts the speculation that the crystallization rate may also influence Fe-Ti oxide abundance.

Isotope ratios of basalts from ODP Leg 115 holes (Table 1)

Strontium, neodymium, and lead isotope ratios are reported for 13 Leg 115 basalts as well as 3 basalts from Texaco drill hole SM-1 on the Mascarene Plateau. The 87Sr/86Sr ratios and eNd range from 0.70330 to 0.70439 and 5.5 to 7.4, respectively, although 87Sr/86Sr ratios higher than 0.70383 are found only in SM-1 basalts. The high 87Sr/86Sr values are thought to reflect seawater Sr in secondary phases, although all samples were strongly leached in HC1 before analysis. 206Pb/204Pb ratios range from 18.53 to 18.80, and sho high 207Pb/204Pb and 208Pb/204Pb ratios relative to 206Pb/204Pb ratios, typical of Indian Ocean mid-ocean ridge (MORB) and oceanic-island basalts (OIB). Isotopic compositions of Leg 115 basalts generally fall between fields for MORB and Reunion Island basalts, consistent with the conclusion drawn from geochronological studies that Deccan flood basalt volcanism, the Chagos-Laccadive Ridge, and the Mascarene Plateau are all products of the Reunion mantle plume. Isotopic compositions of magmas produced by this plume have varied systematically with time in the direction of less "depleted," less MORB-like isotopic signatures. This compositional change has been accompanied by a decrease in eruption rate. We interpret Deccan volcanism as the voluminous beginning of the plume. Reduced entrainment of asthenosphere following melting of the plume head resulted in less MORB-like isotope ratios in magmas and a decrease in eruptive activity with time.

Model - data comparison of western African rainfall evolutions during the Last Interglacial (130-115 ka)

This dataset characterizes the evolution of western African precipitation indicated by marine sediment geochemical records in comparison to transient simulations using CCSM3 global climate model throughout the Last Interglacial (130-115 ka). It contains (1) defined tie-points (age models), newly published stable isotopes of benthic foraminifera and Al/Si log-ratios of eight marine sediment cores from the western African margin and (2) annual and seasonal rainfall anomalies (relative to pre-industrial values) for six characteristic latitudinal bands in western Africa simulated by CCSM3 (two transient simulations: one non-accelerated and one accelerated experiment).