(Table 2) Chemical composition of skeletons of scleractinian non-zooxanthelate corals

The first data on chemical composition of nonreef-building non-zooxanthellate deep-sea corals presented in this publication allow us to identify following tendencies manifested in the biomineralization process. Comparison of concentration levels of some chemical elements in scleractinian corals and ambient ocean waters suggests that corals do not accumulate K in the process of biomineralization and weakly accumulate Mg, whereas Ca, Sr, Si, Al, Ti, Mn, Zn, Cu, Cd, Pb, and Fe are concentrated in skeletons of corals with enrichment coefficients of 10**3 to 10**7. Correlations between components contained in the skeletons of scleractinian corals suggest that the source of Al, Si, Fe, and Ti in them is the clayey constituent of bottom sediments and zooplankton, while trace elements are likely accumulated via bioassimilation from seawater. Such elements as Mn, Sr, Pb, and Cd can structurally substitute Ca in calcite and aragonite. Variations in concentrations of the elements in coral skeletons depending on their habitat depths are fairly significant. As could be expected Ca and Mg concentrations are prone to decrease with depth (R = -0.55 and -0.51, respectively), which can possibly be caused by partial dissolution of carbonate skeletons with increasing depth, whereas the Sr/Ca ratio does not depend on depth.

(Table 1.4) Ratios of petrogenic components in glassy and crystalline basalts from the north part of the Bougault anomaly, Mid-Atlantic Ridge 15°N

Structure and composition of sub-surface bottom sediments from the southwest Barents Sea have been under study. The study has revealed heterogeneity of sediment structure resulted from temporal irregularity and variability of sedimentation processes. The study of the heavy minerals from 0.1-0.01 mm grain size fraction has shown prevalence of green hornblende, epidote, garnet, and ilmenite in all types of sediments; these minerals are the basis of terrigenous-mineralogical province. At the same time in different areas local terrigenous-mineralogical associations have been identified. Clay mineral composition of in the sediments was quite uniform: biotite, chlorite, hydromica, smectite. Despite this, a number of features indicating initial stages of clay mineral transformation has been identified. Differences in material composition and structure of the studied sediments are associated with rapid change in paleogeographic situation on the land - ice cover melting on the Kola Peninsula and subsequent Holocene climatic situation.

Composition of ferromanganese crusts from the Atlantic, Pacific and Indian Oceans

A collection of layered ferromanganese ores (27 samples) from the Atlantic and Pacific oceans was studied. Trace element and PGE contents were determined layer-by-layer (up to 10 microlayers) in 13 of these samples. The trace, rare earth, and platinum group element distributions, including their layer-to-layer variations, were compared in hydrogenic and hydrothermal crusts from different regions. It was found that the main PGE variations (by a factor of 10-50) are related to their layer-to-layer variations within a given ore field. The distributions of PGE and trace elements are strongly heterogeneous, which is related, first, to different contents of the elements in the layers of different age in ferromanganese crusts (FMC) and, second, to the observed regional heterogeneity and influence of hydrothermal fluids. Geochemical data indicate that CFC formation was mainly caused by the hydrochemical precipitation of material from seawater. This process was accompanied by diagenetic phenomena, water-rock interaction, and influence of volcanic and hydrothermal sources.

Rocks and minerals from the Strakhov Fracture Zone, 4°N Mid-Atlantic Ridge

Geological-geophysical data obtained during Cruises 7, 11, and 12 of R/V Akademic Nikolay Strakhov (1989-1991) within the international project EQUARIDGE in the Strakhov Fracture Zone region (4°N) are presented. The trough of the fracture is interpreted as an open extension joint, a graben produced by stretching along the axis of the Mid-Atlantic Ridge. Bedrock studies showed that typical mid-ocean tholeiitic basalts occur within the narrow (60 nm wide) axial rift zone, whereas igneous rocks not typical for the ocean were found on the eastern and western flank plateaus. This allows to suppose that a reworked relict continental-type basement of pre-Upper Jurassic age possibly exists beneath the flank plateaus, within the segment under discussion. The above data correspond to the hypothesis of E. Bonatti about nonspreading nature of the basement of Mid-Atlantic Ridge within the equatorial segment and the Strakhov Fracture Zone.

Polychaete taxocenes in the Pevek Strait (Chaun Bay) and the Long Strait, Chukci Sea

In spite of similar abiotic conditions in the Long Strait and Chaun Bay, the polychaete taxocenes differ markedly. In some cases biomass, production, and assimilation of polychaetes in the Long Strait are lower, while rate of metabolism is higher than in the Chaun Bay. This may be related to appearance of an intermediate layer in the Long Strait during some years. The latter is characterized by positive temperatures in winter and by low content of oxygen; these conditions are unfavorable for Arctic polychaetes.

Chemical composition of iron-manganese and phosphate rocks from aseismic ridges of the Indian Ocean and from the continental slope of the Southeast Africa

Study of chemical composition of 26 samples collected at depths from 400 to 1400 m on vertex surfaces of the Southeast Indian Ridge, Mascarene Ridge, Madagascar Ridge, and Mozambique Ridge, as well as on the upper part of the Southeast Africa continental slope showed that the samples represent three groups of rocks: 1) low phosphate or phosphate-free ferromanganese rocks, 2) phosphate ferromanganese rocks 3) phosphorites and phosphatized limestones.

Isotopic composition of various forms of sulfur in barite crusts from the Red Sea rift

Barite crusts were formed by an intermittent hydrothermal vent with output temperature from 85 to 465°C. Principal sources of supply of sulfate sulfur are sea water, evaporites, and tholeiitic basalts of the Red Sea rift. Sulfides and sulfates were formed in conditions of isotope disequilibrium with respect to sulfur because rate of precipitation of sulfur compounds from hydrothermal solution was high compared with rate of isotope exchange.