Oxygen isotope and Mg/Ca record of planktonic foraminifera of sediment core MD01-2390

Changes in the local freshwater budget over the last 22,000 years have been estimated from a sediment core located in the southern South China Sea (SCS) using a combined approach of Mg/Ca and oxygen isotopes on the planktonic foraminifera Globigerinoides ruber (white) sensu stricto (s.s.). Core MD01-2390 (06°28,12N, 113°24,56E; water depth 1591 m) is located near the glacial paleo-river mouths of the Baram, Rajang and North Sunda/Molengraaff Rivers that drained the exposed Sunda Shelf. The delta18Oseawater record reveals lower average values (-0.96±0.18 per mil) during the Last Glacial Maximum (LGM) when compared with modern values (-0.54±0.18 per mil). Low salinity during the LGM is interpreted to reflect a higher freshwater contribution due to a greater proximity of the core site to the mouths of the Baram, Rajang and North Sunda/Molengraaff Rivers at that time. A general deglacial increasing trend in salinity due to the progressive landward displacement of the coastline during deglacial shelf flooding is punctuated by several short-term shifts towards higher and lower salinity that are likely related to abrupt changes in the intensity of the East Asian summer monsoon. Thus, the deglacial delta18Oseawater changes reflect the combined effects of sea-level-induced environmental changes on the shelf (e.g. phases of retreat and breakdown of the shelf drainage systems) and East Asian monsoon climate change. Lower salinity than at present during the Early Holocene may be attributed to an increase in summer monsoonal precipitation that is corroborated by previous marine and terrestrial studies that report a Preboreal-Early Holocene monsoon optimum in the Asian monsoon region.

(Table 1) Oxygen and carbon isotope compositions of altered carbonates from DSDP Hole 6-53 from the western Pacific Ocean

In the lower part of DSDP core 53.0, partly recrystallized carbonate sediments and well recrystallized limestone breccias of Oligo-Miocene age are associated with altered volcanic flows, lithified tuffs, and tuff breccias, suggesting that carbonate alteration was the result of thermal metamorphism. However, the oxygen isotope compositions of these carbonates (-3.4 to +0.6 per mil rel. PDB) are not compatible with recrystallization and isotope exchange with sea water at high temperatures. Evaluating the effects of the composition of the water which exchanged with the carbonates and of carbonate-water isotope exchange in closed systems yields the following approximate maximum temperature of recrystallization: limestone breccias, 100°C; calcite veins rimming breccia clasts, 30°C; and unconsolidated sediments overlying the breccias, 20°C. Therefore, the volcanics at site 53.0 must have been emplaced into the primary carbonate sediments at relatively low temperatures. Subsequent carbonate alteration was probably a consequence of chemical changes in ambient pore waters resulting from the submarine weathering of volcanic material.

Artificial oxygen fluxes measured by the eddy correlation method using stirring-sensitive oxygen microsensor and oxygen optodes in a flume experiment

In the last decade, the aquatic eddy correlation (EC) technique has proven to be a powerful approach for non-invasive measurements of oxygen fluxes across the sediment water interface. Fundamental to the EC approach is the correlation of turbulent velocity and oxygen concentration fluctuations measured with high frequencies in the same sampling volume. Oxygen concentrations are commonly measured with fast responding electrochemical microsensors. However, due to their own oxygen consumption, electrochemical microsensors are sensitive to changes of the diffusive boundary layer surrounding the probe and thus to changes in the ambient flow velocity. The so-called stirring sensitivity of microsensors constitutes an inherent correlation of flow velocity and oxygen sensing and thus an artificial flux which can confound the benthic flux determination. To assess the artificial flux we measured the correlation between the turbulent flow velocity and the signal of oxygen microsensors in a sealed annular flume without any oxygen sinks and sources. Experiments revealed significant correlations, even for sensors designed to have low stirring sensitivities of ~0.7%. The artificial fluxes depended on ambient flow conditions and, counter intuitively, increased at higher velocities because of the nonlinear contribution of turbulent velocity fluctuations. The measured artificial fluxes ranged from 2 - 70 mmol m**-2 d**-1 for weak and very strong turbulent flow, respectively. Further, the stirring sensitivity depended on the sensor orientation towards the flow. Optical microsensors (optodes) that should not exhibit a stirring sensitivity were tested in parallel and did not show any significant correlation between O2 signals and turbulent flow. In conclusion, EC data obtained with electrochemical sensors can be affected by artificial flux and we recommend using optical microsensors in future EC-studies. Flume experiments were conducted in February 2013 at the Institute for Environmental Sciences, University of Koblenz-Landau Landau. Experiments were performed in a closed oval-shaped acrylic glass flume with cross-sectional width of 4 cm and height of 10 cm and total length of 54 cm. The fluid flow was induced by a propeller driven by a motor and mean flow velocities of up to 20 cm s-1 were generated by applying voltages between 0 V and 4 V DC. The flume was completely sealed with an acrylic glass cover. Oxygen sensors were inserted through rubber seal fittings and allowed positioning the sensors with inclinations to the main flow direction of ~60°, ~95° and ~135°. A Clark type electrochemical O2 microsensor with a low stirring sensitivity (0.7%) was tested and a fast-responding needle-type O2 optode (PyroScience GmbH, Germany) was used as reference as optodes should not be stirring sensitive. Instantaneous three-dimensional flow velocities were measured at 7.4 Hz using stereoscopic particle image velocimetry (PIV). The velocity at the sensor tip was extracted. The correlation of the fluctuating O2 sensor signals and the fluctuating velocities was quantified with a cross-correlation analysis. A significant cross-correlation is equivalent to a significant artificial flux. For a total of 18 experiments the flow velocity was adjusted between 1.7 and 19.2 cm s**-1, and 3 different orientations of the electrochemical sensor were tested with inclination angles of ~60°, ~95° and ~135° with respect to the main flow direction. In experiments 16-18, wavelike flow was induced, whereas in all other experiments the motor was driven by constant voltages. In 7 experiments, O2 was additionally measured by optodes. Although performed simultaneously with the electrochemical sensor, optode measurements are listed as separate experiments (denoted by the attached 'op' in the filename), because the velocity time series was extracted at the optode tip, located at a different position in the flume.

Isotope oxygen record for ODP sediments from the Exmouth Plateau

A new composite d18O record, generated from calcareous fine-fraction and bulk sediments from the Exmouth Plateau, details long-term Cretaceous climatic change at mid-latitudes in the Southern Hemisphere. Assessment of new and previously published d18O data indicates that a mid-Cretaceous global climatic optimum was achieved sometime between the time of the Cenomanian-Turonian boundary and the middle Turonian, when surface-ocean paleotemperatures were the highest of the past 115 m.y. Periods of cooling and warming that reversed the general patterns were superimposed on long-term Aptian-Turonian warming and Turonian-Maastrichtian cooling trends, respectively. Extrapolation of Southern Hemisphere paleotemperature trends to Maastrichtian paleotemperature data from a low-latitude Pacific guyot implies that maximum mid-Cretaceous low-latitude paleotemperatures could have been in excess of 33°C.