Mineralogical composition of the upper 300m of Hole 302-M0002A

During the Arctic Coring Expedition (ACEX), a 428-m-thick sequence of Upper Cretaceous to Quaternary sediments was penetrated. The mineralogical composition of the upper 300 m of this sequence is presented here for the first time. Heavy and clay mineral associations indicate a major and consistent shift in provenance, from the Barents-Kara - western Laptev Sea region, characterized by presence of common clinopyroxene, to the eastern Laptev-East Siberian seas in the upper part of the section, characterized by common hornblende (amphibole). Sea ice originating from the latter source region must have survived at least one summer melt cycle in order to reach the ACEX drill site, if considering modern sea ice trajectories and velocities. This shift in mineral assemblages probably represents the onset of a perennial sea ice cover in the Arctic Ocean, which occurred at about 13 Ma, thus suggesting a coeval freeze in the Arctic and Antarctic regions.

Chemical and mineral compositions of cherty and siliceous-clayey rocks from accretionary complexes in Sikhote Alin

The paper reports results of a study of clastic heavy mineral assemblages and geochemical features of some assemblages in several Permian-Mesozoic cherty and siliceous-clayey sequences of the Sikhote Alin Region. They are composed of pelagic and hemipelagic sediments of the Panthalassa (Paleopacific) Ocean. Four typical mineral assemblages and their environments are established. In one of the ocean segments, where the sedimentary cover formed during Late Paleozoic - Early Cretaceous, the Permian pelagic domain was characterized by the amphibole-pyroxene assemblage with heavy minerals derived from ophiolites. The Triassic-Jurassic stage was marked by development of the clinopyroxene assemblage with heavy minerals derived from intraplate alkaline volcanic complexes. Middle-Late Jurassic hemipelagic sediments host the zircon-clinopyroxene assemblage with greater role of continental environments and presence of volcanic products of the convergence zone. Another segment of the ocean accumulated red cherts and siliceous-clayey sediments during Jurassic - Early Cretaceous under influence of island-arc volcanism.

Grain counts and relative abundances of volcaniclastic sands and sandstones of ODP Leg 180 sites

Modal analysis of middle Miocene to Pleistocene volcaniclastic sands and sandstones recovered from Sites 1108, 1109, 1118, 1112, 1115, 1116, and 1114 within the Woodlark Basin during Leg 180 of the Ocean Drilling Program indicates a complex source history for sand-sized detritus deposited within the basin. Volcaniclastic detritus (i.e., feldspar, ferromagnesian minerals, and volcanic rock fragments) varies substantially throughout the Woodlark Basin. Miocene sandstones of the inferred Trobriand forearc succession contain mafic and subordinate silicic volcanic grains, probably derived from the contemporary Trobriand arc. During the late Miocene, the Trobriand outerarc/forearc (including Paleogene ophiolitic rocks) was subaerially exposed and eroded, yielding sandstones of dominantly mafic composition. Rift-related extension during the late Miocene-late Pliocene led to a transition from terrestrial to neritic and finally bathyal deposition. The sandstones deposited during this period are composed dominantly of silicic volcanic detritus, probably derived from the Amphlett Islands and surrounding areas where volcanic rocks of Pliocene-Pleistocene age occur. During this time terrigenous and metamorphic detritus derived from the Papua New Guinea mainland reached the single turbiditic Woodlark rift basin (or several subbasins) as fine-grained sediments. At Sites 1108, 1109, 1118, 1116, and 1114, serpentinite and metamorphic grains (schist and gneiss) appear as detritus in sandstones younger than ~3 Ma. This is thought to reflect a major pulse of rifting that resulted in the deepening of the Woodlark rift basin and the prevention of terrigenous and metamorphic detritus from reaching the northern rift margin (Site 1115). The Paleogene Papuan ophiolite belt and the Owen Stanley metamorphics were unroofed as the southern margin of the rift was exhumed (e.g., Moresby Seamount) and, in places, subaerially exposed (e.g., D'Entrecasteaux Islands and onshore Cape Vogel Basin), resulting in new and more proximal sources of metamorphic, igneous, and ophiolitic detritus. Continued emergence of the Moresby Seamount during the late Pliocene-early Pleistocene bounded by a major inclined fault scarp yielded talus deposits of similar composition to the above sandstones. Upper Pliocene-Pleistocene sandstones were deposited at bathyal depths by turbidity currents and as subordinate air-fall ash. Silicic glassy (high-K calc-alkaline) volcanic fragments, probably derived from volcanic centers located in Dawson and Moresby Straits, dominated these sandstones.

(Table 1) Mineral composition of ODP Hole 125-778A

The high-pressure, low-temperature metamorphic rocks known as blueschists have long been considered to form in subduction zones, where the descent of a relatively cold slab leads to the occurrence of unusually low temperatures at mantle pressures. Until now, however, the link between blueschist-facies rocks and subduction zones has been indirect, relying on a spatial association of blueschists with old subduction complexes, and estimates of the geothermal gradients likely to exist in subduction zones. Here we strengthen this link, by reporting the discovery of blueschist-facies minerals (lawsonite, aragonite, sodic pyroxene and blue amphibole) in clasts from a serpentinite seamount in the forearc of the active Mariana subduction zone. The metamorphic conditions estimated from the mineral compositions are 150-250 °C and 5-6 kbar (16-20 km depth). The rocks must have been entrained in rising serpentine mud diapirs, and extruded from mud volcanoes onto the sea floor. Further study of these rocks may provide new insight into the tectonics of trench-forearc systems, and in particular, the processes by which blueschist-facies clasts come to be associated with forearc sediments in ancient subduction complexes.

(Table 1) Heavy mineral content in sediments of the southern Mediterranean Ridge, Nile Cone and Egyptian Shelf

Petrographic analysis of Quaternary terrigenous sand layers in eastern Mediterranean cores reveals distinct mineralogical differences between the Egyptian Shelf-Nile Cone region and the southern part of the Mediterranean Ridge. A compositionally and texturally immature suite in Ridge cores, mixed with a Nile-derived assemblage, identifies a fresh non-recycled mineral component derived from proximal igneous and metamorphic surface or near-surface exposures, probably in the south-central Ridge area rather than from distal African sources. The presence of such basement terrains would be consistent with a compressive thrust-belt origin for this part of the Mediterranean Ridge.

Chemical and mineral composition of rocks from the Philippine Sea

The book is devoted to geology of the Philippine Sea floor. This region is studied most extensively among other marginal seas of the Pacific Ocean. Rocks of the sedimentary and basalt layers within this sea have been studied during five legs of D/S Glomar Challenger. International geological expedition on board R/V Dmitry Mendeleev carried out according to the Project ''Ophiolites of Continents and Comparable Rocks of the Ocean Floor''obtained unique collection of rocks from the second and third layers of the ocean crust in the Philippine Sea. The book provides detailed petrographic and geochemical description of igneous and sedimentary formations from the Philippine Sea and compares them with rocks of the continental ophiolite association. An analysis of structure and history of the ocean crust formation in the region is based on all known geological information. The main periods of tectonic movement activation and nature of their manifestations within the sea are shown.

Coarse-silt-fraction mineralogy at DSDP Legs 56 and 57 Holes

Soviet sedimentologists use the term "coarse silt" to denote the size fraction 0.1 to 0.05 mm (50-100 µm). Petelin (1961) has shown that this fraction is most diagnostic for terrigeneous and volcanogenic mineral assemblages and provinces in Recent deep-sea sediments, because of its greatest variability of both heavy and light non-opaque minerals, which may be easily identified by the common immersion method. We believe that the fraction is suitable for mineralogical study of unconsolidated and friable sediments from DSDP cores as well, if the objective is to investigate their source area and transporation tracks. In the case of fine-grained oceanic sediments, mineral composition of the coarse silt does not differ markedly from that of the "coarse fraction" (>62 µm).