721 resultados para Soil organic carbon
Resumo:
A series of C2-C8 hydrocarbons (including saturated, aromatic, and olefinic compounds) from deep-frozen core samples taken during DSDP Leg 75 (Holes 530A and 532) were analyzed by a combined hydrogen-stripping/thermovaporization method. Concentrations representing both hydrocarbons dissolved in the pore water and adsorbed on the mineral surfaces vary in Hole 530A from about 10 to 15,000 ng/g of dry sediment weight depending on the lithology (organic-carbon-lean calcareous oozes versus "black shales"). Likewise, the organic-carbon-normalized C2-C8 hydrocarbon concentrations vary from 3,500 to 93,100 ng/g Corg, reflecting drastic differences in the hydrogen contents and hence the hydrocarbon potential of the kerogens. The highest concentrations measured of nearly 10**5 ng/g Corg are about two orders of magnitude below those usually encountered in Type-II kerogen-bearing source beds in the main phase of petroleum generation. Therefore, it was concluded that Hole 530A sediments, even at 1100 m depth, are in an early stage of evolution. The corresponding data from Hole 532 indicated lower amounts (3,000-9,000 ng/g Corg), which is in accordance with the shallow burial depth and immaturity of these Pliocene/late Miocene sediments. Significant changes in the light hydrocarbon composition with depth were attributed either to changes in kerogen type or to maturity related effects. Redistribution pheonomena, possibly the result of diffusion, were recognized only sporadically in Hole 530A, where several organic-carbon lean samples were enriched by migrated gaseous hydrocarbons. The core samples from Hole 530A were found to be severely contaminated by large quantities of acetone, which is routinely used as a solvent during sampling procedures on board Glomar Challenger.
Resumo:
Regional consequences of the biotic extinctions and of the changes in biological productivity that occurred at the time of the Cretaceous/Tertiary (K/T) boundary were investigated by comparison of organic matter in sediments from three southern Tethyan margin locations. Organic matter characterization comprised Rock-Eval pyrolysis and organic carbon measurements. Low concentrations of organic matter precluded additional detailed determinations. At all three locations, the organic matter has been microbially reworked and evidently was deposited in oxygenated marine environments.
Resumo:
Uranium series nuclide concentrations have been measured on sediments from five box cores from an equatorial Pacific transect. 230Thexcess activities show discontinuities at the Holocene-glacial boundary as dated by 14C. The glacial sedimentation rates determined by 230Th and 14C are 2.5-3.0 cm/kyr. The Holocene rates from 230Th are much lower than those dated by 14C (1.9-2.3 cm/kyr) because of carbonate dissolution. 230Th sedimentation fluxes exceed water column supply by factors of 1.2-1.8 in the Holocene and 1.8-3.0 in the glacial sections. A number of models have been applied to calculate carbonate dissolution rates. The results show that carbonate dissolution rates in the Holocene (in g/cm**2 kyr) equal 1.5 * 10**-3 exp (1.4D) where D is water depth in kilometers. A point-by- point estimation of sediment fluxes through time show that clay accumulation rates in the area have been near constant at 0.1-0.2 g/cm**2 kyr over the past 20 kyr whereas carbonate accumulation rates have decreased dramatically from 0.6-1.0 g/cm**2 kyr in the glacial sections of the cores to 0.2-0.6 g/cm**2 kyr in the Holocene. The errors caused by the uncertainties in the age of the termination of the last glacial period have been investigated and results show that a range of 11-14 kyr leads to an error upper limit of about 30% in the estimation of CaCO3 dissolution rates. The response time of CaCO3 and 230Thex concentrations in the mixed layer of sediments due to an impulse of change in CaCO3 dissolution rate has also been discussed, showing that the observed changes in carbonate dissolution may be explained in terms of a single or a continuous change, depending upon the thickness of the mixed layer.